Skip to main content
Log in

Comparison of calculated results with NTD measured data for establishment of burned core model for Monte Carlo simulation of HANARO reactor

  • Published:
Journal of Radioanalytical and Nuclear Chemistry Aims and scope Submit manuscript

Abstract

The modeling method to establish a depleted-core model for the Monte Carlo simulation was verified by comparing the analysis results with the neutron flux distribution obtained by a zirconium activation method and a reaction rate of 30Si(n, γ) 31Si obtained using a resistivity measurement method. First, the modeling method used to build the depleted-core model using the HANAFMS core management system is explained. Calculation and measurement methods are also described including the reactor condition, irradiation device, and data treatment methodology. Finally, the viability of the proposed modeling method was discussed through a comparison of the calculated and measured results.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Fig. 1
Fig. 2
Fig. 3

Similar content being viewed by others

References

  1. Schmidt PE, Vedde J (1998) High resistivity NTD production and applications. Transections Electrochem Soc 98–13:3–16

    Google Scholar 

  2. Jun BJ, Lee CS, Lee BC, Kim HR (2000) Analysis of NTD Method in HANARO. Transections of the Korean Nuclear Society Autumn Meeting, Daejeon

    Google Scholar 

  3. Jun BJ, Song YD, Ki MS, Lee BC (2002) Neutronic design of irradiation device for neutron transmutation doppping in HANARO. In: Proceedings of transections of the PHYSOR 2002, Seoul, Korea

  4. Kim MS (2006) Radial uniformity of neutron irradiation in silicon ingots for neutron transmutation doping at HANARO. Nucl Eng Technol 38(1):93–98

    CAS  Google Scholar 

  5. X-5 Monte Carlo Team (2003) MCNP-A general Monte Carlo N-Particle transport code, Version 5, LAUR-03-1987, Los Alamos National Laboratory

  6. Kim HR, Lee CS, Lee BJ (1998) In-core fuel management practice in HANARO. Nucl Eng Des. 179:282–286

    Article  Google Scholar 

  7. Cho DK, Sun GM, Hwang TW et al (2011) Sensitivity of physics parameters for establishment of a burned CANDU full-core model for decommissioning waste characterization. J Nucl Sci Technol 48(2):215–226

    Article  CAS  Google Scholar 

  8. Cho DK, Sun GM, Hwang TW et al (2011) Verification of source term estimation method against measured data for decommissioning waste from a CANDU reactor. J Nucl Sci Technol 48(7):1087–1093

    Article  CAS  Google Scholar 

  9. Park SJ, Kim MS, Kang KD, Lim IC (2009) Characteristics and operation of neutron transmutation doping in HANARO reactor.In: Proceedings of ICONE17, Brussels, Belgium

Download references

Acknowledgments

The authors acknowledge that this work was funded by the Ministry of Science, ICT and future Planning of Korea.

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Dong-Keun Cho.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Cho, DK., Kim, MS. Comparison of calculated results with NTD measured data for establishment of burned core model for Monte Carlo simulation of HANARO reactor. J Radioanal Nucl Chem 303, 1629–1633 (2015). https://doi.org/10.1007/s10967-014-3784-8

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s10967-014-3784-8

Keywords

Navigation