Abstract
Sintered Hydroxyapatite (HA) has been used as bone graft for years. Nevertheless, its slow resorbability is the main drawbacks. This study aims to evaluate the effect of temperature on phase transformation and mechanical property of non-sintered HA obtained from gypsum block under hydrothermal and its solubility compared to commercially available sintered HA. HA block was fabricated from gypsum block in Na3PO4.12H2O solution at 100 °C, 140 °C, and 180 °C for 24 h under hydrothermal. It was found that pure HA block could be obtained at 180 °C. The diametral tensile strength (DTS) of the obtained HA block decreased considerably compared to set gypsum block. The obtained HA has higher solubility in acetate buffer compared to commercial sintered HA, which predicts its higher osteoclastic resorption. In Tris–HCl buffer, the obtained HA has lower solubility compared to the commercial sintered HA. In conclusion, non-sintered HA block could be obtained via hydrothermal at 180 °C for 24 h. The DTS values of the obtained blocks decreased with the increase of hydrothermal temperature. The current non-sintered HA block showed better solubility in acetate buffer compared to sintered HA, which simulated its resorbability in osteoclastic environment.
Similar content being viewed by others
References
J.K. Odusote, Y. Danyuo, A.D. Baruwa, A.A. Azeez, Synthesis and characterization of hydroxyapatite from bovine bone for production of dental implants. J. Appl. Biomate. Functio. Mater (2019). https://doi.org/10.1177/2280800019836829
D.S. Gomes, A.M.C. Santos, G.A. Neves, R.R. Menezes, A brief review on hydroxyapatite production and use in biomedicine. Ceramica (2019). https://doi.org/10.1590/0366-69132019653742706
A. Szcześ, L. Hołysz, E. Chibowski, Synthesis of hydroxyapatite for biomedical applications. Adv. Coll. Interf. Sci (2017). https://doi.org/10.1016/j.cis.2017.04.007
V.P. Orlovskii, V.S. Komlev, S.M. Barinov, Hydroxyapatite and hydroxyapatite-based ceramics. Inorganic Mater (2002). https://doi.org/10.1023/A:1020585800572
K. Ishikawa, Y. Miyamoto, A. Tsuchiya, K. Hayashi, K. Tsuru, G. Ohe, Physical and histological comparison of hydroxyapatite carbonate apatite, and β-tricalcium phosphate bone substitutes. Materials (2018). https://doi.org/10.3390/ma11101993
O. Prokopiev, I. Sevostianov, Dependence of the mechanical properties of sintered hydroxyapatite on the sintering temperature. Mater. Sci. Eng. A (2006). https://doi.org/10.1016/j.msea.2006.05.158
K. Ishikawa, Bone substitute fabrication based on dissolution-precipitation reactions. Materials (2010). https://doi.org/10.3390/ma3021138
K. Ishikawa, Carbonate apatite bone replacement: learn from the bone. J. Ceram. Soc. Japan (2019). https://doi.org/10.2109/jcersj2.19042
M.U. Hassan, M. Akmal, H.J. Ryu, Cold sintering of as-dried nanostructured calcium hydroxyapatite without using additives. J. Mater. Res. Technol (2021). https://doi.org/10.1016/j.jmrt.2021.01.060
H. Guo, A. Baker, J. Guo, C.A. Randall, Cold Sintering Process: a novel technique for low-temperature ceramic processing of ferroelectrics. J. Am. Ceram. Soc. (2016). https://doi.org/10.1111/jace.14554
M. Figueiredo, J. Henriques, G. Martins, F. Guerra, F. Judas, H. Figueiredo, Physicochemical characterization of biomaterials commonly used in dentistry as bone substitutes - comparison with human bone. J. Biomed. Mater. Res (2010). https://doi.org/10.1002/jbm.b.31529
J.T.B. Ratnayake, M.L. Gould, A. Shavandi, M. Mucalo, G.J. Dias, Development and characterization of a xenograft material from New Zealand sourced bovine cancellous bone. J. Biomedi. Mater. Res - Part B Appl. Biomater. (2017). https://doi.org/10.1002/jbm.b.33644
B. Brković, M. Radulović, V. Danilović, Preimplant preparation of the extraction alveolus with the deproteinized bovine bone and calcium-sulphate Vojnosanitetski Pregled Military-Medical and Pharmaceutical Review. . (2006). https://doi.org/10.2298/VSP0602181B
N. Ahmad, K. Tsuru, M.L. Munar, S. Matsuya, K. Ishikawa, Effect of Precursor Solubility on the Mechanical Strength of HAP Block, in: 2012. https://doi.org/10.1002/9781118217504.ch1.
