Skip to main content
Log in

Detailed analysis of the flow in the inducer of a transonic centrifugal compressor

  • Published:
Journal of Thermal Science Aims and scope Submit manuscript

Abstract

Numerical and experimental investigations were conducted in a transonic centrifugal compressor stage composed of a backswept splittered unshrouded impeller and a vaned diffuser. A detailed analysis of the flow in the inducer (i.e. the entry zone of the impeller between the main blade leading edge and the splitter blade leading edge) is proposed from choke to surge. Steady and unsteady simulations were performed using the code elsA, which uses a multi-domain approach on structured meshes and solves the compressible RANS equations, associated with a two-equation turbulence model k-l in the rotating frame of reference. The 1MW LMFA-ECL test rig was used for carrying out the tests in the compressor stage. Unsteady pressure measurements up to 150 kHz and Laser Doppler Anemometry measurements were performed in the inducer. A good agreement is obtained between the experimental and numerical data even if an over dissipation is noticed in the numerical results. The change in flow pattern from choke to surge is mainly due to a change in the tip leakage flow trajectory which straightens, leading to a flow blockage of an individual passage near shroud. A spectral analysis shows that only the blade passing frequency and its harmonics compose the various spectra obtained from choke to surge.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. Moore, F. K. and Greitzer, E. M., 1986a, “A Theory of Post-Stall Transients in Axial Compression Systems: Part 1-Development Equations”, ASME Journal of Engineering for Gas Turbines and Power, Vol. 108, pp. 68–76.

    Article  Google Scholar 

  2. Moore, F. K. and Greitzer, E. M., 1986b, “A Theory of Post-Stall Transients in Axial Compression Systems: Part 2-Application”, ASME Journal of Engineering for Gas Turbines and Power, Vol. 108, pp. 231–239.

    Article  Google Scholar 

  3. Camp, T. R. and Day, I. J., 1998, “A Study of Spike and Modal Stall Phenomena in a Low-Speed Axial Compressor”, ASME Journal of Turbomachinery, Vol. 120, pp. 393–401.

    Article  Google Scholar 

  4. Outa, E., Kato, D. and Chiba, K., 1994, “A N-S Simulation of Stall cell Behavior in a 2-D Compressor Rotor-Stator System at Various Loads”, ASME paper 94-GT-257.

  5. Vo, H. D., Tan C. S.and Greitzer, E. M., 2005, “Criteria for Spike Initiated Rotating Stall”, ASME Paper GT 2005-68374.

  6. Justen, F., Ziegler, K. U. and Gallus, H. E., 1999, “Experimental Investigation of Unsteady Flow Phenomena in a Centrifugal Compressor vaned Diffuser of Variable Geometry”, Journal of Turbomachinery, Vol. 121, pp. 763–771.

    Article  Google Scholar 

  7. Spakovszky, Z. S. and Roduner, C. H., 2009, “Spike and Modal Stall Inception in an Advanced Turbocharger Centrifugal Compressor”, Journal of Turbomachinery, 2009, Vol. 131, pp. 1–9.

    Article  Google Scholar 

  8. Trébinjac, I., Bulot, N., Ottavy, X. and Buffaz, N., 2011, “Surge Inception in a Transonic Centrifugal Compressor Stage”, Proceedings of ASME Turbo-expo 2011: Power for Land, Sea and Air, Vancouver, British Columbia, GT 2011-45116.

  9. Hayami, H., Sawae, M., Nakamura, T., and Kawaguchi, N., 1993, “Blade Loading and Shock Wave in a Transonic Circular Cascade Diffuser”, Journal of Turbomachinery, Vol. 115, pp. 560–564.

    Article  Google Scholar 

  10. Bonaiuti, D., Armone, A., Hah, C. and Hayami, H., 2002, “Development of Secondary Flow Field in a Low Solidity Diffuser in a Transonic Centrifugal Compressor Stage”, Proceedings of the International Gas Turbine Institute, Amsterdam, Netherlands.

  11. Trébinjac, I., Bulot, N. and Buffaz, N., 2011, “Analysis of the Flow in a Transonic Centrifugal Compressor Stage from Choke to Surge”, Proceedings of the 9th European Conference on Turbomachinery, (ETC-9), Istanbul, Turkey, March 2011.

  12. Bulot, N., Trébinjac, I., Ottavy, X., Kulisa, P., Haltier, G., Paoletti, B. and Krikorian, P., 2009, “Experimental and Numerical Investigation of the Flow Field in a High Pressure Centrifugal Compressor Impeller Near Surge”, IMechE Journal of Power and Energy, Vol. 223,Number 6, pp 657–666.

    Article  Google Scholar 

  13. Bulot, N, Ottavy, X. and Trébinjac, I, 2010, “Unsteady Pressure Measurements in a High-Speed Centrifugal Compressor”, Journal of Thermal Science, Vol.19, No1, pp 1–8.

    Article  Google Scholar 

  14. Rochuon, N., 2007, “Analyse de l’écoulement tridimensionnel instationnaire dans un compresseur centrifuge à fort taux de pression”, PhD thesis, Ecole Centrale de Lyon.

  15. Trébinjac, I., Kulisa, P., Bulot N. and Rochuon N., 2009 “Effect of the Unsteadiness on the Performance of a Transonic Centrifugal Compressor Stage” J. Turbomachinery., October 2009, Vol. 131,Issue 4, 041011, 9 pages.

  16. Ibaraki, S., Sumida, K. and Suita, T., 2009, “Design and Off-Design of a Transonic Centrifugal Compressor Impeller”, Proceedings of ASME Turbo-expo 2009: Power for Land, Sea and Air, Orlando, Florida, USA, GT 2009-59516

  17. Senoo, Y., Hayami, H., Kinoshita, Y. and Yamasaki, H., 1979, “Experimental Study on the Flow in a Supersonic Centrifugal Impeller”, Journal of Engineering Power, January 1979, Vol. 101, pp 32–39

    Article  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Buffaz, N., Trébinjac, I. Detailed analysis of the flow in the inducer of a transonic centrifugal compressor. J. Therm. Sci. 21, 1–12 (2012). https://doi.org/10.1007/s11630-012-0513-x

Download citation

  • Received:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11630-012-0513-x

Keywords

Navigation