Skip to main content
Log in

Impedance measurements on lacquered tinplate: fitting with equivalent circuits

  • Published:
Journal of Applied Electrochemistry Aims and scope Submit manuscript

Abstract

Experimental impedance data previously obtained for various kinds of lacquered tinplate are fitted using two different equivalent electrical circuits, with the aim of assessing the advantages/disadvantages of this procedure for quality control of the material as compared to direct evaluation of the impedance diagrams. It is shown that for screening purposes the same conclusions can be obtained either by fitting or by qualitative analysis of the diagrams. The physical meaning of parameters obtained from the impedance measurements is also discussed. The results are interpreted on the basis that the lacquer is characterized by intact and porous areas which are associated with a capacitance in parallel with the pore resistance in the high frequency range. At lower frequencies other processes occur in series with the resistance of the pores. For short immersion times, the passivation film present on tinplate is detected, whereas for longer immersion times, faradaic processes are detected.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. A. Montanari, G. Milanese, A. Cassara and R. Massini, Fourth International Tinplate Conference, USA (1988), paper 23.

  2. P. Junges, L. Billen, M. L. Guyon and P. Seurin, Second North American Tinplate Conference, USA (1990), paper 12.

  3. S. N. Popova, B. N. Popov, R. E. White and D. Drazic, Corrosion 46(12) (1990) 1007.

    Google Scholar 

  4. J. Hollaender, E. Ludwig and S. Hillebrand, Fifth International Tinplate Conference, England (1992), paper 25.

  5. R. D. Armstrong, J. D. Wright and T. M. Handyside, J. Appl. Electrochem. 22 (1992) 795.

    Google Scholar 

  6. M. Ichiba, H. Iwasa and T. Watanabe, Fifth International Tinplate Conference, England (1992), paper 24.

  7. G. G. do Nascimento, J. L. C. dos Santos, I. C. P. Margarit and O. R. Mattos, Electrochim. Acta 41(7/8) (1996) 1099.

    Google Scholar 

  8. L. Beaunier, I. Epelboin, J. C. Lestrade and H. Takenouti, Surf. Technol. 4 (1976) 237.

    Google Scholar 

  9. F. Mansfeld, M. W. Kendig and S. Tsai, Corrosion, 38(9) (1982) 478.

    Google Scholar 

  10. B. A. Boukamp, 'Equivalent Circuit, Manual AC-Immitance Data Analysis System' (Twente University of Technology, The Netherlands, 1989).

    Google Scholar 

  11. C. Gabrielli, M. Keddam, O. R. Mattos and H. Takenouti, J. Electroanal. Chem. 117 (1981) 147.

    Google Scholar 

  12. I. C. P. Margarit, O. R. Mattos, T. M. C. Nogueira and W. Rosas, Tenth International Congress on Metallic Corrosion, Vol. 1, India (1987), p. 813.

    Google Scholar 

  13. P. Agarwal, M. E. Orazem and L. H. Garcia-Rubio, J. Elec-trochem. Soc. 139 (1992) 1917.

    Google Scholar 

  14. P. Agarwal, M. E. Orazem and L. H. Garcia-Rubio, American Society for Testing and Materials edited by J. Scully, D. Silverman and M. Kendig (1993), p. 115

  15. J. R. Macdonald (Ed.), 'Impedance Spectroscopy Emphasizing Solid Materials and Systems' (Wiley-Intersci-ence, New York, 1987).

    Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Nascimento, G.G.d., Mattos, O.R., Santos, J.L.C.d. et al. Impedance measurements on lacquered tinplate: fitting with equivalent circuits. Journal of Applied Electrochemistry 29, 383–392 (1999). https://doi.org/10.1023/A:1003470415180

Download citation

  • Issue Date:

  • DOI: https://doi.org/10.1023/A:1003470415180

Navigation