Skip to main content
Log in

Preparation and Tribological Properties of Polyimide/Carboxyl-Functionalized Multi-walled Carbon Nanotube Nanocomposite Films Under Seawater Lubrication

  • Original Paper
  • Published:
Tribology Letters Aims and scope Submit manuscript

Abstract

The polyimide (PI)/carboxyl-functionalized multi-walled carbon nanotube (MWCNTs-COOH) nanocomposite films were synthesized by situ polymerization method. The results showed that the incorporation of MWCNTs-COOH greatly enhanced thermal stability and mechanical property of PI. PI/MWCNTs-COOH nanocomposites exhibited better tribological properties under seawater lubrication than other conditions because of excellent lubricating effect of seawater. Besides, the wear resistance of PI under seawater lubrication had been greatly improved by filling MWCNTs-COOH, because strong interfacial adhesion between PI matrix and MWCNTs-COOH nanofillers could transfer load effectively between contact surfaces. In particular, when the content of MWCNTs-COOH was 0.7 wt%, the corresponding PI/MWCNTs-COOH nanocomposites had the best tribological properties under seawater lubrication.

Graphical Abstract

The polyimide (PI)/carboxyl-functionalized multi-walled carbon nanotube (MWCNTs-COOH) nanocomposite films were synthesized by in situ polymerization using 4,4′-oxydianiline (ODA), carboxyl-functionalized multi-walled carbon nanotube (MWCNTs-COOH) and pyromellitic dianhydride (PMDA). The tribological properties of PI/MWCNTs-COOH nanocomposite films were measured under dry sliding condition, pure water condition and seawater lubrication condition. This study can provide some guidance to develop polymer materials with excellent wear resistance suitable for ocean environment.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15

Similar content being viewed by others

References

  1. Yang, S.D., Li, Z.Y.: Seawater hydraulic drive and its application in ocean exploitation. Ocean Eng. 18, 81–85 (2000)

    Google Scholar 

  2. Cui, G.J., Bi, Q.L., Zhu, S.Y., Yang, J., Liu, W.M.: Tribological behavior of Cu–6Sn–6Zn–3Pb under sea water, distilled water and dry-sliding conditions. Tribol. Int. 55, 126–134 (2012)

    Article  Google Scholar 

  3. Zhang, L.B., Wang, J.Q., Wang, H.G., Xu, Y., Wang, Z.F., Li, Z.P., Mi, Y.J., Yang, S.R.: Preparation, mechanical and thermal properties of functionalized graphene/polyimide nanocomposites. Compos. Part A Appl. Sci. Manuf. 43, 1537–1545 (2012)

    Article  Google Scholar 

  4. Liu, H., Li, Y.Q., Wang, T.M., Wang, Q.H.: In situ synthesis and thermal, tribological properties of thermosetting polyimide/graphene oxide nanocomposites. J. Mater. Sci. 47, 1867–1874 (2012)

    Article  Google Scholar 

  5. Chen, J.S., Jia, J.H., Zhou, H.D., Chen, J.M., Yang, S.Y., Fan, L.: Tribological behavior of short-fiber-reinforced polyimide composites under dry-sliding and water-lubricated conditions. J. Appl. Polym. Sci. 107, 788–796 (2008)

    Article  Google Scholar 

  6. Jia, J.H., Zhou, H.D., Gao, S.Q., Chen, J.M.: A comparative investigation of the friction and wear behavior of polyimide composites under dry sliding and water-lubricated condition. Mater. Sci. Eng. A Struct. 356, 48–53 (2003)

    Article  Google Scholar 

  7. Iijima, S.: Helical micro-tubules of graphitic carbon. Nature 345, 56–58 (1991)

    Article  Google Scholar 

  8. Dong, B., Yang, Z., Huang, Y., Li, H.L.: Study on tribological properties of multi-walled carbon nanotubes/epoxy resin nanocomposites. Tribol. Lett. 20, 251–254 (2005)

    Article  Google Scholar 

  9. Cai, H., Yan, F.Y., Xue, Q.J.: Investigation of tribological properties of polyimide/carbon nanotube nanocomposites. Mater. Sci. Eng. A Struct. 364, 94–100 (2004)

    Article  Google Scholar 

  10. Meng, H., Sui, G.X., Xie, G.Y., Yang, R.: Friction and wear behavior of carbon nanotubes reinforced polyamide 6 composites under dry sliding and water lubricated condition. Compos. Sci. Technol. 69, 606–611 (2009)

    Article  Google Scholar 

  11. Wang, S.B., Pan, L., Li, Q.: Tribological behaviors of polytetrafluoroethylene composites under dry sliding and seawater lubrication. J. Appl. Polym. Sci. 39454, 2523–2531 (2013)

    Article  Google Scholar 

  12. Chen, B.B., Wang, J.Z., Yan, F.Y.: Microstructure of PTFE-based polymer blends and their tribological behaviors under aqueous environment. Tribol. Lett. 45, 387–395 (2012)

    Article  Google Scholar 

  13. Wu, D.C., Shen, L., Low, J.E., Wong, S.Y., Li, X., Tjiu, W.C., Liu, Y., He, C.B.: Multi-walled carbon nanotube/polyimide composite film fabricated through electrophoretic deposition. Polymer 51, 2155–2160 (2010)

