Abstract
Results of research and development of three velocimeter components in the form of an assemblage of mechanical seismic detector and boards of electronics, realizing stabilization of inertial mass zero point and formation of amplitude-frequency characteristic, are presented. Original electromagnetic system of mass suspension for the vertical variant is applied in the seismic detector; it gives a possibility of mass reduction to the variant of horizontal seismic detector without change of the general design. The suspension system consists of two cylindrical magnets and a ferromagnetic shunt. On the basis of the developed seismic detectors, design of the multifunctional seismic assemblage SEP-1 is realized allowing its application for solution of a wide variety of seismologic problems at measurements both in base variant and in wellholes.
Similar content being viewed by others
References
Belonosov, A.I. and Chistyakov, V.A., Report on Results of Tests of the Seismic Assemblage SK-2, in Otchet OOO “Mirovye tekhnologii” (Report of LLC “Mirovye Tekhnologii”), 2000.
Belonosov, A.I., Pravdin, N.M., Khaikinson, Ya.M., and Chistyakov, V.A., Compact Wellhole-Base Assemblage SK-2 for Measurement of Seismic Disturbances, in Sbornik nauchnykh trudov AO NPK “Rossiiskie tekhnologii” (Collection of Scientific Papers of AO NPK Rossiiskie Tekhnologii), 1996.
Rykov, A.V., Modelirovanie seismometra (Simulation of Seismic Detector), Moscow: IFZ RAN, 1996.
Additional information
Original Russian Text © A.I. Belonosov, A.V. Rykov, 2008, published in Seismicheskie Pribory, 2008, pp. 41–48.
About this article
Cite this article
Belonosov, A.I., Rykov, A.V. Multifunctional broad-band seismic assemblage SEP-1. Seism. Instr. 44, 26–31 (2008). https://doi.org/10.3103/S0747923908010039
Published:
Issue Date:
DOI: https://doi.org/10.3103/S0747923908010039