ISRM Suggested Methods for Rock Stress Estimation—Part 5: Establishing a Model for the In Situ Stress at a Given Site Ove StephanssonArno Zang ISRM SUGGESTED METHOD 23 June 2012 Pages: 955 - 969
Suggested Methods for Rock Failure Criteria: General Introduction R. UlusayJ. A. Hudson ISRM Suggested Method 03 July 2012 Pages: 971 - 971
Introduction to Suggested Methods for Failure Criteria Bezalel HaimsonAntonio Bobet ISRM SUGGESTED METHOD 03 July 2012 Pages: 973 - 974
Mohr–Coulomb Failure Criterion Joseph F. LabuzArno Zang ISRM SUGGESTED METHOD 03 July 2012 Pages: 975 - 979
Three-Dimensional Failure Criteria Based on the Hoek–Brown Criterion Stephen Priest ISRM SUGGESTED METHOD 18 July 2012 Pages: 989 - 993
Drucker–Prager Criterion Leandro R. AlejanoAntonio Bobet ISRM SUGGESTED METHOD 18 July 2012 Pages: 995 - 999
Lade and Modified Lade 3D Rock Strength Criteria Sergio A. B. da Fontoura ISRM SUGGESTED METHOD 18 July 2012 Pages: 1001 - 1006
A Failure Criterion for Rocks Based on True Triaxial Testing Chandong ChangBezalel Haimson ISRM SUGGESTED METHOD 18 July 2012 Pages: 1007 - 1010
ISRM Suggested Method for the Determination of Mode II Fracture Toughness Tobias BackersOve Stephansson ISRM SUGGESTED METHOD 03 July 2012 Pages: 1011 - 1022
Comparison of Different Techniques of Tilt Testing and Basic Friction Angle Variability Assessment Leandro R. AlejanoJavier GonzálezJosé Muralha Original Paper 24 May 2012 Pages: 1023 - 1035
Analytical Study of Underground Explosion-Induced Ground Motion J. C. LiG. W. MaY. X. Zhou Original Paper 16 December 2011 Pages: 1037 - 1046
Estimation of Elastic Modulus of Intact Rocks by Artificial Neural Network Ibrahim OcakSadi Evren Seker Original Paper 10 March 2012 Pages: 1047 - 1054
Application of Generalized Regression Neural Networks in Predicting the Unconfined Compressive Strength of Carbonate Rocks Nurcihan CeryanUmut OkkanAyhan Kesimal Original Paper 15 March 2012 Pages: 1055 - 1072
A Novel Testing Apparatus for Hydromechanical Investigation of Rocks: Geo-Sequestration of Carbon dioxide R. ShuklaP. G. RanjithA. Haque Original Paper 23 March 2012 Pages: 1073 - 1085
Effect of Thermal Treatment on the Dynamic Fracture Toughness of Laurentian Granite Tubing YinXibing LiSheng Huang Original Paper 20 March 2012 Pages: 1087 - 1094
Deep-Seated Slope Failures Induced by Inappropriate Cutting in China Hong-Yue SunYu ZhaoQuan-Li Zhao Original Paper 25 August 2012 Pages: 1103 - 1111
Physical Properties of Sandstones After High Temperature Treatment Hong TianThomas KempkaMartin Ziegler Technical Note 24 February 2012 Pages: 1113 - 1117
Uncertainty in Measurements of Vibrations From Blasting Pablo SegarraLina M. LópezJosé A. Sanchidrián Technical Note 27 April 2012 Pages: 1119 - 1126
Discussion on “Predicting the Uniaxial Compressive and Tensile Strengths of Gypsum Rock by Point Load Testing” by M. Heidari et al., Rock Mechanics and Rock Engineering (2012) 45:265–273 Diyuan LiLouis Ngai Yuen Wong Discussion 29 May 2012 Pages: 1127 - 1130
Reply to Discussion by Li and Wong on “Predicting the Uniaxial Compressive and Tensile Strengths of Gypsum Rock by Point Load Testing” by Heidari et al., Rock Mechanics and Rock Engineering (2012) 45:265–273 M. HeidariG. R. KhanlariM. Torabi-Kaveh Reply 22 May 2012 Pages: 1131 - 1135
Discussion of Alejano, Gonzalez and Muralha (2012) S. R. Hencher Discussion Open access 20 July 2012 Pages: 1137 - 1139
Response by the Authors to S. R. Hencher’s Discussion of the Paper “Comparison of Different Techniques of Tilt Testing and Basic Friction Angle Variability Assessment Leandro R. AlejanoJavier GonzálezJosé Muralha Reply 28 September 2012 Pages: 1141 - 1143