1. Particle Hardening in Creep-Resistant Mg-Alloy MRI 230D Probed by Nanoindenting Atomic Force Microscopy

   • Björn Backes
   • Karsten Durst
   • Mathias Göken

   Communication 12 December 2008 Pages: 257 - 261

   

2. Role of Strain-Hardening Law on the Bursting Speed of a Rotating Thin-Walled Shaft

   • U. Güven

   Communication 31 December 2008 Pages: 262 - 263

3. Microstructure and Mechanical Behaviors of 0.1C-13Mn Metastable Austenitic Steel

   • Dong-Woo Suh
   • Seong-Jun Park
   • Sung-Joon Kim

   Communication 17 December 2008 Pages: 264 - 268

   

4. Effect of Ruthenium on Creep Strength of Ni-Base Single-Crystal Superalloys at 750 °C and 750 MPa

   • N. Tsuno
   • K. Kakehi
   • R. Hashizume

   Communication 24 December 2008 Pages: 269 - 272

   

5. On the Role of β Particles in Stress Corrosion Cracking of Mg-Al Alloys

   • N. Winzer
   • C.E. Cross

   Communication 17 December 2008 Pages: 273 - 274

6. Fabrication of Porous Aluminum by Friction Stir Processing

   • Yoshihiko Hangai
   • Takao Utsunomiya

   Communication 17 December 2008 Pages: 275 - 277

   

7. Superplastic Behavior of a High-Strength Al-Zn-Mg-Cu-Zr Alloy

   • A. Kumar
   • A.K. Mukhopadhyay
   • K.S. Prasad

   Communication 17 December 2008 Pages: 278 - 281

   

8. Microstructural Evolution and Mechanical Properties of a Ni-Based Superalloy, TMW-4

   • C.Y. Cui
   • Y.F. Gu
   • H. Harada

   OriginalPaper 06 January 2009 Pages: 282 - 291

   

9. Influence of Sintering under Nitrogen Atmosphere on Microstructures of Powder Metallurgy Duplex Stainless Steels

   • C. García
   • F. Martin
   • M.L. Aparicio

   OriginalPaper 07 January 2009 Pages: 292 - 301

   

10. Nanosized MX Precipitates in Ultra-Low-Carbon Ferritic/Martensitic Heat-Resistant Steels

    • Feng-Shi Yin
    • Woo-Sang Jung

    OriginalPaper 17 December 2008 Pages: 302 - 309

    

11. Scanning Electron Microscopy/Electron Backscatter Diffraction–Based Observations of Martensite Variant Selection and Slip Plane Activity in Supermartensitic Stainless Steels during Plastic Deformation at Elevated, Ambient, and Subzero Temperatures

    • Morten Karlsen
    • Øystein Grong
    • Remi Chiron

    OriginalPaper 07 January 2009 Pages: 310 - 320

    

12. Creep-Fatigue Interactions in a 9 Pct Cr-1 Pct Mo Martensitic Steel: Part I. Mechanical Test Results

    • B. Fournier
    • M. Sauzay
    • A. Pineau

    OriginalPaper 23 December 2008 Pages: 321 - 329

    

13. Creep-Fatigue Interactions in a 9 Pct Cr-1 Pct Mo Martensitic Steel: Part II. Microstructural Evolutions

    • B. Fournier
    • M. Sauzay
    • A. Pineau

    OriginalPaper 12 December 2008 Pages: 330 - 341

    

14. Cyclic Deformation of Advanced High-Strength Steels: Mechanical Behavior and Microstructural Analysis

    • Timothy B. Hilditch
    • Ilana B. Timokhina
    • Peter D. Hodgson

    OriginalPaper 06 January 2009 Pages: 342 - 353

    

15. Finite Element Modeling of Plane Strain Toughness for 7085 Aluminum Alloy

    • M.E. Karabin
    • F. Barlat
    • R.T. Shuey

    OriginalPaper 07 January 2009 Pages: 354 - 364

    

