Abstract
Fracture toughness, thermal conductivity and corrosion resistance are essential for prolonging the life of thermal barrier coatings. In this paper, the thermophysical properties, mechanical properties and corrosion resistance of ZrO2-Y2O3-Ta2O5 ceramic composites prepared by the solid-state reaction method were analyzed. According to the findings, (Zr0.544Y0.114Ta0.114Er0.114Ti0.114)O had the best mechanical properties and corrosion resistance, with a fracture toughness of 4.29 MPa·m1/2. The thermal conductivity of (Zr0.544Y0.114Ta0.114Er0.114Ti0.114)O was the lowest, at 0.98 W/mK. (Zr0.544Y0.114Ta0.114A0.114B0.114)O ceramic material has extensive practical value.
Similar content being viewed by others
References
Y. Chen, R. Zhang, G. Zhang, P. Jiang, J. Song, and X. Chu, Toughening Mechanism of Thermal Barrier Coatings, Int. J. Thermophys., 2021, 42(5), p 42–69.
A.G. Evans, D.R. Clarke, and C.G. Levi, The Influence of Oxides on the Performance of Advanced Gas Turbines, J. Eur. Ceram. Soc., 2008, 28(7), p 1405–1419.
R. Darolia, Thermal Barrier Coatings Technology: Critical Review, Progress Update, Remaining Challenges and Prospects, Int. Mater. Rev., 2013, 58(6), p 315–348.
D.R. Clarke and S.R. Phillpot, Thermal Barrier Coating Materials, Mater. Today, 2005, 8(6), p 22–29.
P.G. Lashmi, P.V. Ananthapadmanabhan, G. Unnikrishnan, and S.T. Aruna, Present Status and Future Prospects of Plasma Sprayed Multilayered Thermal Barrier Coating Systems, J. Eur. Ceram. Soc., 2020, 40(8), p 2731–2745.
J.G. Thakare, C. Pandey, M.M. Mahapatra, and R.S. Mulik, Thermal Barrier Coatings—A State of the Art Review, Met. Mater. Int., 2020, 27(7), p 1947–1968.
H.L. Tsai and P.C. Tsai, Performance of Laser-Glazed Plasma-Sprayed (Zro2-12wt.% Y203) (Ni-22w.t%Cr-10w.t% A1-1 Wt.% Y) Thermal Barrier Coatings in Cyclic Oxidation Tests, Surf. Coat. Technol., 1995, 71, p 53–59.
J. Yu, H. Zhao, S. Tao, X. Zhou, and C. Ding, Thermal Conductivity of Plasma Sprayed Sm2Zr2O7 Coatings, J. Eur. Ceram. Soc., 2010, 30(3), p 799–804.
H. Fang, W. Wang, J. Huang, and D. Ye, Corrosion Resistance and Thermal-Mechanical Properties of Ceramic Pellets to Molten Calcium–Magnesium–Alumina–Silicate (CMAS), Ceram. Int., 2019, 45(16), p 19710–19719.
H. Zhang, J. Yuan, W. Song, X. Zhou, S. Dong, S. Duo, J. Wang, X. Yang, J. Jiang, L. Deng, J. Huang, and X. Cao, Composition, Mechanical Properties and Thermal Cycling Performance of YSZ Toughened La2Ce2O7 Composite Thermal Barrier Coatings, Ceram. Int., 2020, 46(5), p 6641–6651.
R.S. Rejith, J.K. Thomas, and S. Solomon, Structural, Optical and Impedance Spectroscopic Characterizations of RE2Zr2O7 (RE = La, Y) Ceramics, Solid State Ionics, 2018, 323, p 112–122.
Y. Chen, R. Zhang, S. Hu, P. Jiang, J. Sun, B. Zhang, and Y. Zhang, Effect of Porosity on Thermal Conductivity of Five-Element Ceramic System Materials, J. Aeronaut. Mater., 2023, 43(2), p 66–74.
Y. Chen, R. Zhang, S. Hu, P. Jiang, J. Sun, and X. Huang, Corrosion Resistance and Thermal Shock Resistance of Sc Ta0.5−xYSZ at High Temperatures, Ceram. Int., 2021, 47(23), p 33309–33314.
W. Zhao, F. Yang, Z. Liu, H. Chen, Z. Shao, X. Zhang, K. Wang, and L. Xue, A Novel (La0.2Sm0.2Eu0.2Gd0.2Tm0.2)2Zr2O7 High-Entropy Ceramic Nanofiber with Excellent Thermal Stability, Ceram. Int., 2021, 47(20), p 29379–29385.
