1. Introduction

   • George M. Pharr
   • Yang-Tse Cheng
   • Michael V. Swain

   Indentation Methods in Advanced Materials Research 01 March 2009 Pages: 579 - 580

2. The contributions of David Tabor to the science of indentation hardness

   • Ian M. Hutchings

   Review 01 March 2009 Pages: 581 - 589

3. Relation between the ratio of elastic work to the total work of indentation and the ratio of hardness to Young’s modulus for a perfect conical tip

   • J. Chen
   • S. J. Bull

   Articles 01 March 2009 Pages: 590 - 598

4. Modified method for continuous stiffness measurement

   • Pal Jen Wei
   • Jen Fin Lin

   OriginalPaper 01 March 2009 Pages: 599 - 606

5. Nanoindentation study of slip transfer phenomenon at grain boundaries

   • T. B. Britton
   • D. Randman
   • A. J. Wilkinson

   OriginalPaper 01 March 2009 Pages: 607 - 615

6. Influence of the indenter tip geometry and environment on the indentation modulus of enamel

   • G. M. Guidoni
   • L. H. He
   • M. V. Swain

   OriginalPaper 01 March 2009 Pages: 616 - 625

7. Measuring the constitutive behavior of viscoelastic solids in the time and frequency domain using flat punch nanoindentation

   • E. G. Herbert
   • W. C. Oliver
   • G. M. Pharr

   OriginalPaper 01 March 2009 Pages: 626 - 637

8. Nanoindentation of histological specimens: Mapping the elastic properties of soft tissues

   • R. Akhtar
   • N. Schwarzer
   • B. Derby

   OriginalPaper 01 March 2009 Pages: 638 - 646

9. Where are the geometrically necessary dislocations accommodating small imprints?

   • M. Rester
   • C. Motz
   • R. Pippan

   OriginalPaper 01 March 2009 Pages: 647 - 651

10. Critical issues in making small-depth mechanical property measurements by nanoindentation with continuous stiffness measurement

    • G. M. Pharr
    • J. H. Strader
    • W. C. Oliver

    OriginalPaper 01 March 2009 Pages: 653 - 666

11. Measuring substrate-independent modulus of dielectric films by instrumented indentation

    • Jennifer Hay

    OriginalPaper 01 March 2009 Pages: 667 - 677

12. Nanoindentation analysis as a two-dimensional tool for mapping the mechanical properties of complex surfaces

    • Nicholas X. Randall
    • Matthieu Vandamme
    • Franz-Josef Ulm

    OriginalPaper 01 March 2009 Pages: 679 - 690

13. The dynamic indentation behavior of steel at large depths of penetration

    • G. Sundararajan
    • S. N. Dikshit

    OriginalPaper 01 March 2009 Pages: 691 - 703

14. A quantitative analysis for the stress field around an elastoplastic indentation/contact

    • Gang Feng
    • Shaoxing Qu
    • William D. Nix

    OriginalPaper 01 March 2009 Pages: 704 - 718

15. Nanoindentation of yttria-doped zirconia: Effect of crystallographic structure on deformation mechanisms

    • Y. Gaillard
    • M. Anglada
    • E. Jiménez-Piqué

    OriginalPaper 01 March 2009 Pages: 719 - 727

16. Comparative investigation of strength and plastic instability in Cu/Au and Cu/Cr multilayers by indentation

    • Y. P. Li
    • X. F. Zhu
    • G. P. Zhang

    OriginalPaper 01 March 2009 Pages: 728 - 735

17. Contact area determination in indentation testing of elastomers

    • Julia K. Deuschle
    • H. Matthias Deuschle
    • Eduard Arzt

    OriginalPaper 01 March 2009 Pages: 736 - 748

18. Strain gradient plasticity to study hardness behavior of magnetite (Fe₃O₄) under multicyclic indentation

    • D. Chicot
    • F. Roudet
    • G. Louis

    OriginalPaper 01 March 2009 Pages: 749 - 759

19. Direct mapping of deformation in punch indentation and correlation with slip line fields

    • T. G. Murthy
    • J. Madariaga
    • S. Chandrasekar

    OriginalPaper 01 March 2009 Pages: 760 - 767

20. Localized compression and shear tests on nanotargets with a Berkovich tip and a novel multifunctional tip

    • A. Rinaldi
    • P. Peralta
    • K. Sieradzki

    OriginalPaper 01 March 2009 Pages: 768 - 775

21. The equivalence of axisymmetric indentation model for three-dimensional indentation hardness

    • J. Qin
    • Y. Huang
    • K. C. Hwang

    OriginalPaper 01 March 2009 Pages: 776 - 783

22. Can indentation technique measure unique elastoplastic properties?

    • Ling Liu
    • Nagahisa Ogasawara
    • Xi Chen

    OriginalPaper 01 March 2009 Pages: 784 - 800

23. A simple method for evaluating elastic modulus of thin films by nanoindentation

    • Zhongxin Wei
    • Guoping Zhang
    • Shengmin Guo

    OriginalPaper 01 March 2009 Pages: 801 - 815

24. Predicting macroscopic plastic flow of high-performance, dual-phase steel through spherical nanoindentation on each microphase