R. Lowmunkong, T. Sohmura, J. Takahashi, Y. Suzuki, S. Matsuya, K. Ishikawa, Transformation of 3DP gypsum model to HA by treating in ammonium phosphate solution. J. Biomed. Mater. Res - Part B Appl. Biomater. (2007). https://doi.org/10.1002/jbm.b.30609
Y. Suzuki, S. Matsuya, K.I. Udoh, M. Nakagawa, Y. Tsukiyama, K. Koyano, K. Ishikawa, Fabrication of hydroxyapatite block from gypsum block based on (NH 4)2HPO4 treatment. Dent. Mater. J. (2005). https://doi.org/10.4012/dmj.24.515
Y. Sugiura, K. Ishikawa, Fabrication of pure octacalcium phosphate blocks from dicalcium hydrogen phosphate dihydrate blocks via a dissolution–precipitation reaction in a basic solution. Mater. Lett (2019). https://doi.org/10.1016/j.matlet.2018.12.093
Y. Sugiura, K. Ishikawa, Effect of calcium and phosphate on compositional conversion from dicalcium hydrogen phosphate dihydrate blocks to octacalcium phosphate blocks. Curr. Comput.-Aided Drug Des. (2018). https://doi.org/10.3390/cryst8050222
K. Tsuru, A. Yoshimoto, M. Kanazawa, Y. Sugiura, Y. Nakashima, K. Ishikawa, Fabrication of carbonate apatite block through a dissolution-precipitation reaction using calcium hydrogen phosphate dihydrate block as a precursor. Materials (2017). https://doi.org/10.3390/ma10040374
S. Nomura, K. Tsuru, A. Valanezhad, S. Matsuya, I. Takahashi, K. Ishikawa, Fabrication of carbonate apatite block from calcium sulfate by hydrothermal treatment. Key. Eng. Mater. (2012). https://doi.org/10.4028/www.scientific.net/KEM.493-494.139
I.D. Ana, S. Matsuya, K. Ishikawa, Engineering of carbonate apatite bone substitute based on composition-transformation of gypsum and calcium hydroxide. Engineering (2010). https://doi.org/10.4236/eng.2010.25045
G. Kawachi, H. Misumi, H. Fujimori, S. Goto, C. Ohtsuki, M. Kamitakahara, K. Ioku, Fabrication of porous blocks of calcium phosphate through hydrothermal processing under glycine coexistence. J. Ceram. Soc. Jpn. 118, 559–563 (2010). https://doi.org/10.2109/jcersj2.118.559
Y. Ayukawa, Y. Suzuki, K. Tsuru, K. Koyano, K. Ishikawa, Histological comparison in rats between carbonate apatite fabricated from gypsum and sintered hydroxyapatite on bone remodeling. BioMed. Res. Int (2015). https://doi.org/10.1155/2015/579541
E. Landi, A. Tampieri, G. Celotti, S. Sprio, Densification behaviour and mechanisms of synthetic hydroxyapatites. J Eur. Ceram. Soc (2000). https://doi.org/10.1016/S0955-2219(00)00154-0
J.D.B. Featherstone, S. Pearson, R.Z. LeGeros, An infrared method for quantification of carbonate in carbonated apatites1. Caries. Res (1984). https://doi.org/10.1159/000260749
T. Matsumoto, M. Okazaki, M. Inoue, Y. Hamada, M. Taira, J. Takahashi, Crystallinity and solubility characteristics of hydroxyapatite adsorbed amino acid. Biomaterials (2002). https://doi.org/10.1016/S0142-9612(01)00358-1
M. König, J. Vaes, E. Klemm, D. Pant, Solvents and supporting electrolytes in the electrocatalytic reduction of CO2. IScience (2019). https://doi.org/10.1016/j.isci.2019.07.014
L.H. Thang, L.T. Bang, B.D. Long, N.A. Son, S. Ramesh, Effect of carbonate contents on the thermal stability and mechanical properties of carbonated apatite artificial bone substitute. J. Mater. Eng. Perform. (2022). https://doi.org/10.1007/s11665-022-07169-6
M. Maruta, T. Arahira, K. Tsuru, S. Matsuya, Characterization and thermal decomposition of synthetic carbonate apatite powders prepared using different alkali metal salts. Dent. Mater. J (2019). https://doi.org/10.4012/dmj.2018-213
J.C. Elliott, P.E. Mackie, R.A. Young, Monoclinic hydroxyapatite. Science (1973). https://doi.org/10.1126/science.180.4090.1055
S. Ebrahimi, C.S.S. Mohd Nasri, S.E. Bin Arshad, Hydrothermal synthesis of hydroxyapatite powders using response surface methodology (RSM). PLoS ONE (2021). https://doi.org/10.1371/journal.pone.0251009
S. Nomura, K. Tsuru, M. Maruta, S. Matsuya, I. Takahashi, K. Ishikawa, Fabrication of carbonate apatite blocks from set gypsum based on dissolutionprecipitation reaction in phosphate-carbonate mixed solution. Dent Mater J (2014). https://doi.org/10.4012/dmj.2013-192
Acknowledgements
This study was funded by Hibah PUTI Q3 2020 Universitas Indonesia (Contract No. BA-939/UN2.RST/PPM.00.03.01/2021).
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
All authors declare that they have no conflict of interest.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations
Rights and permissions
Springer Nature or its licensor holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Sunarso, Rino, Qalbina, T. et al. Effect of hydrothermal temperature on phase transformation and mechanical property of non-sintered hydroxyapatite and its in vitro solubility. J. Korean Ceram. Soc. 60, 215–223 (2023). https://doi.org/10.1007/s43207-022-00257-2
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s43207-022-00257-2