Y. Yao, F. Yang, and X. Zhao, Multicomponent High-Entropy Zr-Y-Yb-Ta-Nb-O Oxides for Next-Generation Thermal Barrier Coating Applications, J. Am. Ceram. Soc., 2021, 105(1), p 35–43.
C. Viazzi, J.-P. Bonino, F. Ansart, and A. Barnabé, Structural Study of Metastable Tetragonal YSZ Powders Produced Via a Sol–Gel Route, J. Alloy. Compd., 2008, 452(2), p 377–383.
K. Tõnsuaadu, A. Zalga, A. Beganskiene, and A. Kareiva, Thermoanalytical Study of the YSZ Precursors Prepared by Aqueous Sol–Gel Synthesis Route, J. Therm. Anal. Calorim., 2012, 110(1), p 77–83.
C. Yuhui, Z. Ruolin, S. Jiaxiang, Z. Baiqiang, and Z. Yonghai, Effect of Porosity on Thermal Conductivity of Five-Element Ceramic System Materials, J. Aeronaut. Mater., 2023, 43(2), p 66–74.
J.N. Plendl and P.J. Gielisse, Hardness of Nonmetallic Solids on an Atomic Basis, Phys. Rev., 1962, 125(3), p 828.
X. Ren, C. Wan, M. Zhao, J. Yang, and W. Pan, Mechanical and Thermal Properties of Fine-Grained Quasi-Eutectoid (La1−Yb )2Zr2O7 Ceramics, J. Eur. Ceram. Soc., 2015, 35(11), p 3145–3154.
D.R. Clarke and C.G. Levi, Materials Design for the Next Generation Thermal Barrier Coatings, Annu. Rev. Mater. Res., 2003, 33(1), p 383–417.
D.R. Clarke, Materials Selection Guidelines for Low Thermal Conductivity Thermal Barrier Coatings, Surf. Coat. Technol., 2003, 163–164, p 67–74.
H. Wang, S. Lin, S. Yang, X. Yang, J. Song, D. Wang, H. Wang, Z. Liu, B. Li, M. Fang, N. Wang, and H. Wu, High-Temperature Particulate Matter Filtration with Resilient Yttria-Stabilized ZrO2 Nanofiber Sponge, Small, 2018, 14(19), p 1800258.
Y. Chen, R. Zhang, S. Hu, P. Jiang, J. Sun, B. Zhang, and Y. Zhang, Mechanical Properties of (ZrYTaErTi)O Composites, Ceram. Int., 2023, 49(3), p 5261–5268.
X. Song, Y. Ding, J. Zhang, C. Jiang, Z. Liu, C. Lin, W. Zheng, and Y. Zeng, Effect of Dy2O3 Doping on Phase Compositions, Microstructures, Thermophysical Properties and Fracture Toughness of YSZ Coatings, J. Market. Res., 2022, 20(9), p 3549–3560.
G. Hengrong, L. Meida, S. Xiaofeng, Z. Chongyuan, H. Wangyu, G. Shengkai, J. Tao, Z. Nairen, and H. Zhuangqi, Investigation on Oxidation and Failure of the Thermal Barrier Coating Deposited on Superalloy, Acta Metall. Sin., 2002, 11(38), p 1133–1140.
R. Ahmadi-Pidani, R. Shoja-Razavi, R. Mozafarinia, and H. Jamali, Evaluation of Hot Corrosion Behavior of Plasma Sprayed Ceria and Yttria Stabilized Zirconia Thermal Barrier Coatings in the Presence of Na2SO4+V2O5 Molten Salt, Ceram. Int., 2012, 38(8), p 6613–6620.
Acknowledgments
This study was supported by the National Natural Science Foundation of China Youth Foundation (No. 51705474), Science and Technology Research Project of Henan Province (No. 232102320213).
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Springer Nature or its licensor (e.g. a society or other partner) holds exclusive rights to this article under a publishing agreement with the author(s) or other rightsholder(s); author self-archiving of the accepted manuscript version of this article is solely governed by the terms of such publishing agreement and applicable law.
About this article
Cite this article
Chen, Y., Wang, L., Hu, S. et al. Properties of a Five-Element Oxide Ceramic (ZrYTaAB)O Prepared by Mechanical Milling and Sintering. J. of Materi Eng and Perform (2024). https://doi.org/10.1007/s11665-024-09440-4
Received:
Revised:
Accepted:
Published:
DOI: https://doi.org/10.1007/s11665-024-09440-4