Abstract
Transition liquid-phase insert metal bonding of Al2O3 and AISI 304 stainless steel based materials is investigated. This joining technique allows the continuous replenishment of the active solute which is consumed by the chemical reaction that occurs at the ceramic/filler metal interface. Replenishment is facilitated by employing a sandwich of filler materials comprising tin-based filler metal and amorphous Cu50Ti50 or NiCrB interlayers. During Al2O3/AISI 304 stainless steel bonding, the highest shear strength properties are produced using a bonding temperature of 500 °C. Thick reaction layers containing defects form at the ceramic/filler material interface when higher bonding temperatures are applied. Bonding at temperatures above 500 °C also increases the tensile residual stress generated at the periphery of Al2O3/AISI 304 stainless steel joints. The shear strength of joints produced using NiCrB interlayers markedly increased following heat treatment at 200 °C for 1.5 h. Heat treatment had little influence on the shear strength of the joint produced using Cu50Ti50 interlayers.
Similar content being viewed by others
References
Y. C. KIM, K. SAIDA, Y. ZHOU and T. H. NORTH,Trans. Jpn Weld. Res. Inst. 22 (1993) 121.
Y. ZHOU, K. IKEUCHI, T. H. NORTH and Z. WANG,Metall. Trans. 22A (1991) 2822.
J. P. HAMMOND, S. A. DAVID and M. L. SANTELLA,Weld. J. 67 (1988) 228s.
R. R. KAPOOR and T. W. EAGAR,Metall. Trans. 20B (1989) 919.
Y. NAKAO, K. NISHIMOTO and K. SAIDA,Trans. Jpn Weld. Soc. 20 (1989) 66.
TAYLOR LYMAN “Metals Handbook”, 8th Edn, Vol. 8 (American Society for Metals, Metals Park, OH, 1973) 300.
H. NAKAGAWA, C. H. LEE and T. H. NORTH,Metall. Trans. 22A (1991) 543.
Y. ZHOU, W. F. GALE and T. H. NORTH,Int. Mater. Rev. 40 (1996) 181.
H. HONGQI, J. ZHIHAO and W. XIAOTIAN,J. Mater. Sci. 29 (1994) 5041
T. TORVUND, O. M. AKESELSEN, J. H. ULVENSOEN and O. GRONG,ibid., submitted.
M. G. NICHOLAS, “Joining of Ceramics” (Chapman and Hall, London, 1990) p. 89.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
ZHAI, Y., NORTH, T.H. & REN, J. Transient liquid-phase insert metal bonding of Al2O3 and AISI 304 stainless steel. Journal of Materials Science 32, 1399–1404 (1997). https://doi.org/10.1023/A:1018581312445
Published:
Issue Date:
DOI: https://doi.org/10.1023/A:1018581312445