Abstract
Reverse electrowetting-on-dielectric (REWOD) is a novel energy harvesting technique that has been gaining considerable amount of attention owing to its high power output even with the small amount of disturbance. To enhance the output power of REWOD, the dielectric layers in the system require a high capacitance. Nevertheless, current leakage is inevitable in such high-k dielectric materials. In this work, the application of a high-k dielectric material TiO2 has been investigated along with a new leakage barrier layer Al2O3 that acts as a lamination, in order to minimize the current leakage and maximize the power output. As expected, the laminated structure with TiO2 and Al2O3 exhibited reduced current leakage and relatively high capacitance compared to the single layer of TiO2 or Al2O3, respectively. As the electrical energy is generated through the interaction of liquid droplets and the multilayered dielectric film, the energy-harvesting performance displayed different behavior about current generation with respect to the top surface material that is in contact with the conductive droplet. Overall, the laminated REWOD energy harvesting system produced an enhanced power density of 15.36 mW cm−2 at a low bias voltage.
Similar content being viewed by others
REFERENCES
Priya, S., & Inman, D. J. (2009). Energy harvesting technologies. New york: Springer.
Kim, H. S., Kim, J.-H., & Kim, J. (2011). A review of piezoelectric energy harvesting based on vibration. International Journal of Precision Engineering and Manufacturing, 12, 1129–1141.
Park, J.-H., Lim, T.-W., Kim, S.-D., & Park, S.-H. (2016). Design and experimental verification of flexible plate-type piezoelectric vibrator for energy harvesting system. International Journal of Precision Engineering and Manufacturing-Green Technology, 3, 253–259.
Kim, J. E., Kim, H., Yoon, H., Kim, Y. Y., & Youn, B. D. (2015). An energy conversion model for cantilevered piezoelectric vibration energy harvesters using only measurable parameters. International Journal of Precision Engineering and Manufacturing-Green Technology, 2, 51–57.
Usharani, R., Uma, G., & Umapathy, M. (2016). Design of high output broadband piezoelectric energy harvester with double tapered cavity beam. International Journal of Precision Engineering and Manufacturing-Green Technology, 3, 343–351.
Wang, Z. L., & Wu, W. (2012). Nanotechnology-enabled energy harvesting for self-powered micro-/nanosystems. Angewandte Chemie International Edition, 51, 11700–11721.
Zorzi, M., Gluhak, A., Lange, S., & Bassi, A. (2010). From today’s intranet of things to a future internet of things: a wireless- and mobility-related view. IEEE Wireless Communicatins, 17(6), 44–51.
Hu, R., Cola, B. A., Haram, N., Barisci, J. N., Lee, S., Stoughton, S., et al. (2010). Harvesting waste thermal energy using a carbon-nanotube-based thermo-electrochemical cell. Nano Letters, 10, 838–846.
Zhu, G., Su, Y., Bai, P., Chen, J., Jing, Q., Yang, W., et al. (2014). Harvesting water wave energy by asymmetric screening of electrostatic charges on a nanostructured hydrophobic thin-film surface. ACS Nano, 8, 6031–6037.
Naruse, Y., Matsubara, N., Mabuchi, K., Izumi, M., & Suzuki, S. (2009). Electrostatic micro power generation from low-frequency vibration such as human motion. Journal of Micromechanics and Microengineering, 19, 094002.
Zorlu, Ö., Tropal, E. T., & Kulah, H. (2011). A vibration-based electromagnetic energy harvester using mechanical frequency up-conversion method. IEEE Sensors Journal, 11, 481–488.
Wang, S., Lin, L., & Wang, Z. L. (2012). Nanoscale triboelectric-effect-enabled energy conversion for sustainably powering portable electronics. Nano Letters, 12, 6339–6346.
Moon, J. K., Jeong, J., Lee, D., & Pak, H. K. (2013). Electrical power generation by mechanically modulating electrical double layers. Nature Communications, 4, 1487.
