Abstract
Understanding the viscous behavior of copper smelting slags is essential in increasing the process efficiency and obtaining the discrete separation between the matte and the slag. The viscosity of the FeOt-SiO2-Al2O3 copper smelting slags was measured in the current study using the rotating spindle method. The viscosity at a fixed Al2O3 concentration decreased with increasing Fe/SiO2 ratio because of the depolymerization of the molten slag by the network-modifying free oxygen ions (O2−) supplied by FeO. The Fourier transform infrared (FTIR) analyses of the slag samples with increasing Fe/SiO2 ratio revealed that the amount of large silicate sheets decreased, whereas the amount of simpler silicate structures increased. Al2O3 additions to the ternary FeOt-SiO2-Al2O3 slag system at a fixed Fe/SiO2 ratio showed a characteristic V-shaped pattern, where initial additions decreased the viscosity, reached a minimum, and increased subsequently with higher Al2O3 content. The effect of Al2O3 was considered to be related to the amphoteric behavior of Al2O3, where Al2O3 initially behaves as a basic oxide and changes to an acidic oxide with variation in slag composition. Furthermore, Al2O3 additions also resulted in the high temperature phase change between fayalite/hercynite and the modification of the liquidus temperature with Al2O3 additions affecting the viscosity of the copper smelting slag.
Similar content being viewed by others
References
N. Sano: Advanced Physical Chemistry for Process Metallurgy, Academic Press, New York, NY, 1997, pp. 47-48.
J.H. Park, H. Kim, and D.J. Min: Metall. Mater. Trans. B, 2008, vol. 39B, pp. 150-53.
A. Yazawa and M. Kameda: Tech. Repts, Tohoku Univ., 1953, vol. 18, pp. 40-58.
P. Röntgen, H. Winterhager, and L. Kammel: Erzmetall, 1956, vol. 9, pp. 207-14.
A.C. Ducret and W.J. Rankin: Scand. J. Metall., 2002, vol. 31, pp. 59-67.
Y.S. Lee, D.J. Min, S.M. Jung, and S.H. Lee: ISIJ Int., 2004, vol. 44, pp. 1283-90.
S. Banya and J.D. Shim: Can. Metall. Q., 1982, vol. 21, pp. 319-28.
J. Lumsden: Physical Chemistry of Process Metallurgy, Part 1, Interscience Publishers, New York, NY, 1961, p. 165.
A. Muan: Trans. AIME, 1955, vol. 203, pp. 965-76.
H. Kim, W.H. Kim, Y.S. Lee, J.H. Park, and D.J. Min: Steel Res. Int., 2010, vol. 81, pp. 261-64.
S. Sridhar, K.C. Mills, O.D.C. Afrange, H.P. Lorz, and R. Carli: Ironmaking Steelmaking, 2000, vol. 27, pp. 238-42.
A. Vartiainen: Sulfide Smelting ‘98, 1998, pp. 363–71.
E.J. Jung, W. Kim, I. Sohn, and D.J. Min: J. Mater. Sci., 2010, vol. 45, pp. 2023-29.
W.H. Kim, I. Sohn, and D.J. Min: Steel Res. Int., 2010, vol. 81, pp. 735-41.
B.O. Mysen, D. Virgo, and C.M. Scarfe: Am. Mineral., 1980, vol. 65, pp. 690-710.
I. Mihailova and D. Mehandjiev: J. Univ. Chem. Tech. Metall., vol. 45, no. 3, 2010, pp. 317-26.
A.M. Hofmeister: Phys. Chem. Miner., 1997, vol. 24, pp. 535-46.
G.H. Kaiura, J.M. Toguri, and G. Marchant: Can. Metall. Q., 1977, vol. 16, pp. 156-60.
M. Kucharski, N.M. Stubina, and J.M. Toguri: Can. Metall. Q., 1989, vol. 28, pp. 7-11.
Acknowledgments
This study was supported partially by the Brain Korea 21 (BK21) Project at the Division of the Humantronics Information Materials, LS-Nikko Copper Inc., the National Science Foundation of Korea Project No.2010-8-0581, and the Ministry of Knowledge Education Project No.2010-8-0972. Special appreciation is given to Professor D.J. Min for his continued support and helpful comments.
Author information
Authors and Affiliations
Corresponding author
Additional information
Manuscript submitted November 27, 2010.
Rights and permissions
About this article
Cite this article
Park, HS., Park, S.S. & Sohn, I. The Viscous Behavior of FeOt-Al2O3-SiO2 Copper Smelting Slags. Metall Mater Trans B 42, 692–699 (2011). https://doi.org/10.1007/s11663-011-9512-7
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11663-011-9512-7