1. Development of Design of Electrodehydrator for Dewatering Water-Oil Emulsions by Numerical Methods Using Salome Software

   • K. V. Tarantsev
   • A. V. Korosteleva
   • I. A. Proshin

   RESEARCH, DESIGN, CALCULATIONS, AND OPERATING EXPERIENCE 10 October 2015 Pages: 293 - 298

   

2. Study of Hydraulic Characteristics of Modular Heat and Mass Exchange Packed Contact Device

   • A. V. Stepykin
   • A. A. Sidyagin

   OriginalPaper 12 October 2015 Pages: 299 - 303

   

3. Automated Determination of Nanocoating Cracking and Fragmentation Sites

   • I. V. Konovalenko
   • P. O. Marushchak
   • I. M. Danilyuk

   OriginalPaper 12 October 2015 Pages: 304 - 307

   

4. Development of a Combined Stirrer for Mixing Viscous Fluids

   • V. K. Leont’ev
   • O. N. Korableva

   OriginalPaper 10 October 2015 Pages: 308 - 310

   

5. Classification and Separation of Granules in Vortex Granulators

   • A. E. Artyukhov
   • A. S. Fursa
   • K. V. Moskalenko

   OriginalPaper 12 October 2015 Pages: 311 - 318

   

6. Plasma Hardening of a Steel 30KhGSA Surfacing Layer

   • V. A. Korotkov

   OriginalPaper 10 October 2015 Pages: 319 - 323

   

7. Stabilization of the Temperature of the Working Medium in the Equipment of Chemical Plants (Survey of Patents)

   • I. O. Mikulionok

   OriginalPaper 10 October 2015 Pages: 324 - 327

   

8. Improvement of Compressor Seal Assembly Elements. Part 1

   • V. B. Tarel’nik
   • V. S. Martsinkovskii
   • V. I. Yurko

   OriginalPaper 12 October 2015 Pages: 328 - 333

   

9. An Experimental Investigation of a Piston Compressor Pump with Gas Damper

   • A. K. Kuzhbanov
   • E. A. Pavlyuchenko
   • V. E. Shcherba

   OriginalPaper 12 October 2015 Pages: 334 - 341

   

10. Factors Influencing Leakage of Medium in a Slotted Shaft Seal. Part 2. Effect of Shaft Rotation

    • V. A. Mel’nik

    OriginalPaper 12 October 2015 Pages: 342 - 347

    

11. Calculation of the Parameters of an Oil Trap Based on the Method of Balance of Powers

    • E. A. Maksimov
    • V. I. Vasilev
    • A. A. Ostsemin

    INDUSTRIAL ECOLOGY 12 October 2015 Pages: 348 - 355

    

12. Oil Sorbent from Polyethylene-Terephthalate Wastes

    • E. A. Tatarintseva
    • A. V. Karpenko
    • Yu. N. Nagar

    OriginalPaper 12 October 2015 Pages: 356 - 360

    

13. Influence of a Constant Magnetic Field and Ultraviolet Radiation on Growth of Higher Plants and Phytoremediation of Soil from Oil Products

    • L. N. Olshanskaya
    • O. V. Titorenko
    • Yu. A. Eremeeva

    OriginalPaper 12 October 2015 Pages: 361 - 365

    

14. Nonpolluting Technologies for Polymer Welding

    • V. G. Sister
    • E. M. Ivannikova
    • A. F. Bobrikhin

    MANUFACTURING TECHNOLOGY 10 October 2015 Pages: 366 - 369

    

15. Experimental Study of Aerodynamic Resistance of Staggered Equilateral Banks of Tubes with Spiral Aluminum Fins

    • V. B. Kuntysh
    • V. V. Dudarev
    • A. B Sukhotskii

    RESEARCH, DESIGN, CALCULATIONS, AND OPERATING EXPERIENCE 12 October 2015 Pages: 373 - 378

    

16. Ecologically Clean Technological Treatment of Materials Using Superhigh Frequency Technique

    • V. G. Sister
    • E. M. Ivannikova
    • A. G. Gudkov

    OriginalPaper 12 October 2015 Pages: 379 - 382

    

17. Assessment of Change in Torque of Stream-Bubble Contact Mass Transfer Devices

    • I. N. Madyshev
    • O. S. Dmitrieva
    • A. N. Nikolaev

    OriginalPaper 12 October 2015 Pages: 383 - 387

    

18. Estimating the Efficiency of the Heating Plates of Presses Used in the Fabrication of Rubber-Mechanical Products

    • S. V. Karpushkin
    • S. V. Karpov
    • A. O. Glebov

    OriginalPaper 14 October 2015 Pages: 388 - 395

    

19. Hydrogen Permeability of Palladium Membranes Made of Alloy V-1 in Laboratory Investigations and Membrane Devices

    • A. B. Vandyshev
    • V. A. Kulikov

    OriginalPaper 12 October 2015 Pages: 396 - 401

    

20. Improvement of Compressor Seal Assembly Elements. Part 2

    • V. B. Tarel’nik
    • V. S. Martsinkovskii
    • V. I. Yurko

    OriginalPaper 12 October 2015 Pages: 402 - 407

    

21. A Generalized Thermodynamic Approach to the Calculation of Processes of Suction and Discharge in Positive-Displacement Pumps and Compressors

    • V. E. Shcherba
    • V. V. Shalai
    • E. A. Pavlyuchenko

    OriginalPaper 12 October 2015 Pages: 408 - 413

    

22. Determining the Limit Plastic Load in T-Joints of Pipelines Subjected to Compound Combined Loading

    • V. N. Skopinskii
    • N. A. Berkov
    • R. A. Vozhov

    OriginalPaper 12 October 2015 Pages: 414 - 419

    

23. A Technique of Selecting the Optimal Values of the Parameters of the Hydraulic Monitoring Holes of Drilling Bits

    • V. A. Bruyaka

    OriginalPaper 12 October 2015 Pages: 420 - 425

    

24. Comprehensive Assessment of Wastewater Quality in the Production of Cephalothin Sodium Salt

    • K. R. Tarantseva
    • O. V. Firsova

    INDUSTRIAL ECOLOGY 12 October 2015 Pages: 426 - 432

    

25. Study of the Effect of Strain Ageing on Corrosion Failure and Submicrostructure of Low-Carbon Steels for Gas-Distribution Pipelines

    • O. Yu. Elagina
    • L. A. Efimenko
    • I. V. Volkov

    MATERIALS SCIENCE AND CORROSION PROTECTION 12 October 2015 Pages: 433 - 437

    

26. Compositions for Corrosion Protection of Chemical, Petrochemical, and Oil-and-Gas Equipment and Pipelines

    • R. N. Zagidullin
    • S. N. Zagidullin
    • A. T. Gil’mutdinov

    OriginalPaper 12 October 2015 Pages: 438 - 442