Kwon, S.-H., Park, J., Kim, W. K., Yang, Y., Lee, E., Han, C. J., et al. (2014). An effective energy harvesting method from a natural water motion active transducer. Energy & Environmental Science, 7, 3279–3283.
Kim, S., Choi, S. J., Zhao, K., Yang, H., Gobbi, G., Zhang, S., et al. (2016). Electrochemically driven mechanical energy harvesting. Nature Communications, 7, 10146.
Kim, S. H., Haines, C. S., Li, N., Kim, K. J., Mun, T. J., Choi, C., et al. (2017). Harvesting electrical energy from carbon nanotube yarn twist. Science, 357, 773–778.
Krupenkin, T., & Taylor, J. A. (2011). Reverse electrowetting as a new approach to high-power energy harvesting. Nature Communications, 2, 448.
Hsu, T. H., Manakasettham, S., Taylor, J. A., & Krupendin, T. (2015). Bubbler: a novel ultra-high power density energy harvesting method based on reverse electrowetting. Scientific Reports, 5, 16537.
Yang, H., Hong, S., Koo, B., Lee, D., & Kim, Y.-B. (2017). High-performance reverse electrowetting energy harvesting using atomic-layer-deposited dielectric film. Nano Energy, 31, 450–455.
An, J., Usui, T., Logar, M., Park, J., Thian, D., Kim, S., et al. (2014). Plasma processing for crystallization and densification of atomic layer deposition BaTiO3 thin films. ACS Applied Materials & Interfaces, 6, 10656–10660.
Aarik, J., Aidla, A., Kiisler, A.-A., Uustare, T., & Sammelselg, V. (1997). Effect of crystal structure on optical properties of TiO2 films grown by atomic layer deposition. Thin Solid Films, 305, 270–273.
Kadosima, M., Hiratani, M., Shimamoto, Y., Torii, K., Miki, H., Kiruma, S., et al. (2003). Rutile-type TiO2 thin film for high-k gate insulator. Thin Solid Films, 424, 224–228.
Usui, T., Mollinger, S. A., Iancu, A. T., Reis, T. N., & Prinz, F. B. (2012). High aspect ratio and high breakdown strength metal-oxide capacitors. Applied Physics Letters, 101, 033905.
Di Paola, A., Bellardita, M., & Palmisano, L. (2013). Brookite, the least known TiO2 photocatalyst. Catalysts, 3, 36–73.
Palomares, E., Clifford, J. N., Haque, S. A., Lutz, T., & Durrant, J. R. (2003). Control of charge recombination dynamics in dye sensitized solar cells by the use of conformally deposited metal oxide blocking layers. Journal of the American Chemical Society, 125, 475–482.
Tzeng, S.-D., & Gwo, S. (2016). Charge trapping properties at silicon nitride/silicon oxide interface studied by variable-temperature electrostatic force microscopy. Journal of Applied Physics, 100, 023711.
Basset, P., Galayko, D., Mahmood Paracha, A., Marty, F., Dudka, A., & Bourouina, T. (2009). A batch-fabricated an electret-free silicon electrostatic vibration energy harvester. Journal of Micromechanics and Microengineering, 19, 115025.
Huynh, D. H., Nguyen, T. C., Nguyen, P. D., Abeyrathne, C. D., Hossain, Md S, Evans, R., et al. (2016). Environmentally friendly power generator based on moving liquid dielectric and double layer effect. Scientific Reports, 6, 26708.
Acknowledgements
This research was supported by Basic Science Research Program through the National Research Foundation of Korea(NRF) funded by the Ministry of Education(2012R1A6A1029029).
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Yang, H., Lee, H., Lim, Y. et al. Laminated Structure of Al2O3 and TiO2 for Enhancing Performance of Reverse Electrowetting-On-Dielectric Energy Harvesting. Int. J. of Precis. Eng. and Manuf.-Green Tech. 8, 103–111 (2021). https://doi.org/10.1007/s40684-019-00145-x
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40684-019-00145-x