Skip to main content
Log in

Influence of mass on the speed of wheelchair racing

  • Original Article
  • Published:
Sports Engineering Aims and scope Submit manuscript

Abstract

Reducing the mass of a racing wheelchair improves the winning time even for relatively small mass reductions over short distances (100 m). In this study, the improvement of speed and winning time on mass reduction was modelled mathematically, the speed profiles of 100 m wheelchair races as well as the rolling resistance and drag area of the athlete–wheelchair system was determined experimentally, and the improvement of the winning time through mass reduction was calculated from the mathematical model and experimental data. For winning times of 30 s, the relative improvement of the winning time is at least equal to the relative reduction of mass. For winning times of 15 s, the relative improvement of the winning time is at least half the relative reduction of mass. A reduction by 1 kg results in an overall improvement of the winning time of about 1–2.3% for winning times of 15–30 s (100-m race). In absolute terms, a mass saving of 1 and 5 kg on a 60-kg system would reduce a 15-s winning time for the 100 m by 0.132 and 0.66 s, respectively, and a 30-s winning time by 0.63 and 2.86 s, respectively. The mass of a wheelchair is the most important parameter for improving the winning time. The influence of the mass on the winning time is 4 or 1.5 times greater than the influence of the rolling friction coefficient, and 4 or 5.5 times greater than the influence of the drag area in a 15 or 30-s race, respectively. These principles should be considered when designing a racing wheelchair.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12

Similar content being viewed by others

References

  1. IWAS (2008) IWAS Athletics, world wide ranking. http://athletics.iwasf.com/. Accessed 14 Aug 2009

  2. IPC International Paralympic Committee (2007) IPC athletics classification manual for physical impairments 2008–2010. http://www.paralympic.org/release/Summer_Sports/Athletics/News/2007_12_07_ClassificationManual.pdf. Accessed 14 Aug 2009

  3. IPC International Paralympic Committee (2008a). IPC athletics world championship records. http://www.paralympic.org/release/Summer_Sports/Athletics/Records/2008_01_ChampionshipRecords.pdf. Accessed 14 Aug 2009

  4. IPC International Paralympic Committee (2008b). IPC athletics world records. http://www.paralympic.org/opencms/release/Summer_Sports/Athletics/Records/2009_06_12__World_Records.pdf. Accessed 14 Aug 2009

  5. IPC International Paralympic Committee (2008c). Paralympic records (to be ratified). http://www.paralympic.org/release/Summer_Sports/Athletics/Records/2008_09_16_Beijing_Records_Paralympic_Website.pdf. Accessed 14 Aug 2009

  6. IPC International Paralympic Committee (2008d). World records (to be ratified). http://www.paralympic.org/release/Summer_Sports/Athletics/Records/2008_09_16_Beijing_Records_World_Website.pdf. Accessed 14 Aug 2009

  7. Petrushov VA (1998) Improvement in vehicle aerodynamic drag and rolling resistance determination from coast-down tests. Proc Inst Mech Eng D J Automobile Eng 212:369–380

    Article  Google Scholar 

  8. Whitt FR, Wilson DG (1982) Bicycling science, 2nd edn. The MIT Press, Cambridge

    Google Scholar 

  9. Di Prampero PE, Cortili G, Mognoni P, Saibene F (1979) Equation of motion of a cyclist. J Appl Physiol 47:201–206

    Google Scholar 

  10. Davies CT (1980) Effect of air resistance on the metabolic cost and performance of cycling. Eur J Appl Physiol Occup Physiol 45:245–254

    Article  Google Scholar 

  11. Candau RB, Grappe F, Ménard M, Barbier B, Rouillon JD (1996) Accuracy of deceleration method for aerodynamic and rolling resistance measurements in cycling. In: The 1996 International Pre-Olympic Scientific Congress, 10–14 July 1996, Dallas, Texas (International Council of Sport Science and Physical Education), abstract book, pp 123

  12. Grappe F, Candau R, Belli A, Rouillon JD (1997) Aerodynamic drag in field cycling with special reference to the Obree’s position. Ergonomics 40:1299–1311

    Article  Google Scholar 

  13. Grappe F, Candau R, Barbier B, Hoffman MD, Belli A, Rouillon J-D (1999) Influence of tyre pressure and vertical load on coefficient of rolling resistance and simulated cycling performance. Ergonomics 10:1361–1371

    Google Scholar 

  14. Candau RB, Grappe F, Ménard M, Barbier B, Millet GY, Hoffman MD, Belli AR, Rouillon JD (1999) Simplified deceleration method for assessment of resistive forces in cycling. Med Sci Sports Exerc 31:1441–1447

    Article  Google Scholar 

  15. Hoffman MD, Millet GY, Hoch AZ, Candau RB (2003) Assessment of wheelchair drag resistance using a coasting deceleration technique. Am J Phys Med Rehabil 82:880–889

    Article  Google Scholar 

  16. van der Woude LH, Geurts C, Winkelman H, Veeger H (2003) Measurement of wheelchair rolling resistance with a handle bar push technique. J Med Eng Technol 27:249–258

    Article  Google Scholar 

  17. Kyle CR, Crawford C, Nadeau D (1973) Factors affecting the speed of a bicycle. Engineering report no. 73–1, California State University, Long Beach, 2 November

