Abstract
The microstructure and strength at 1473 and 2073 K and creep properties at 2073 K were investigated in three Ir-Nb-Zr alloys with the fcc and L12 two-phase structure. The microstructure and lattice misfit were investigated using scanning electron microscopy (SEM), transmission electron microscopy (TEM), and X-ray diffractometry (XRD). Compression and creep tests were performed, and their deformation structures were observed using SEM and TEM. At 1473 K, the strength of the Ir-Nb-Zr alloys was higher than that of the binary Ir-Nb and Ir-Zr alloys, but they were almost equivalent at 2073 K. However, the ternary alloys showed great improvement on creep at 2073 K. The time for the 2 pct creep strain of the Ir-Nb-Zr alloy was about 100 hours, while it was 1 hour for the binary alloys. The deformation mechanisms for compressive strength and creep resistance in these Ir-Nb-Zr alloys are discussed in terms of the deformation structure.
Similar content being viewed by others
References
N. Tanatsugu, T. Sato, Y. Naruo, T. Kashiwagi, T. Mizutani, T. Monji, and K. Hamabe: Acta Astronautica, 1997, vol. 40, pp. 165–70.
N.S. Stoloff: in Superalloys II, C.T. Sims, N.S. Stoloff, and W.C. Hagel, eds., John Willey & Sons, New York, NY, 1987.
Y. Yamabe, Y. Koizumi, H. Murakami, Y. Ro, T. Maruko, and H. Harada: Scripta Mater., 1996, vol. 35(2), pp. 211–15.
Y. Yamabe-Mitarai, Y. Ro, T. Maruko, and H. Harada: Metall. Mater. Trans. A, 1998, vol. 29A, pp. 537–49.
Y. Yamabe-Mitarai, Y. Ro, S. Nakazawa, T. Maruko, and H. Harada: Def. Diffus. Forum, 2001, vols. 188–190, pp. 171–84.
Y. Yamabe-Mitarai, S. Nakazawa, and H. Harada: Scripta Mater., 2000, vol. 43, pp. 1059–64.
Y. Yamabe-Mitarai, S. Nakazawa, and H. Harada: JSME Int. J. Ser. A, 2002, vol. 45(1), pp. 2–7.
A.M. Gyurko and J.M. Sanchez: Mater. Sci. Eng. A, 1993, vol. 170, pp. 169–75.
G.A. Miller: Master’s Thesis, University of Texas at Austin, Austin, TX, 1994.
C.A. Freitas and J.M. Sanchez: Proc. THERMEC ’97, TMS, Warrendale, PA, 1997, pp. 1567–73.
Y. Yamabe-Mitarai and H. Harada: J. Alloy and Comp., in press.
Y. Yamabe-Mitarai and H. Harada: Phil. Mag. Lett., 2002, vol. 82(3), pp. 109–18.
Y. Yamabe-Mitarai and H. Harada: Mater. Sci. Eng. A, in press.
Y. Yamabe-Mitarai and H. Harada: unpublished research, 2001.
T.M. Pollock and A.S. Argon: Acta Metall. Mater., 1992, vol. 40(1), pp. 1–30.
S. Tian, J. Zhang, X. Wu, H. Yang, Y. Xu, and Z. Hu: Metall. Mater. Trans. A, 2001, vol. 32A, pp. 2947–57.
R.D. Field, T.M. Pollock, and W.H. Murphy: Superalloys 1992, 1992, pp. 57–66.
A. Lasalmonie and J.L. Strudel: Phil. Mag., 1976, vol. 32(5), pp. 937–49.
M.V. Natahl, R.A. Mackay, and R.V. Miner: Metall. Trans. A, 1989, vol. 20A, pp. 133–41.
Y.F. Gu, Y. Yamabe-Mitarai, S. Nakazawa, and H. Harada: Scripta Mater., 2002, vol. 46, pp. 137–42.
Y. Yamabe-Mitarai, S. Nakazawa, and H. Harada: Material Science Forum, in press.
Y.F. Gu, Y. Yamabe-Mitarai, Y. Ro, and H. Harada: Key Eng. Mater., 2000, vols. 171–174, pp. 669–76.
Author information
Authors and Affiliations
Additional information
This article is based on a presentation made in the symposium entitled “Fundamentals of Structural Intermetallics,” presented at the 2002 TMS Annual Meeting, February 21–27, 2002, in Seattle, Washington, under the auspices of the ASM and TMS Joint Committee on Mechanical Behavior of Materials.
Rights and permissions
About this article
Cite this article
Yamabe-Mitarai, Y., Gu, Y. & Harada, H. Compressive strength and creep properties of Ir-Nb-Zr alloys between 1473 and 2073 K. Metall Mater Trans A 34, 2207–2215 (2003). https://doi.org/10.1007/s11661-003-0284-9
Issue Date:
DOI: https://doi.org/10.1007/s11661-003-0284-9