1. Modeling and experimental validation of the surface residual stresses induced by deep rolling and presetting of a torsion bar

   • Jasenko Perenda
   • Jovan Trajkovski
   • Ivan Prebil

   Original Research 21 March 2015 Pages: 435 - 448

   

2. Extension of the normalized Cockcroft and Latham criterion with temperature-dependent critical damage values for predicting chevron cracks in solid forward extrusion

   • Michael Terhorst
   • Andreas Feuerhack
   • Fritz Klocke

   Original Research 19 March 2015 Pages: 449 - 456

   

3. Crystal plasticity finite element simulations of pure bending of aluminium alloy AA7108

   • A. Saai
   • I. Westermann
   • O. S. Hopperstad

   Original Research 03 April 2015 Pages: 457 - 469

   

4. Numerical simulation and optimization of the injection blow molding of polypropylene bottles - a single stage process

   • J. Biglione
   • Y. Béreaux
   • S. Chhay

   Original Research 26 March 2015 Pages: 471 - 487

   

5. Deep rolling of fine blanking punch edges

   • F. Klocke
   • A. Shirobokov
   • P. Mattfeld

   Original Research 16 April 2015 Pages: 489 - 498

   

6. Numerical study of the effect of martensite plasticity on the forming limits of a dual-phase steel sheet

   • C. D. Schwindt
   • M. A. Bertinetti
   • J. W. Signorelli

   Original Research 23 April 2015 Pages: 499 - 517

   

7. Modelling of sintering during rotational moulding of the thermoplastic polymers

   • A. Hamidi
   • S. Farzaneh
   • A. Tcharkhtchi

   Original Research 24 April 2015 Pages: 519 - 530

   

8. Measuring and modelling air mass flow rate in the injection stretch blow moulding process

   • Y. Salomeia
   • G. H. Menary
   • S. Yan

   Original Research 19 April 2015 Pages: 531 - 545

   

9. Identification of material parameters for thin sheets from single biaxial tensile test using a sequential inverse identification strategy

   • P. A. Prates
   • M. C. Oliveira
   • J. V. Fernandes

   Original Research 14 May 2015 Pages: 547 - 571