1. Gas distribution in the initial section of vessels with a granular charge

   • Yu. L. Lyubina
   • A. L. Suris

   Research, Design, Calculations, and Operating Experience Pages: 199 - 206

2. Fractal dimensionality and operational indicators of fibrous filtering materials

   • F. F. Chausov
   • Yu. N. Germanov

   Research, Design, Calculations, and Operating Experience Pages: 207 - 212

3. Effect of the geometry of the “shell/elliptical-bottom” contact zone on the stress state of pressure vessels

   • R. G. Rizvanov
   • R. G. Abdeev
   • A. F. Insafutdinov

   Research, Design, Calculations, and Operating Experience Pages: 213 - 216

4. Method of evaluating the stresses from dents in the walls of pressure vessels

   • G. P. Ivanov
   • S. A. Razbitnoi

   Research, Design, Calculations, and Operating Experience Pages: 217 - 219

5. Optimum design of presses for making polymer and rubber engineering components

   • V. I. Kochetov

   Research, Design, Calculations, and Operating Experience Pages: 220 - 225

6. Choosing the parameters of a contact-type gas-steam power plant

   • I. V. Shcherbatenko

   Research, Design, Calculations, and Operating Experience Pages: 226 - 233

7. Experience with conversion of refrigerating turbomachinery to ozone-safe coolants

   • I. Ya. Sukhomlinov
   • D. L. Slavutskii
   • M. V. Golovin

   Research, Design, Calculations, and Operating Experience Pages: 234 - 236

8. Jet compressor plant with improved efficiency—A result of new design approaches

   • V. N. Eliseev

   Research, Design, Calculations, and Operating Experience Pages: 237 - 240

9. Flow optimization in the outlet section of the blade passage of a centrifugal pump

   • N. S. Yalovoi
   • A. M. Kats

   Research, Design, Calculations, and Operating Experience Pages: 241 - 244

10. Foreign use of software developed by the Rebis company

    • L. I. Egorova

    Research, Design, Calculations, and Operating Experience Pages: 245 - 248

11. Measurement of waste-water flow from industrial establishments

    • V. P. Malkin
    • V. I. Kuzin

    Industrial Ecology Pages: 249 - 250

12. Selection of oxidants and systems for purification of municipal and industrial waste waters

    • S. F. Strokatova
    • O. V. Yurk'yan
    • V. N. Azarov

    Industrial Ecology Pages: 251 - 254

13. Adequate qualimetry of ecological safety of technological objects

    • M. V. Arkind
    • M. G. Borchaninov
    • V. S. Karpov

    Industrial Ecology Pages: 255 - 256

14. Development of fluoroplastic antistatic coatings

    • E. V. Izvolenskii

    Materials Science and Corrosion Protection Pages: 257 - 258

15. Determination of the rheological characteristics of a carbon-fluoroplastic seal

    • A. P. Epishov
    • V. D. Prodan

    Materials Science and Corrosion Protection Pages: 259 - 262