  18. Kyle CR, Burke E (1984) Improving the racing bicycle. Mech Eng 106:34–45

    Google Scholar 

  19. Pöschel T, Schwager T, Brilliantov NV (1999) Rolling friction of a hard cylinder on a viscous plane. Eur Phys J B10:169–174

    Google Scholar 

  20. Xu Y, Yung KL (2003) The effect of inertial normal force on the rolling friction of a soft sphere on a hard plane. Europhys Lett 61:620–624

    Article  Google Scholar 

  21. Yung KL, Xu Y (2003) Non-linear expressions for rolling friction of a soft ball on a hard plane. Nonlin Dyn 33:33–41

    Article  MATH  Google Scholar 

  22. Hur N, Ahn I, Patrushov VA (1997) Method for measuring vehicle motion resistances using short distance coast-down test based on the distance–time data. US Patent Office, US5686651, filed 06-02-1996, published 11-11-1997

  23. UCI (2008) UCI cycling regulations, 2008, Part 1 General Organisation of Cycling as a Sport, Chapter III Equipment, Sect. 2: bicycles, §2––Technical Specifications, pp 60. http://www.uci.ch/Modules/BUILTIN/getObject.asp?MenuId=MTkzNg&ObjTypeCode=FILE&type=FILE&id=34033&. Accessed 14 Aug 2009

  24. IPC International Paralympic Committee (2008e). IPC Athletics, official rules for athletics 2008–2009. http://www.paralympic.org/release/Summer_Sports/Athletics/Rules/2008_05_IPC_Athletics_Rules_And_Regulations_Website.pdf. Accessed 14 Aug 2009

  25. Moss AD, Fowler NE, Tolfrey VL (2003) A telemetry-based velocometer to measure wheelchair velocity. J Biomech 36:253–257

    Article  Google Scholar 

  26. Sunrise Medical (2008) SOPUR X-Limit. http://www.sunrisemedical.de/products/product_detail.jsp?PRODUCT%3C%3Eprd_id=845524445443343&FOLDER%3C%3Efolder_id=1408474395337707&ASSORTMENT%3C%3East_id=1408474395284289&bmUID=1215487325918&bmLocale=de#Technische%20Daten. Accessed 14 Aug 2009

  27. Sun Components (2008) Products. http://www.suncomponents.com/products.htm. Accessed 14 Aug 2009

  28. Panaracer (2008) Wheelchair. http://www.panaracer.com/eng/products/index_wh.html. Accessed 14 Aug 2009

  29. Corima (2008) Wheelchair wheels. http://www.corima.com/gb/produits/handi/default.cfm. Accessed 14 Aug 2009

  30. Coutts KD (1994) Drag and sprint performance of wheelchair basketball players. J Rehabil Res Dev 31:138–143

    Google Scholar 

  31. Lucas GG, Emtage AL (1987) A new look at the analysis of coast-down test results. Proc Inst Mech Eng D J Automobile Eng 201:91–97

    Article  Google Scholar 

  32. Leino MAH, Spring E, Suominen H (1983) Methods for the simultaneous determination of air resistance to a skier and the coefficient of friction of his skis on the snow. Wear 86:101–104

    Article  Google Scholar 

  33. Delft University of Technology (2008) Custom ride. Delft Outlook 25/3:5. http://www.tudelft.nl/live/ServeBinary?id=20ded2f9-a1f5-4b49-a069-45f3e5aabce6&binary=/doc/DO-08-3-1InBrief.pdf. Accessed 14 Aug 2009

  34. Siebert M (2008) Design and construction of custom-made lightweight carbon fibre wheelchair. In: Estivalet M, Brisson B (eds) The engineering of sport 7. Springer, Paris, pp 19–26

    Google Scholar 

  35. Gross AC, Kyle CR, Malewicki DJ (1983) The aerodynamics of human-powered land vehicles. Sci Am 249:142–152

    Article  Google Scholar 

  36. Hennekam W (1990) The speed of a cyclist. Phys Educ 25:141–146

    Article  Google Scholar 

  37. Kyle CR, Edelman WE (1975) Man-powered vehicle design criteria. In: Proceedings of the Third international conference on vehicle system dynamics. Swets & Zeitlinger, Amsterdam, pp 20–30

  38. Bassett DR, Kyle CR, Passfield L, Broker JP, Burke ER (1999) Comparing cycling world hour records, 1967–1996: modeling with empirical data. Med Sci Sports Exerc 31:1665–1676

    Article  Google Scholar 

  39. Wong KG (2008) Will expensive technology and funding limit the growth and development of disability sports in ASEAN? Sports Technol 1:85

    Article  Google Scholar 

Download references

Acknowledgments

The author thanks the three athletes, their trainers, Ms Joan Ow, the Disability Classification and Research Centre and the Singapore Disability Sports Council, who participated or assisted in, or gave their consent to, this study.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Franz Konstantin Fuss.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Fuss, F.K. Influence of mass on the speed of wheelchair racing. Sports Eng 12, 41–53 (2009). https://doi.org/10.1007/s12283-009-0027-2

Download citation

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s12283-009-0027-2

Keywords

Navigation