Abstract
The dielectric behaviour of epoxy and polyester laminates has been studied before and after exposing the samples to moisture (relative humidity 60 to 95%) and various exhalates (HCl, HNO3, HCOOH, CH3COOH, NH3 and SO2 vapours) which are normally released by electronic packaging materials. A strong dielectric dispersion at room temperature is observed after exposing the samples to moisture and various exhalates. The dissipation factor also increases quite appreciably, the increase being more at higher exposure times. The results have been explained in terms of the ionic conductivity due to the dissociation of the exhalates. Recovery studies have also been made and it was found that the changes were reversible except in the case of HCOOH and CH3COOH, for epoxy and in the case of NH3 for polyester. These results indicate some chemical changes in these cases.
Similar content being viewed by others
References
P. C. Arni, G. C. Cochrane andJ. D. Gray,J. Appl. Chem. 15 (1965) 305.
V. E. Rance andH. G. Cole, “Corrosion of Metals by Vapours from Organic Materials” (H.M.S.O., London, 1958).
C. E. Jowett (ed.), “Electronics and Environment” (London Business Book Limited).
Martin T. Goosey (ed.) “Plastics for Electronics” (Elsevier Applied Science, London, 1985).
Leo S. Kohn, in “Epoxy Resin Technology”, edited by Paul F. Bruins, (Interscience 1968).
B. Barkatakova andB. Hranickova,Technical Digest 10 (1968) 730.
Ibert Mellan (ed.), “Corrosion Resistant Materials”, 3rd Edn, (Noyes Data Corporation, New Jersey, 1976).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Singh, D.B., Kumar, A., Tayal, V.P. et al. Dielectric behaviour of epoxy and polyester laminates in moisture and electronic packaging exhalates. J Mater Sci 23, 528–534 (1988). https://doi.org/10.1007/BF01174680
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF01174680