Abstract
The design of composite controllable mills with superhard cutters for high-speed machining is considered. Static and dynamic balancing of the mill design is described.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Grechishnikov, V.A., Grigor’ev, S.N., Kirsanov, S.V., et al., Metallorezhushchii instrument: Uchebnik (Metal-Cutting Tools: A Handbook), Moscow: ITs MGTU Stankin, Izd. Yanus-K, 2005.
Chulin, I.V., Complex mills for machining surfaces with linear generatrices, Russ. Eng. Res., 2012, vol. 32, no. 3, pp. 288–290.
Isaev, A.V., Design of composite mills with round replaceable polyhedral plates distributed over a helical surface, Vestn. MGTU Stankin, 2011, no. 1, pp. 61–66.
Volosova, M.A. and Grigor’ev, S.N., Ceramic cutting plates: Influence of abrasive machining and coatings on their performance, Vestn. MGTU Stankin, 2011, no. 2(14), pp. 68–74.
Russian patent 88594.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © V.A. Grechishnikov, I.V. Chulin, A.I. Isakov, 2014, published in STIN, 2014, No. 10, pp. 17–19.
About this article
Cite this article
Grechishnikov, V.A., Chulin, I.V. & Isakov, A.I. Design of controllable end mills with superhard cutters for high-speed machining. Russ. Engin. Res. 35, 292–294 (2015). https://doi.org/10.3103/S1068798X15040127
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X15040127