    • Byoung-Wook Choi
    • Dong-Han Seo
    • Jaeil Jang

    OriginalPaper 01 March 2009 Pages: 816 - 822

25. Indentation-induced two-way shape memory surfaces

    • Xueling Fei
    • Yijun Zhang
    • Yang-Tse Cheng

    OriginalPaper 01 March 2009 Pages: 823 - 830

26. Substrate-affected indentation contact parameters of elastoplastic coating/substrate composites

    • Mototsugu Sakai

    OriginalPaper 01 March 2009 Pages: 831 - 843

27. Characterization of the mechanical behavior of wear surfaces on single crystal nickel by nanomechanical techniques

    • M. J. Cordill
    • N. R. Moody
    • W. W. Gerberich

    OriginalPaper 01 March 2009 Pages: 844 - 852

28. Response of power-law-viscoelastic and time-dependent materials to rate jumps

    • A. H. W. Ngan
    • B. Tang

    OriginalPaper 01 March 2009 Pages: 853 - 862

29. Storage and loss stiffnesses and moduli as determined by dynamic nanoindentation

    • Wendelin J. Wright
    • W. D. Nix

    OriginalPaper 01 March 2009 Pages: 863 - 871

30. Novel ultra nanoindentation method with extremely low thermal drift: Principle and experimental results

    • J. Nohava
    • N. X. Randall
    • N. Conté

    OriginalPaper 01 March 2009 Pages: 873 - 882

31. A new insight on reversible deformation and incipient plasticity during nanoindentation test in MgO

    • Alex Montagne
    • Christophe Tromas
    • Jacques Woirgard

    OriginalPaper 01 March 2009 Pages: 883 - 889

32. Pressure sensitive flow and constraint factor in amorphous materials below glass transition

    • K. Eswar Prasad
    • V. Keryvin
    • U. Ramamurty

    OriginalPaper 01 March 2009 Pages: 890 - 897

33. Scale effects for strength, ductility, and toughness in “brittle” materials

    • W. W. Gerberich
    • J. Michler
    • R. Ballarini

    OriginalPaper 01 March 2009 Pages: 898 - 906

34. Influence of specimen preparation, microstructure anisotropy, and residual stresses on stress–strain curves of rolled Al2024 T351 as derived from spherical indentation tests

    • J. Heerens
    • F. Mubarok
    • N. Huber

    OriginalPaper 01 March 2009 Pages: 907 - 917

35. Influence of the loading rate on the indentation response of Ti-based metallic glass

    • J. Sort
    • J. Fornell
    • M. D. Baró

    OriginalPaper 01 March 2009 Pages: 918 - 925

36. Indentation strength of a piezoelectric ceramic: Experiments and simulations

    • S. N. Kamble
    • D. V. Kubair
    • U. Ramamurty

    OriginalPaper 01 March 2009 Pages: 926 - 935

37. Determination of plastic properties of metals by instrumented indentation using a stochastic optimization algorithm

    • I. Peyrot
    • P. O. Bouchard
    • J. Michler

    OriginalPaper 01 March 2009 Pages: 936 - 947

38. Molecular dynamics study of crystal plasticity during nanoindentation in Ni nanowires

    • V. Dupont
    • F. Sansoz

    OriginalPaper 01 March 2009 Pages: 948 - 956

39. Indentation fracture of silicone gels

    • Wei-Chun Lin
    • Kathryn J. Otim
    • Kenneth R. Shull

    OriginalPaper 01 March 2009 Pages: 957 - 965

40. Slip distance model for the indentation size effect at the initiation of plasticity in ceramics and metals

    • A. J. Bushby
    • T. T. Zhu
    • D. J. Dunstan

    OriginalPaper 01 March 2009 Pages: 966 - 972

41. Viscoelastic and poroelastic mechanical characterization of hydrated gels

    • Matteo Galli
    • Kerstyn S. C. Comley
    • Michelle L. Oyen

    OriginalPaper 01 March 2009 Pages: 973 - 979

42. Microindentation and nanoindentation of human fingernails at varying relative humidity

    • Laura Farran
    • A. Roland Ennos
    • Stephen J. Eichhorn

    OriginalPaper 01 March 2009 Pages: 980 - 984

43. Measurements of diffusion thickness at polymer interfaces by nanoindentation: A numerically calibrated experimental approach

    • Chunyu Yang
    • Chieh-Tsung Lo
    • Balaji Narasimhan

    OriginalPaper 01 March 2009 Pages: 985 - 992

44. Indentation creep of a Ti-based metallic glass

    • Y. J. Huang
    • Y. L. Chiu
    • J. F. Sun

    OriginalPaper 01 March 2009 Pages: 993 - 997

45. Validity of the reduced modulus concept to describe indentation loading response for elastoplastic materials with sharp indenters

    • In-suk Choi
    • Oliver Kraft
    • Ruth Schwaiger

    OriginalPaper 01 March 2009 Pages: 998 - 1006

46. Numerical investigation of indentation fatigue on polycrystalline copper

    • B. X. Xu
    • Z. F. Yue
    • X. Chen

    OriginalPaper 01 March 2009 Pages: 1007 - 1015

47. Nanoindentation near the edge

    • J. E. Jakes
    • C. R. Frihart
    • D. S. Stone

    OriginalPaper 01 March 2009 Pages: 1016 - 1031

48. Some basic equations for the next generation of surface testers solving the problem of pileup, sink-in, and making area-function calibration obsolete

    • Norbert Schwarzer

    OriginalPaper 01 March 2009 Pages: 1032 - 1036

49. Analysis of the tip roundness effects on the micro- and macroindentation response of elastic-plastic materials

    • Sara Aida Rodríguez Pulecio
    • María Cristina Moré Farias
    • Roberto Martins Souza

    OriginalPaper 01 March 2009 Pages: 1037 - 1044

50. Determination of plastic properties by instrumented spherical indentation: Expanding cavity model and similarity solution approach

    • Peng Jiang
    • Taihua Zhang
    • Naigang Liang

    OriginalPaper 01 March 2009 Pages: 1045 - 1053