1. Palladium seeded GaAs nanowires

   • Robert T. Hallberg
   • Sebastian Lehmann
   • Kimberly A. Dick

   Invited Feature Paper 01 January 2016 Pages: 175 - 185

   

2. Low temperature photoluminescence spectroscopy studies on sputter deposited CdS/CdTe junctions and solar cells

   • Mohit Tuteja
   • Prakash Koirala
   • Angus Rockett

   Article 01 January 2016 Pages: 186 - 194

   

3. Enhanced photoluminescence property of co-doped ZnB₂O₄: Eu³⁺, Tb³⁺ phosphor prepared by a thermal conversion method

   • Yu-Yan Liang
   • Li-Jun Qiao
   • Zhi-Hong Liu

   Article 01 January 2016 Pages: 195 - 201

   

4. Ab initio investigation of the substitution effects of 2 p elements on the electronic structure of γ-Fe₄X (X = B, C, N, and O) in the ground state

   • Antônio Vanderlei dos Santos
   • Carlos Ariel Samudio Pérez

   Article 01 January 2016 Pages: 202 - 212

   

5. Effect of a transverse magnetic field on solidification structure in directionally solidified Al-40 wt% Cu alloys

   • Hanxiao Li
   • Dafan Du
   • Xi Li

   Article 01 January 2016 Pages: 213 - 221

   

6. In situ observations of the rapid solidification for undercooled Al₃₀Si₇₀ alloy melt

   • Junfeng Xu
   • Long Diao
   • Zengyun Jian

   Article 01 January 2016 Pages: 222 - 231

   

7. Mechanical and tribological properties of AlCuFe quasicrystal and Al(Si)CuFe approximant thin films

   • Simon Olsson
   • Esteban Broitman
   • Fredrik Eriksson

   Article 01 January 2016 Pages: 232 - 240

   

8. The stabilities and electronic structures of Al_nSi_12-nN₁₂ (n = 0, 1, 2, and 4)

   • Huihui Yang
   • Hongshan Chen

   Article 01 January 2016 Pages: 241 - 249

   

9. Effect of Mn addition on microstructure and mechanical properties of cast Al-2Li-2Cu-0.8Mg-0.4Zn-0.2Zr alloy

   • Antao Chen
   • Liang Zhang
   • Yanlei Li

   Article 01 January 2016 Pages: 250 - 258

   

10. Measurement of local mechanical properties using multiple indentations by a special conical indenter and error analysis

    • Shigeru Hamada
    • Shogo Kashiwa
    • Hiroshi Noguchi

    Article 01 January 2016 Pages: 259 - 273

    

11. Microstructure characteristics of spray-formed high speed steel and its evolution during subsequent hot deformation

    • Lin Lu
    • Long-gang Hou
    • Ji-Shan Zhang

    Article 01 January 2016 Pages: 274 - 280

    

12. Direct metal laser sintering synthesis of carbon nanotube reinforced Ti matrix composites: Densification, distribution characteristics and properties

    • Kun Chang
    • Dongdong Gu

    Article 01 January 2016 Pages: 281 - 291

    

13. Role of stress in the high cycle fatigue behavior of advanced 9Cr/CrMoV dissimilarly welded joint

    • Chendong Shao
    • Fenggui Lu
    • Yuming Ding

    Article 01 January 2016 Pages: 292 - 301

    

14. Fabrication of large alumina foams by pyrolysis of thermo-foamed alumina-sucrose

    • Sujith Vijayan
    • Rajaram Narasimman
    • Kuttan Prabhakaran

    Article 01 January 2016 Pages: 302 - 309