Abstract
The trifluoroacetate metal-organic deposition (TFA-MOD) is one of the most appealing routes for the growth of high-quality YBa2Cu3O7-δ (YBCO) coated conductors (CCs) due to its advantages of low cost and high efficiency. However, the puzzle of the inhomogeneities in microstructures and superconducting properties of YBCO CCs prepared based on the TFA-MOD route remain still a challenge. In this paper, 10 cm long YBCO films were prepared under different low-pressure conditions. These YBCO films were deposited on buffered Hastelloy C276 tapes using a dip coater. The effect of different ambient pressures on the microstructure and critical current density of YBCO films was investigated. High critical current density (JC) YBCO coated conductors with good homogeneity were obtained. The JC values (77 K, self-field) at different positions along the length direction of YBCO coated conductor were around 3.5–4 MA/cm2. The results showed that only under a suitable pressure the homogeneities of the microstructure and critical current density along the length direction of coated conductor can be greatly improved. The improvement was mainly ascribed to good texture and the absence of impurity phases BaF2 and Ba4Y2O7 in the films.
Highlights
-
(1)
Solution-deposited long YBa2Cu3O7-δ CCs with high homogeneity were obtained.
-
(2)
Excess water vapor causes formation of Ba4Y2O7 in the YBCO films.
-
(3)
Excess water vapor converts orientations of needle-shaped grains from order to disorder.
Similar content being viewed by others
References
Sharma RG (2015) Superconductivity: basics and applications to magnets. Springer, Witzerland
Wee SH, Zuev YL, Cantoni C, Goyal A (2013) Engineering nanocolumnar defect configurations for optimized vortex pinning in high temperature superconducting nanocomposite wires. Sci Rep 3:2310
Paranthaman MP, Aytug T, Stan L, Jia QX, Cantoni C, Wee SH (2014) Chemical solution derived planarization layers for highly aligned IBAD-MgO templates. Supercond Sci Technol 27:022002
Matias V, Rowley EJ, Coulter Y, Maiorov B, Holesinger T, Yung C, Glyantsev V, Moeckly B (2010) YBCO films grown by reactive co-evaporation on simplified IBAD-MgO coated conductor templates. Supercond Sci Technol 23:014018
Yamasaki H, Ohki K, Yamaguchi I, Sohma M, Kondo W, Matsui H, Manabe T, Kumagai T (2010) Strong flux pinning due to dislocations associated with stacking faults in YBa2Cu3O7-δ thin films prepared by fluorine-free metal organic deposition. Supercond Sci Technol 23:105004
Aytug T, Chen Z, Maroni VA, Miller DJ, Cantoni C, Specht ED, Kropf AJ, Zaluzec N, Zhang Y, Zuev Y, Paranthaman M (2011) Nano-engineered defect structures in Ce- and Ho-doped metal-organic chemical vapor deposited YBa2Cu3O6+δ films: Correlation of structure and chemistry with flux pinning performance. J Appl Phys 109:113923
Selvamanickam V, Xu A, Liu Y, Khatri ND, Lei C, Chen Y, Galstyan E, Majkic G (2014) Correlation between in-field critical currents in Zr-added (Gd, Y) Ba2Cu3Ox superconducting tapes at 30 and 77 K. Supercond Sci Technol 27:055010
Araki T, Hirabayashi I (2003) Review of a chemical approach to YBa2Cu3O7-x-coated, superconductors-metalorganic deposition using trifluoroacetates. Supercond Sci Technol 16:R71
Obradors X, Puig T, Ricart S, Coll M, Gazquez J, Palau A, Granados X (2012) Growth, nanostructure and vortex pinning in superconducting YBa2Cu3O7 thin films based on trifluoroacetate solutions. Supercond Sci Technol 25:123001
Zhang HL, Ding FZ, Gu HW, Dong ZB, Qu F (2016) Fabrication of high-JC BaTiO3-doped YBa2Cu3O7-δ thin films by the low-fluorine TFA-MOD approach. J Alloy Compd 664:5–10