16. Experimental and Analytical Investigations on Plane Strain Toughness for 7085 Aluminum Alloy

    • R.T. Shuey
    • F. Barlat
    • D.J. Chakrabarti

    OriginalPaper 07 January 2009 Pages: 365 - 376

    

17. On the Extension of Processing Time with Increase in Temperature during Transient-Liquid Phase Bonding

    • M.M. Abdelfatah
    • O.A. Ojo

    OriginalPaper 06 January 2009 Pages: 377 - 385

    

18. Type IV Cracking Susceptibility in Weld Joints of Different Grades of Cr-Mo Ferritic Steel

    • K. Laha
    • K.S. Chandravathi
    • K. Bhanu Sankara Rao

    OriginalPaper 20 December 2008 Pages: 386 - 397

    

19. Correlation of Microstructures and Tribological Properties of Ferrous Coatings Deposited by Atmospheric Plasma Spraying on Al-Si Cast Alloy Substrate

    • Aleksandar Vencl
    • Mihailo Mrdak
    • Miloš Banjac

    OriginalPaper 03 December 2008 Pages: 398 - 405

    

20. Fabrication of Lotus-Type Porous Al-Si Alloys Using the Continuous Casting Technique

    • J.S. Park
    • S.K. Hyun
    • H. Nakajima

    OriginalPaper 06 January 2009 Pages: 406 - 414

    

21. Effects of Processing Parameters on the Grain Refinement of Magnesium Alloy by Equal-Channel Angular Extrusion

    • S.X. Ding
    • C.P. Chang
    • P.W. Kao

    OriginalPaper 06 January 2009 Pages: 415 - 425

    

22. Grain Growth in Dilute Tungsten Heavy Alloys during Liquid-Phase Sintering under Microgravity Conditions

    • John L. Johnson
    • Louis G. Campbell
    • Randall M. German

    OriginalPaper 07 January 2009 Pages: 426 - 437

    

23. Fabrication of Lotus-Type Porous Cobalt and Silicon through Decomposition of Moisture

    • H. Onishi
    • S. Ueno
    • H. Nakajima

    OriginalPaper 27 November 2008 Pages: 438 - 443

    

24. Wetting of Polycrystalline α-Al₂O₃ by Molten Zr₅₅Cu₃₀Al₁₀Ni₅ Metallic Glass Alloy

    • Ping Shen
    • Xiao-Hong Zheng
    • Qi-Chuan Jiang

    OriginalPaper 12 December 2008 Pages: 444 - 449

    

25. Formation of Nanocrystalline Matrix Composite during Spray Forming of Al₈₃La₅Y₅Ni₅Co₂

    • V.C. Srivastava
    • K.B. Surreddi
    • H.-W. Zoch

    OriginalPaper 06 January 2009 Pages: 450 - 461

    

26. Thermodynamic Effects of Alloying Elements on Solid-State Interfacial Reactions in a Multicomponent System: Theoretical Treatment and Application in SiC _f /Ti Composites

    • Feng Qin
    • Tongxiang Fan
    • Di Zhang

    OriginalPaper 24 December 2008 Pages: 462 - 471

    

27. Understanding Friction and Wear Mechanisms of High-Purity Titanium against Steel in Liquid Nitrogen Temperature

    • Bikramjit Basu
    • J. Sarkar
    • Ravi Mishra

    OriginalPaper 17 December 2008 Pages: 472 - 480

    

28. The Effect of Degassing on Grain Refinement in Commercial Purity Aluminum

    • P.L. Schaffer
    • A.K. Dahle

    OriginalPaper 06 January 2009 Pages: 481 - 485

    

29. Acoustic Effects on Cyclic-Tension Fatigue of Al-4Cu-1Mg Alloy by Ultrasonic Shear Wave Methods

    • H. Yamagishi
    • M. Fukuhara
    • A. Chiba

    OriginalPaper 07 January 2009 Pages: 486 - 493