Improving Powder Injection in Plasma Spraying by Optical Diagnostics of the Plasma and Particle Characterization Georg MauerRobert VaßenJochen Schein Peer Reviewed 02 November 2010 Pages: 3 - 11
Velocity Diagnostics for Gas Velocity Distributions in Cold Gas and Plasma Spraying Using Non-Resonant Laser Scattering Sebastian LangeMarco SieberChristian J. Kähler Peer Reviewed 15 October 2010 Pages: 12 - 20
Modeling of the Plasma Flow and Anode Region Inside a Direct Current Plasma Gun Rodolphe BolotChristian CoddetDominique Billières Peer Reviewed 17 October 2010 Pages: 21 - 27
Improvement of Plasma Spray Torch Stability by Controlling Pressure and Voltage Dynamic Coupling V. RatJ. F. Coudert Peer Reviewed 14 October 2010 Pages: 28 - 38
Predicting the Thermal Conductivity of AlSi/Polyester Abradable Coatings: Effects of the Numerical Method Rodolphe BolotJean-Louis SeichepineChristian Coddet Peer Reviewed 12 November 2010 Pages: 39 - 47
Effect of Substrate Temperature and Ambient Pressure on Heat Transfer at Interface Between Molten Droplet and Substrate Surface M. FukumotoK. YangM. Yamada Peer Reviewed 04 August 2010 Pages: 48 - 58
Flattening and Cooling of Millimeter- and Micrometer-Sized Alumina Drops S. GoutierM. VardelleP. Fauchais Peer Reviewed 11 November 2010 Pages: 59 - 67
Influence of the Surface State on the Adherence of the Coating: Case of an Alumina Coating Plasma Sprayed on SiC Composites S. CostilS. LukatC. Coddet Peer Reviewed 17 September 2010 Pages: 68 - 75
Relationships Between Process Parameters, Microstructure, and Adhesion Strength of HVOF Sprayed IN718 Coatings Christophe LyphoutPer NylénLars Östergren Peer Reviewed 02 September 2010 Pages: 76 - 82
Phase Composition and Microstructural Responses of Graded Mullite/YSZ Coatings Under Water Vapor Environments E. GarciaJ. Mesquita-GuimarãesR. S. Lima Peer Reviewed 13 November 2010 Pages: 83 - 91
Elastic Modulus Evolution and Behavior of Si/Mullite/BSAS-Based Environmental Barrier Coatings Exposed to High Temperature in Water Vapor Environment C. V. CojocaruS. E. KrugerR. S. Lima Peer Reviewed 03 December 2010 Pages: 92 - 99
Mechanical Behavior of Air Plasma-Sprayed YSZ Functionally Graded Mullite Coatings Investigated via Instrumented Indentation C. V. CojocaruY. WangM. I. Osendi Peer Reviewed 13 November 2010 Pages: 100 - 107
Next Generation Thermal Barrier Coatings for the Gas Turbine Industry Nicholas CurryNicolaie MarkocsanMitch Dorfman Peer Reviewed 17 November 2010 Pages: 108 - 115
Columnar-Structured Thermal Barrier Coatings (TBCs) by Thin Film Low-Pressure Plasma Spraying (LPPS-TF) Andreas HospachGeorg MauerDetlev Stöver Peer Reviewed 04 September 2010 Pages: 116 - 120
Effect of Chemical Compositions and Surface Morphologies of MCrAlY Coating on Its Isothermal Oxidation Behavior Yong LiChang-Jiu LiGuan-Jun Yang Peer Reviewed 13 November 2010 Pages: 121 - 131
The Oxidation Behavior of TBC with Cold Spray CoNiCrAlY Bond Coat W. R. ChenE. IrissouB. R. Marple Peer Reviewed 17 November 2010 Pages: 132 - 138
High Temperature Mechanical Behavior of UHTC Coatings for Thermal Protection of Re-Entry Vehicles G. PulciM. TuluiT. Valente Peer Reviewed 19 November 2010 Pages: 139 - 144
Preparation of Nanocomposite GDC/LSCF Cathode Material for IT-SOFC by Induction Plasma Spraying Yan ShenVeronica Alexandra B. AlmeidaFrançois Gitzhofer Peer Reviewed 19 November 2010 Pages: 145 - 153
The Structure and Properties of Plasma Sprayed Iron Oxide Doped Manganese Cobalt Oxide Spinel Coatings for SOFC Metallic Interconnectors Jouni PuranenJuha LagerbomPetri Vuoristo Peer Reviewed 18 November 2010 Pages: 154 - 159
Influence of Deposition Temperature on the Microstructures and Properties of Plasma-Sprayed Al2O3 Coatings Shun HaoChang-Jiu LiGuan-Jun Yang Peer Reviewed 12 November 2010 Pages: 160 - 169
Structural, Mechanical and Erosion Properties of Yttrium Oxide Coatings by Axial Suspension Plasma Spraying for Electronics Applications Junya KitamuraZhaolin TangAlan Burgess Peer Reviewed 12 November 2010 Pages: 170 - 185