    Article  Google Scholar 

  14. Zhang, H.J., Zhang, Z.Z., Guo, F., Wang, K., Jiang, W.: Enhanced wear properties of hybrid PTFE/cotton fabric composites filled with functionalized multi-walled carbon nanotubes. Mater. Chem. Phys. 116, 183–190 (2009)

    Article  Google Scholar 

  15. Men, X.H., Zhang, Z.Z., Song, H.J., Wang, K., Jiang, W.: Functionalization of carbon nanotubes to improve the tribological properties of poly(furfuryl alcohol) composite coatings. Compos. Sci. Technol. 68, 1042–1049 (2008)

    Article  Google Scholar 

  16. Chang, Y.H., Wu, M.S., Lin, K.F.: Graphting polyimide to MWCNT for enhancing dispersion and properties of MWCNT/polyetherimide nanocomposites. J. Polym. Res. 21, 419–426 (2014)

    Article  Google Scholar 

  17. Tseng, I.H., Chang, J.C., Huang, S.L., Tsai, M.H.: Enhanced thermal conductivity and dimensional stability of flexible polyimide nanocomposite film by addition of functionalized graphene oxide. Polym. Int. 62, 827–835 (2013)

    Article  Google Scholar 

  18. Luong, N.D., Hippi, U., Korhonen, J.T., Soininen, A.J., Ruokolainen, J., Johansson, L.S., Nam, J.D., Sinh, L.H., Seppälä, J.: Enhanced mechanical and electrical properties of polyimide film by grapheme sheets via in situ polymerization. Polymer 52, 5237–5242 (2011)

    Article  Google Scholar 

  19. Lee, D.Y., Lee, M.H., Kim, K.J., Heo, S., Kim, B.Y., Lee, S.J.: Effect of multiwalled carbon nanotube (M-CNT) loading on M-CNT distribution behavior and the related electromechanical properties of the M-CNT dispersed ionomeric nanocomposites. Surf. Coat. Technol. 200, 1920–1925 (2005)

    Article  Google Scholar 

  20. Shi, H.G., Li, Y., Guo, T.Y.: In situ preparation of transparent polyimide nanocomposite with a small load of graphene oxide. J. Appl. Polym. Sci. 128, 3163–3169 (2013)

    Article  Google Scholar 

  21. Jiang, Q., Wang, X., Zhu, Y.T., Hui, D., Qiu, Y.P.: Mechanical, electrical and thermal properties of aligned carbon nanotube/polyimide composites. Compos. Part B Eng. 56, 408–412 (2014)

    Article  Google Scholar 

  22. Chen, C.S., Chen, X.H., Xu, L.S., Yang, Z., Li, W.H.: Modification of multi-walled carbon nanotubes with fatty acid and their tribological properties as lubricant additive. Carbon 43, 1660–1666 (2005)

    Article  Google Scholar 

  23. Yu, A., Hu, H., Bekyarova, E., Itkis, M.E., Gao, J., Zhao, B., Haddon, R.C.: Incorporation of highly dispersed single-walled carbon nanotubes in a polyimide matrix. Compos. Sci. Technol. 66, 1190–1197 (2006)

    Article  Google Scholar 

  24. Demiana, C., Liao, H.L., Lachat, R., Costila, S.: Investigation of surface properties and mechanical and tribological behaviors of polyimide based composite coatings. Surf. Coat. Technol. 235, 603–610 (2013)

    Article  Google Scholar 

  25. Shen, X.J., Pei, X.Q., Liu, Y., Fu, S.Y.: Tribological performance of carbon nanotube–graphene oxide hybrid/epoxy composites. Compos. Part B Eng. 57, 120–125 (2014)

    Article  Google Scholar 

  26. Jiang, Q., Tallury, S.S., Qiu, Y.P., Pasquinelli, M.A.: Molecular dynamics simulations of the effect of the volume fraction on unidirectional polyimide–carbon nanotube nanocomposites. Carbon 67, 440–448 (2004)

    Article  Google Scholar 

  27. Michálek, M., Sedláček, J., Parchoviansky, M., Michálková, M., Galusek, D.: Mechanical properties and electrical conductivity of alumina/MWCNT and alumina/zirconia/MWCNT composites. Ceram. Int. 40, 1289–1295 (2014)

    Article  Google Scholar 

  28. Min, C.Y., Nie, P., Song, H.J., Zhang, Z.Z., Zhao, K.L.: Study of tribological properties of polyimide/graphene oxide nanocomposite films under seawater-lubricated condition. Tribol. Int. 80, 131–140 (2014)

    Article  Google Scholar 

Download references

Acknowledgments

The work was supported by the National Natural Science Foundation of China (51103065) and the Foundation of State Key Laboratory of Solid Lubrication (1202).

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Chunying Min.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Nie, P., Min, C., Song, HJ. et al. Preparation and Tribological Properties of Polyimide/Carboxyl-Functionalized Multi-walled Carbon Nanotube Nanocomposite Films Under Seawater Lubrication. Tribol Lett 58, 7 (2015). https://doi.org/10.1007/s11249-015-0476-7

Download citation

  • Received:

  • Accepted:

  • Published:

  • DOI: https://doi.org/10.1007/s11249-015-0476-7

Keywords

Navigation