Dong ZB, Gu HW, Zhang HL, Shang HJ, Huang DX, Xu WJ, Zhang H, Ding FZ (2019) Heat treatment design of precursor solutions with different fluorine contents for YBa2Cu3O7-x films through the sol-gel approach. J Sol-Gel Sci Techn 90:263
Dong ZB, Din FZ, Zhang JL, Zhang HL, Shang HJ, Huang DX, Xu WJ, Zhang H, Zhang H, Gu HW (2019) Enhanced flux pinning of solution-derived YBa2Cu3O7-x nanocomposite films with novel ultra-small BaMnO3 nanocrystals. Supercond Sci Technol 32:025004
Zhang HL, Ding FZ, Gu HW, Dong ZB, Qu F, Shang HJ (2016) Effect of Ba/Y molar ratio on superconducting properties of BaTiO3-Doped YBa2Cu3O7-δ films. J Supercond Nov Magn 29:1227
Wang HY, Ding FZ, Gu HW, Zhang HL, Dong ZB (2017) Microstructure and superconducting properties of (BaTiO3, Y2O3)-doped YBCO films under different firing temperatures. Rare Met 36:37
Bhuiyan MS, Paranthaman M, Salama K (2006) Solution-derived textured oxide thin films:a review. Supercond Sci Technol 19:R1
Rupich MW, Verebelyi DT, Zhang W, Kodenkandath T, Li XP (2004) Metalorganic deposition of YBCO films for second-generation high-temperature superconductor wires. MRS Bull 29:572
Farjas J, Camps J, Roura P, Ricart S, Puig T, Obradors X (2012) The thermal decomposition of barium trifluoroacetate. Thermochim Acta 544:77
Chen YQ, Bian WB, Huang WH, Tang XN, Zhao GY, Li LW, Li N, Huo W, Jia JQ, You CY (2016) High critical current density of YBa2Cu3O7−x superconducting films prepared through a DUV-assisted solution deposition process. Sci Rep 6:38257
Wu W, Feng F, Zhao Y, Tang X, Xue YR, Shi K, Huang RX, Qu TM, Wang XH, Han ZH, Grivel JC (2014) A low-fluorine solution with a 2:1 F/Ba mole ratio for the fabrication of YBCO films. Supercond Sci Technol 27:055006
Li MJ, Yang WT, Shu GQ, Bai CY, Lu YM, Guo YQ, Liu ZY, Cai CB (2015) Controlled-growth of YBa2Cu3O7−δ film using modified low-fluorine chemical solution deposition. IEEE Trans Appl Supercond 25:6601804
Chung KC, Yoo JM, Ko JW, Kim YK, Wang XL, Dou SX (2007) Properties of MOD-YBCO films at low pressure annealing process. Phys C 460:1422
List FA, Clem PG, Heatherly L, Dawley JT, Leonard KJ, Lee DF, Goyal A (2005) Low-pressure conversion studies for YBCO precursors derived by PVD and MOD methods. IEEE Trans Appl Supercond 15:2656
Chu JY, Zhao Y, Khan MZ, Tang X, Wu W, Shi JT, Wu Y, Huhtinen H, Suo HL, Jin ZJ (2019) Insight into the interfacial nucleation and competitive growth of YBa2Cu3O7-δ films as high-performance coated conductors by a fluorine-free metal-organic decomposition route. Cryst Growth Des 19:6752–6762
Cai YQ, Yao X, Lai YJ (2006) Mechanism of transition between a-axis and c-axis growth of YBa2Cu3Ox thick films grown on NdGaO3 substrate. J Appl Phys 99:113909
Nakaoka K, Yoshida R, Kimura K, Kato T, Usui Y, Izumi T, Shiohara Y (2017) Another approach for controlling size and distribution of nanoparticles in coated conductors fabricated by the TFA-MOD method. Supercond Sci Technol 30:055008
Acknowledgements
This work was supported by Project supported by the National Natural Science Foundation of China (Grant no. 51577180), the Joint Fund of National Natural Science Foundation of China (Grant no. U1832131) and the Natural Science Foundation of Hebei Province (Grant no. E2018402097).
Author information
Authors and Affiliations
Corresponding authors
Ethics declarations
Conflict of interest
The authors declare that they have no conflict of interest.
Additional information
Publisher’s note Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Zhang, H., Huang, D., Zhang, C. et al. High homogeneity 10 cm long BaTiO3-doped YBa2Cu3O7-δ films by the trifluoroacetate metal-organic deposition process. J Sol-Gel Sci Technol 96, 297–303 (2020). https://doi.org/10.1007/s10971-020-05367-z
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10971-020-05367-z