Design of Experiment Analysis of the Sulzer Metco DJ High Velocity Oxy-Fuel Coating of Hydroxyapatite for Orthopedic Applications S. HasanJ. Stokes Peer Reviewed 17 October 2010 Pages: 186 - 194
Comparative Study of the Electrical Properties and Characteristics of Thermally Sprayed Alumina and Spinel Coatings Filofteia-Laura TomaStefan ScheitzSven Thiele Peer Reviewed 12 November 2010 Pages: 195 - 204
Influence of NH4Cl Powder Addition for Fabrication of Aluminum Nitride Coating in Reactive Atmospheric Plasma Spray Process Mohammed ShahienMotohiro YamadaMasahiro Fukumoto Peer Reviewed 12 November 2010 Pages: 205 - 212
Influence of Helium and Nitrogen Gases on the Properties of Cold Gas Dynamic Sprayed Pure Titanium Coatings Wilson WongEric IrissouStephen Yue Peer Reviewed Open access 02 November 2010 Pages: 213 - 226
Characterization of High-Temperature Abrasive Wear of Cold-Sprayed FeAl Intermetallic Compound Coating Chang-Jiu LiHong-Tao WangChong-Gao Bao Peer Reviewed 04 September 2010 Pages: 227 - 233
Influence of Impact Angle and Gas Temperature on Mechanical Properties of Titanium Cold Spray Deposits K. BinderJ. GottschalkT. Klassen Peer Reviewed 07 October 2010 Pages: 234 - 242
Influence of Pre-Heated Al 6061 Substrate Temperature on the Residual Stresses of Multipass Al Coatings Deposited by Cold Spray Silvano RechAndrea TrentinMario Guagliano Peer Reviewed 12 November 2010 Pages: 243 - 251
Investigation of Impact Behavior of Cold-Sprayed Large Annealed Copper Particles and Characterization of Coatings Wenya LiXueping GuoChristian Coddet Peer Reviewed 28 July 2010 Pages: 252 - 259
Corrosion Behavior of Cold Sprayed Titanium Coatings and Free Standing Deposits T. HussainD. G. McCartneyT. Marrocco Peer Reviewed 11 August 2010 Pages: 260 - 274
Consolidation of Al2O3/Al Nanocomposite Powder by Cold Spray Dominique PoirierJean-Gabriel LegouxRaynald Gauvin Peer Reviewed 12 November 2010 Pages: 275 - 284
Effect of Ceramic Particle Velocity on Cold Spray Deposition of Metal-Ceramic Coatings A. SovaV. F. KosarevI. Smurov Peer Reviewed 22 October 2010 Pages: 285 - 291
Formation of Cold-Sprayed Ceramic Titanium Dioxide Layers on Metal Surfaces J.-O. KliemannH. GutzmannT. Klassen Peer Reviewed Open access 21 October 2010 Pages: 292 - 298
Metallization of Thin Al2O3 Layers in Power Electronics Using Cold Gas Spraying Kerstin-Raffaela DonnerFrank GaertnerThomas Klassen Peer Reviewed 21 October 2010 Pages: 299 - 306
Effect of Using Liquid Feedstock in a High Pressure Cold Spray Nozzle E. FarvardinO. StierA. Dolatabadi Peer Reviewed 17 November 2010 Pages: 307 - 316
Analysis of the Mechanical Properties of an Arc Sprayed WC-FeCSiMn Coating: Compression, Bending, and Tension Behavior W. TillmannJ. Nebel Peer Reviewed 02 November 2010 Pages: 317 - 327
Analysis of the Mechanical Properties of an Arc-Sprayed WC-FeCSiMn Coating: Nanoindentation and Simulation W. TillmannB. KlusemannB. Svendsen Peer Reviewed 07 October 2010 Pages: 328 - 335
Microstructures of Metallic NiCrBSi Coatings Manufactured via Hybrid Plasma Spray and In Situ Laser Remelting Process Nicolas SerresFrançoise HlawkaFrédérique Machi Peer Reviewed 12 November 2010 Pages: 336 - 343
Microstructure and Electrochemical Behavior of Fe-Based Amorphous Metallic Coatings Fabricated by Atmospheric Plasma Spraying Z. ZhouL. WangY. B. Liu Peer Reviewed 30 October 2010 Pages: 344 - 350
Characteristics of Cu Film Deposited Using VLPPS N. ZhangF. SunC. Coddet Peer Reviewed 06 August 2010 Pages: 351 - 357
Thermophysical and Microstructural Studies on Thermally Sprayed Tungsten Carbide-Cobalt Coatings Sven ThieleKerstin SempfJörg Spatzier Peer Reviewed 16 October 2010 Pages: 358 - 365
Structure and Tribological Characteristics of HVOF Coatings Sprayed from Powder Blends of Cr3C2-25NiCr and NiCrBSi Alloy A. MäättäU. KanervaP. Vuoristo Peer Reviewed 30 October 2010 Pages: 366 - 371
Improved Hardfacing for Drill Bits and Drilling Tools Albert SueHarry SreshtaBao He Qiu Peer Reviewed 02 November 2010 Pages: 372 - 377
