Abstract
Al-7 wt% Ni alloy was directionally solidified upwards with different growth rates, V (8.3–489.5 μm/s) at constant temperature gradient, G (4.2 K/mm) using a Bridgman-type growth apparatus. The dependence of the dendritic microstructures such as primary dendrite arm spacing (λ 1) and secondary dendrite arm spacing (λ 2) on the growth rate were determined using a linear regression analysis. The present experimental results were also compared with similar previous experimental results. Measurements of microhardness (HV) and electrical resistivity (ρ) of the directionally solidified samples were carried out. The dependence of the microhardness and electrical resistivity on the growth rate (V) was also analyzed. According to these results, it has been found that, for increasing values of V, the values of HV and ρ increase. However, the values of HV and ρ decrease with increasing values of λ 1 and λ 2.
Similar content being viewed by others
References
E. J. Lavernia and N. J. Grant, J. Mater. Sci. 22, 1521 (1987).
F. Yang, L. Peng, and K. Okazaki, Metall. Mater. Trans. A 35, 3323 (2004).
W. R. Osório, L. C. Peixoto, M. V. Canté, and A. Garcia, Mater. Des. 31, 4485 (2010).
H. Kaya, E. Çadırlı, M. Gündüz, and A. Ülgen, J. Mater. Eng. Perf. 12, 544 (2003).
H. Kaya, E. Çadırlı, U. Böyük, and N. Maraşlı, App. Surf. Sci. 255, 3071 (2008).
R. Trivedi and W. Kurz, Int. Mater. Rev. 39, 49 (1994).
M. Şahin, E. Çadırlı, and H. Kaya, Surf. Rev. Lett. 17, 477 (2010).
E. Çadırlı and H. Kaya, Surf. Rev. Lett. 14, 1169 (2007).
H. Kaya, E. Çadırlı, and M. Gündüz, J. Mater. Eng. Perform. 16, 12 (2007).
H. Kaya, E. Çadırlı, M. Gündüz, and O. Uzun, J. Mater. Sci. 39, 6571 (2004).
M. S. Bhat, D. R. Poirier, and J. C. Heinrich, Metall. Trans. B 26, 1049 (1995).
F. M. Smits, AT&T Tech J. 37, 711 (1958).
P. E. Gise and R. Blanchard, Semiconductor and Integrated Circuit Fabrication Techniques, Reston Pub. Co., Reston, VA (1979).
J. H. Lee, H. C. Kim, C. Y. Jo, S. K. Kim, J. H. Shin, S. Liu and R. Trivedi, Mater. Sci. Eng. A 413–414, 306 (2005).
W. Xu, Y. P. Feng, Y. Li, G. D. Zang, and Z. Y. Li, Acta Mater. 50, 183 (2002).
A. V. Gorbunov, Acta Metall. 40, 513 (1992).
H. Kaya, E. Çadırlı, U. Böyük, and N. Maraşlı, App. Surf. Sci. 255, 3071 (2008).
E. Çadırlı, H. Kaya, and M. Gündüz, Surf. Rev. Lett. 16, 191 (2009).
H. Kaya, U. Böyük, S. Engin, E. Çadırlı, and N. Maraşlı, J. Elect. Mater. 39, 303 (2010).
S. Khan, A. Ourdjini, Q. S. Hamed, M. A. A. Najafabadi, and R. Elliott, J. Mater. Sci. 28, 5957 (1993).
H. Kaya, U. Böyük, E. Çadırlı, and N. Marašlı, Mater. Des. 34, 707 (2012).
A. Sergeev and V. Mitin, Phys. Rev. B 61, 6041 (2000).
Z. Boekelheide, D. W. Cooke, E. Helgren, and F. Hellman, Phys. Rev. B 80, 134426 (2009).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kaya, H., Böyük, U., Çadırlı, E. et al. Influence of growth rate on microstructure, microhardness, and electrical resistivity of directionally solidified Al-7 wt% Ni hypo-eutectic alloy. Met. Mater. Int. 19, 39–44 (2013). https://doi.org/10.1007/s12540-013-1007-4
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12540-013-1007-4