Abstract
The fabrication of Step-and-Flash Imprint Lithography (S-FIL) templates with line widths of 50 nm is described in this work. The structures have been patterned using a Ga+ focused ion beam (FIB) in a quartz template. FIB milling is generally accompanied with re-deposition effects, which represent a hindrance to densely patterned nanostructures required in most NIL applications. To reduce these re-deposition effects, in this research, xenon difluoride (XeF2) enhanced FIB etching was applied that also increases the material removal rates in comparison to pure kinetic ion sputtering. To optimise the process when using XeF2 gas the following ion scanning parameters have been examined: ion dose, beam current, dwell time and beam overlap (step size). It has been found that the assisting gases at very low doses do not bring significant etching enhancements whilst the sputtering rates have increased at high doses. Using the XeF2 gas-assisted etching, FIB structuring has been used to fabricate <100 nm structures onto quartz S-FIL templates. The presence of XeF2 considerably enhances the etching rate of quartz without any significant negative effects on the spatial resolution of the FIB lithographic process and reduces the template processing time.
Similar content being viewed by others
References
S.Y. Chou, P.R. Krauss, P.J. Renstrom, Imprint of sub-25 nm vias and trenches in polymers. Appl. Phys. Lett. 67, 3114 (1995)
T. Bailey, B.J. Choi, M. Colburn, M. Meissl, S. Shaya, J.G. Ekerdt, S.V. Sreenivasan, C.G. Willson, Step and flash imprint lithography: template surface treatment and defect analysis. J. Vac. Sci. Technol. B 18, 3572 (2000)
T.C. Bailey, S.C. Johnson, S.V. Sreenivasan, J.G. Ekerdt, C.G. Willson, D.J. Resnick, Step and Flash Imprint Lithography: an efficient nanoscale printing technology. J. Photopolym. Sci. Technol. 15(3), 481–486 (2002)
M.D. Austin, W. Zhang, H. Ge, D. Wasserman, S.A. Lyon, S.Y. Chou, 6 nm half-pitch lines and 0.04 μm2 static random access memory patterns by nanoimprint lithography. Nanotechnology 16, 1058–1061 (2005)
B. Wu, A. Kumar, Extreme ultraviolet lithography: a review. J. Vac. Sci. Technol. B 25, 1743 (2007)
L.J. Guo, Recent progress in nanoimprint technology and its applications. J. Phys. D: Appl. Phys. 37, R123–R141 (2004)
D.J. Resnick, W.J. Dauksher, D. Mancini, K.J. Nordquist, E. Ainley, K. Gehoski, J.H. Baker, T.C. Bailey, B.J. Choi, S. Johnson, S.V. Sreenivasan, J.G. Ekerdt, C.G. Willson, High resolution templates for step and flash imprint lithography. J. Microlithogr. Microfab., Microsyst. 1, 284 (2002)
J. Kettle, R.T. Hoyle, R.M. Perks, S. Dimov, Overcoming material challenges for replication of “motheye lenses” using step and flash imprint lithography for optoelectronic applications. J. Vac. Sci. Technol. B 26, 1794 (2008)
A. Lugstein, B. Basnar, J. Smoliner, E. Bertagnolli, FIB processing of silicon in the nanoscale regime. Appl. Phys. A: Mater. Sci. Process. 76, 545–548 (2003)
M.-K. Lee, K.-K. Kuo, Gas-assisted focused ion beam etching of indium–tin oxide film. Jpn. J. Appl. Phys. 47, 347–350 (2008)
L.R. Harriott, Focused-ion-beam-induced gas etching. Jpn. J. Appl. Phys. 33, 7094 (1994)
I. Chyr, A.J. Steckl, GaN focused ion beam micromachining with gas-assisted etching. J. Vac. Sci. Technol. B 19(6), 2457–2460 (2001)
T. Dai, X. Kang, B. Zhang, J. Xu, K. Bao, C. Xiong, Z. Gan, Study and formation of 2D microstrcutures of sapphire by FIB milling. Microelectron. Eng. 85, 640–645 (2008)
J. Kettle, R.T. Hoyle, S. Dimov, R.M. Perks, Fabrication of complex 3D structures using Step-and-Flash Imprint Lithography (S-FIL). Microelectron. Eng. 85(5–6), 853–855 (2007) 2008
W. Li, S. Dimov, G. Lalev, Focused-ion-beam direct structuring of fused silica for fabrication of nano-imprinting templates. Microelectron. Eng. 84(5–8), 829–832 (2007)
H. Nakamura, H. Komano, M. Ogasawara, Focused ion beam assisted etching of quartz in XeF2 without transmittance reduction for phase shifting mask repair. Jpn. J. Appl. Phys. 31, 4465 (1992)
A. Rota, S.F. Contri, G.C. Gazzadi, S. Cottafava, E. Gualtieri, S. Valeri, Focused ion beam induced swelling in MgO(0 0 1). Surf. Sci. 600(18), 3718–3722 (2006)
Y.Q. Fu, N.K.A. Bryan, O.N. Shing, Investigation of submicron linewidth direct deposition for high-density IC chip modification by focused ion beam. Int. J. Adv. Manuf. Technol. 17(11), 835–839 (2001)
M.-K. Lee, K.-K. Kuo, Gas-Assisted Etching of sapphire using Focused Ion Beam. Jpn. J. Appl. Phys. 45(4A), 2447–2450 (2006)
D.J. Resnick, S.V. Sreenivasan, C. Grant Willson, Step and flash imprint lithography. Mater. Today 8(2), 34–42 (2005)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kettle, J., Hoyle, R.T. & Dimov, S. Fabrication of Step-and-Flash Imprint Lithography (S-FIL) templates using XeF2 enhanced focused ion-beam etching. Appl. Phys. A 96, 819–825 (2009). https://doi.org/10.1007/s00339-009-5319-7
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00339-009-5319-7