Results of studies of the weldability, properties, and structure of welded joints of lithium-alloyed aluminum alloys obtained by argon arc welding and friction welding with mixing (FWM) are described. The effect of the welding parameters on the structure and properties of the welds is studied.
Similar content being viewed by others
References
A. M. Drits, V. V. Ovchinnikov, and T. V. Krymova, “Experience of the use of aluminum-lithium alloys 1460,” Svar. Proizvod., No. 12, 12 – 20 (1997).
V. V. Ovchinnikov and R. V. Egorov, “Porosity of welds due to electron-beam welding of lithium-alloyed aluminum alloys,” Vestnik IGOU, Issue 4, 92 – 96 (2006).
I. N. Shiganov, S. V. Shakhov, L. V. Tarasenko, and A. I. Plokhikh, “Effect of the rate of laser welding on the structure and properties of aluminum alloys with lithium and scandium additives,” Tekhnol. Mashinostr., No. 10, 23 – 28 (2005).
A. M. Drits and V. V. Ovchinnikov, “Friction welding of aluminum alloys with mixing,” Tsvetn. Met., No. 2, 66 – 70 (2005).
A. Ya. Ishchenko, S. V. Pod’elnikov, and A. G. Poklyatskii, “Friction welding of aluminum alloys with mixing (a review),” Avtomat. Svarka, No. 11, 32 – 38 (2007).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 9, pp. 45 – 49, September, 2011.
Rights and permissions
About this article
Cite this article
Drits, A.M., Ovchinnikov, V.V. Weldability and properties of welds of high-strength aluminum alloys of the Al – Cu – Li system. Met Sci Heat Treat 53, 445–449 (2012). https://doi.org/10.1007/s11041-012-9413-7
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11041-012-9413-7