1. Modeling contact of indenter with elastic half-space with adhesive attraction assigned in arbitrary form

   • Yu. Yu. Makhovskaya

   OriginalPaper 11 August 2016 Pages: 301 - 307

2. Intelligent method for monitoring the state of lubricating oil

   • L. V. Markova

   OriginalPaper 11 August 2016 Pages: 308 - 314

3. Distribution of friction tangential stresses in the Courtney-Pratt experiment under Bowden’s theory

   • A. V. Dykha
   • A. G. Kuzmenko

   OriginalPaper 11 August 2016 Pages: 315 - 319

4. Effect of ratio of hardnesses, load, and roughness parameters on approach in elastoplastic contact of rough surfaces of flat parts

   • M. M. Matlin
   • E. N. Kazankina
   • V. A. Kazankin

   OriginalPaper 11 August 2016 Pages: 320 - 323

5. Self-setting of forces of friction during cross rolling

   • G. V. Kozhevnikova

   OriginalPaper 11 August 2016 Pages: 324 - 329

6. Computer simulation of the friction of rough surfaces

   • O. V. Sutyagin
   • A. N. Bolotov
   • G. B. Burdo

   OriginalPaper 11 August 2016 Pages: 330 - 336

7. Tribochemical transformations of glycerol

   • A. A. Kuzharov
   • B. S. Luk’yanov
   • A. S. Kuzharov

   OriginalPaper 11 August 2016 Pages: 337 - 345

8. Experimental study of wear of model friction pairs lubricated with contaminated oil

   • S. V. Boldyrev
   • O. P. Budarova

   OriginalPaper 11 August 2016 Pages: 346 - 350

9. Effect of chemical structure of aramide and polyoxadiazole fibers on friction of organoplastics

   • D. I. Buyaev
   • A. P. Krasnov
   • M. I. Buzin

   OriginalPaper 11 August 2016 Pages: 351 - 357

10. Study of the influence of the friction clutch operability on the performance of the switch motor

    • N. I. Smirnov
    • M. V. Prozhega
    • N. N. Smirnov

    OriginalPaper 11 August 2016 Pages: 358 - 362

11. Wear resistance of cast Fe–Cr–C steels with various combinations of structural constituents at high velocities of sliding

    • V. G. Novytskyi
    • V. A. Loktionov-Remizovskyi
    • D. D. Panasenko

    OriginalPaper 11 August 2016 Pages: 363 - 370

12. Effect of conditions of diamond grinding on tribological behavior of alumina-based ceramics

    • V. V. Kuzin
    • S. Yu. Fedorov
    • A. E. Seleznev

    OriginalPaper 11 August 2016 Pages: 371 - 376

13. The role of structure formation in forming the physicomechanical properties of composites of the diamond–(Fe–Cu–Ni–Sn) system

    • V. A. Mechnik
    • N. A. Bondarenko
    • B. A. Lyashenko

    OriginalPaper 11 August 2016 Pages: 377 - 384

14. Wear resistance of electrospark WC–Cо coatings with different iron contents

    • A. A. Burkov

    OriginalPaper 11 August 2016 Pages: 385 - 388

15. Predicting the propagation of damage in roller bearings of aircraft engines by vibration analysis

    • B. M. Silaev
    • I. S. Barmanov
    • P. A. Danilenko

    OriginalPaper 11 August 2016 Pages: 389 - 394

16. Dаmреr with а pоrоus element fоr bearing arrangements

    • K. S. Akhverdiev
    • A. M. Mukutadze
    • B. M. Fleck

    OriginalPaper 11 August 2016 Pages: 395 - 400

17. Simulations of the working contact loads of a tillage element

    • R. Skirkus
    • V. Jankauskas
    • R. Gaidys

    OriginalPaper 11 August 2016 Pages: 401 - 405