Abstract
The wetting behavior of Sn0.3Ag0.7Cu (wt pct) with the addition of Ti on alumina was studied at 1273 K (1000 °C) using the sessile drop method. The wettability of Sn0.3Ag0.7Cu is significantly enhanced with the addition of Ti. Ti accumulates on the interface and reacts with O, producing TiO and yields good wetting. However, wetting is inhibited in high Ti containing droplets as intense Ti-Sn reactions take place. As a result of these competing reactions, the wettability of Sn0.3Ag0.7Cu-2Ti is the best, with the lowest equilibrium contact angle 24.6 deg. Thermodynamic calculations indicate that the value of the final contact angle cos θ varies linearly with Ti fraction in the Ti-Sn reaction-free case. The influence of the Ti-Sn reaction on wetting is quantitatively characterized by the deviation from the theoretical data. The adverse impact of Ti-Sn reaction on wetting increases in intensity with the droplets containing more Ti as the reaction between Ti and Sn becomes more intense and rapid. Alumina/alumina is brazed using different Ti containing Sn0.3Ag0.7Cu-Ti brazing metals at 1273 K (1000 °C) for 25 minutes. Pores are observed in joints prepared with Sn0.3Ag0.7Cu-0.7, 3, and 4Ti because of poor wettability. The highest joints shear strength of 28.6 MPa is obtained with Sn0.3Ag0.7Cu-2Ti.
Similar content being viewed by others
References
Laixin Shi, Ping Shen, Dan Zhang and Qichuan Jiang, Appl. Surf. Sci. 2011, vol. 257, pp. 10743-10747.
Tuan Zaharinie, Raza Moshwan, Farazila Yusof, M. Hamdi and Tadashi Ariga, Mater. Des. 2014, vol. 54, pp. 375-381.
O. Kozlova, R. Voytovych and N. Eustathopoulos, Scripta Mater. 2011, vol. 65, pp. 13-16.
Sixing Liu, Bing Xiao, Haozhong Xiao, Longhui Meng, Ziyu Zhang and Hengheng Wu, Surf. Coat. Technol. 2016, vol. 286, pp. 376-382.
Longlong Yang, Ping Shen, Qiaoli Lin, Feng Qiu and Qichuan Jiang, Appl. Surf. Sci. 2011, vol. 257, pp. 6276-6281.
Weiyuan Yu, Senhui Liu, Xinya Liu, Minpen Liu and Weigang Shi, J. Mater. Process. Technol. 2015, vol. 221, pp. 285-290.
J. Martinez Fernandez, R. Asthana, M. Singh and F. M. Valera, Ceram. Int. 2016, vol. 42, pp. 5447-5454.
Gang Wang, Ping Xiao, Zhongjia Huang and Rujie He, Ceram. Int. 2016, vol. 42, pp. 5130-5135.
Nicolas Eustathopoulos, Curr. Opin. Solid State Mater. Sci. 2005, vol. 9, pp. 152-160.
R. Voytovych, F. Robaut and N. Eustathopoulos, Acta Mater. 2006, vol. 54, pp. 2205-2214.
Wenwen Li, Bo Chen, Huaping Xiong, Wenjiang Zou and Haishui Ren, J. Eur. Ceram. Soc. 2017, vol. 37, pp. 3849-3859.
Y. Y. Song, H. L. Li, H. Y. Zhao, D. Liu, X. G. Song and J. C. Feng, Vacuum 2017, vol. 141, pp. 116-123.
Majed Ali, Kevin M. Knowles, Phillip M. Mallinson and John A. Fernie, Acta Mater. 2015, vol. 96, pp. 143-158.
Ashutosh Sharma, Heung-Rak Sohn and Jae Pil Jung, Metall. Mater. Trans. A 2015, vol. 47, pp. 494-503.
Laurent Gremillard, Eduardo Saiz, Velimir R Radmilovic and Antoni P Tomsia, J. Mater. Res. 2006, vol. 21, pp. 3222-3233.
E. Saiz, R. M. Cannon and A. P. Tomsia, Acta Mater. 2000, vol. 48, pp. 4449-4462.
W. Fu, X. G. Song, S. P. Hu, J. H. Chai, J. C. Feng and G. D. Wang, Mater. Des. 2015, vol. 87, pp. 579-585.
W. Fu, X. G. Song, Y. X. Zhao, J. Cao, J. C. Feng, C. Jin and G. D. Wang, Mater. Des. 2017, vol. 115, pp. 1-7.
Hugo Ricardo Zschommler Sandim, Bruno Vieira Morante and Paulo Atsushi Suzuki, Mater. Res-ibero-Am J. 2005, vol. 8, pp. 293-297.
Ping Shen, Yi Wang, Lihua Ren, Shixin Li, Yuhua Liu and Qichuan Jiang, Appl. Surf. Sci. 2015, vol. 355, pp. 930-938.
O. Dezellus, F. Hodaj and N. Eustathopoulos, Acta Mater. 2002, vol. 50, pp. 4741-4753.
P. Kritsalis, L. Coudurier and N. Eustathopoulos, J. Mater. Sci. 1991, vol. 26, pp. 3400-3408.
L. X. Cheng, M. R. Liu, X. Q. Wang, B. H. Yan and G. Y. Li, Mater. Sci. Eng. A 2017, vol. 680, pp. 317-323.
M. Gelbstein, N. Froumin and N. Frage, Mater. Sci. Eng. A 2008, vol. 495, pp. 159-163.
John A. Dean and Norbert Adolph Lange: Lange’s handbook of chemistry. (McGraw-Hill, New York, 1992).
A. B. D. Cassie, Discussions of the Faraday Society 1948, vol. 3, pp. 11-16.
Acknowledgments
This project is supported by the National Natural Science Foundation of China (Grant No. 51775138, 51505105, and U1537206) and International Science & Technology Cooperation Program of China (No. 2015DFA50470).
Author information
Authors and Affiliations
Corresponding author
Additional information
Manuscript submitted June 1, 2017.
Rights and permissions
About this article
Cite this article
Kang, J.R., Song, X.G., Hu, S.P. et al. Wetting and Brazing of Alumina by Sn0.3Ag0.7Cu-Ti Alloy. Metall Mater Trans A 48, 5870–5878 (2017). https://doi.org/10.1007/s11661-017-4371-8
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11661-017-4371-8