Abstract
Pyrolysis of a wood chips mixture and main wood compounds such as hemicellulose, cellulose and lignin was investigated by thermogravimetry. The investigation was carried out in inert nitrogen atmosphere with temperatures ranging from 20°C to 900°C for four heating rates: 2 K min−1, 5 K min−1, 10 K min−1, and 15 K min−1. Hemicellulose, cellulose, and lignin were used as the main compounds of biomass. TGA and DTG temperature dependencies were evaluated. Decomposition processes proceed in three main stages: water evaporation, and active and passive pyrolysis. The decomposition of hemicellulose and cellulose takes place in the temperature range of 200–380°C and 250–380°C, while lignin decomposition seems to be ranging from 180°C up to 900°C. The isoconversional method was used to determine kinetic parameters such as activation energy and pre-exponential factor mainly in the stage of active pyrolysis and partially in the passive stage. It was found that, at the end of the decomposition process, the value of activation energy decreases. Reaction order does not have a significant influence on the process because of the high value of the pre-exponential factor. Obtained kinetic parameters were used to calculate simulated decompositions at different heating rates. Experimental data compared with the simulation ones were in good accordance at all heating rates. From the pyrolysis of hemicellulose, cellulose, and lignin it is clear that the decomposition process of wood is dependent on the composition and concentration of the main compounds.
Similar content being viewed by others
References
Biagini, E., Fantei, A., & Tognotti, L. (2008). Effect of the heating rate on the devolatilization of biomass residues. Thermochimica Acta, 472, 55–63. DOI: 10.1016/j.tca.2008.03.015.
Brown, M. E. (2001). Introduction to thermal analysis: Techniques and applications (2nd ed.). Dordrecht, The Netherlands: Kluwer Academic Publishers.
Choudhury, D., Borah, R., Goswamee, R., Sharmah, H., & Rao, P. (2007). Non-isothermal thermogravimetric pyrolysis kinetics of waste petroleum refinery sludge by isoconversional approach. Journal of Thermal Analysis and Calorimetry, 89, 965–970. DOI: 10.1007/s10973-007-8322-2.
Couhert, C., Commandre, J.-M., & Salvador, S. (2009a). Is it possible to predict gas yields of any biomass after rapid pyrolysis at high temperature from its composition in cellulose, hemicellulose and lignin? Fuel, 88, 408–417. DOI: 10.1016/j.fuel.2008.09.019.
Couhert, C., Commandré, J.-M., & Salvador, S. (2009b). Failure of the component additivity rule to predict gas yields of biomass in flash pyrolysis at 950°C. Biomass and Bioenergy, 33, 316–326. DOI: 10.1016/j.biombioe.2008.07.003.
Di Blasi, C. (2008). Modeling chemical and physical processes of wood and biomass pyrolysis. Progress in Energy and Combustion Science, 34, 47–90. DOI: 10.1016/j.pecs.2006.12.001.
Dinwoodie, J. M. (2000). Timber: Its nature and behaviour (2nd ed.). London, UK: Taylor & Francis.
Grønli, M. G., Várhegyi, G., & Di Blasi, C. (2002). Thermogravimetric analysis and devolatilization kinetics of wood. Industrial & Engineering Chemistry Research, 41, 4201–4208. DOI: 10.1021/ie0201157.
Kastanaki, E., Vamvuka, D., Grammelis, P., & Kakaras, E. (2002). Thermogravimetric studies of the behavior of lignite-biomass blends during devolatilization. Fuel Processing Technology, 77–78, 159–166. DOI: 10.1016/S0378-3820(02)00049-8.
Koreňová, Z. (2008). Optimization of thermal decomposition conditions of waste tires. Doctoral dissertation. Slovak University of Technology, Bratislava, Slovakia.
Kumar, A., Wang, L., Dzenis, Y. A., Jones, D. D., & Hanna, M. A. (2008). Thermogravimetric characterization of corn stover as gasification and pyrolysis feedstock. Biomass and Bioenergy, 32, 460–467. DOI: 10.1016/j.biombioe.2007.11.004.
Lv, P., Wu, C., Ma, L., & Yuan, Z. (2008). A study on the economic efficiency of hydrogen production from biomass residues in China. Renewable Energy, 33, 1874–1879. DOI: 10.1016/j.renene.2007.11.002.
McKendry, P. (2002). Energy production from biomass (part 1): overview of biomass. Bioresource Technology, 83, 37–46. DOI: 10.1016/S0960-8524(01)00118-3.
Mohan, D., Pittman, C. U., Jr., & Steele, P. H. (2006). Pyrolysis of wood/biomass for bio-oil: A critical review. Energy & Fuels, 20, 848–889. DOI: 10.1021/ef0502397.
Munir, S., Daood, S. S., Nimmo, W., Cunliffe, A. M., & Gibbs, B. M. (2009). Thermal analysis and devolatilization kinetics of cotton stalk, sugar cane bagasse and shea meal under nitrogen and air atmospheres. Bioresource Technology, 100, 1413–1418. DOI: 10.1016/j.biortech.2008.07.065.
Orfão, J. J. M., Antunes, F. J. A., & Figueiredo, J. L. (1999). Pyrolysis kinetics of lignocellulosic materials-three independent reactions model. Fuel, 78, 349–358. DOI: 10.1016/S0016-2361(98)00156-2.
Park, Y.-H., Kim, J., Kim, S.-S., & Park, Y.-K. (2009). Pyrolysis characteristics and kinetics of oak trees using thermogravimetric analyzer and micro-tubing reactor. Bioresource Technology, 100, 400–405. DOI: 10.1016/j.biortech.2008.06.040.
Šimon, P. (2004). Isoconversional methods: Fundamentals, meaning and application. Journal of Thermal Analysis and Calorimetry, 76, 123–132. DOI: 10.1023/B:JTAN.0000027811.80036.6c.
Stenseng, M., Jensen, A., & Dam-Johansen, K. (2001). Investigation of biomass pyrolysis by thermogravimetric analysis and differential scanning calorimetry. Journal of Analytical and Applied Pyrolysis, 58–59, 765–780. DOI: 10.1016/S0165-2370(00)00200-X.
Yang, H., Yan, R., Chen, H., Lee, D. H., & Zheng, C. (2007). Characteristics of hemicellulose, cellulose and lignin pyrolysis. Fuel, 86, 1781–1788. DOI: 10.1016/j.fuel.2006.12.013.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Gašparovič, L., Koreňová, Z. & Jelemenský, Ľ. Kinetic study of wood chips decomposition by TGA. Chem. Pap. 64, 174–181 (2010). https://doi.org/10.2478/s11696-009-0109-4
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.2478/s11696-009-0109-4