Abstract
This paper introduces a novel flat plate solar collector (FPC) using micro heat pipe array (MHPA) as a key element. To analyze the thermal transfer behavior of flat plate solar collector with micro heat pipe array (MHPA-FPC), an indoor experiment for thermal transfer characteristic of MHPA applied to FPC was conducted by using an electrical heating film to simulate the solar radiation. Different cooling water flow rates, cooling water temperatures, slopes, and contact thermal resistances between the condenser of MHPA and the heat exchanger were tested at different heating powers. The experimental results indicate that MHPA-FPC exhibits the enhanced heat transfer capability with increased cooling water flow rate and temperature. Total thermal resistance has a maximum decline of approximately 10% when the flow rate increases from 180 L h−1 to 360 L h−1 and 38% when the cooling water temperature increases from 20°C to 40°C. When the inclination angle of MHPA-FPC exceeds 30°, the slope change has a negligible effect on the heat transfer performance of MHPA-FPC. In addition, contact thermal resistance significantly affects the heat transfer capability of MHPA-FPC. The total thermal resistances lowers to nearly half of the original level when contact material between the condenser of MHPA and the heat exchanger changes from conductive silicone to conductive grease. These results could provide useful information for the optimal design and operation of MHPA-FPC.
Similar content being viewed by others
References
Hussein H M S, Mohamad M A, El-Asfouri A S. Transient investigation of a thermosyphon flat-plate solar collector. Appl Therm Eng, 1999, 19: 789–800
Hussein H M S, Mohamad M A, El-Asfouri A S. Optimization of a wickless heat pipe flat plate solar collector. Energ Convers Manage, 1999, 40: 1949–1961
Nada S A, El-Ghetany H H, Hussein H M S. Performance of a two-phase closed thermosyphon solar collector with a shell and tube heat exchanger. Appl Therm Eng, 2004, 24: 1959–1968
Hussein H M S, El-Ghetany H H, Nada S A. Performance of wickless heat pipe flat plate solar collectors having different pipes cross sections geometries and filling ratios. Energ Convers Manage, 2006, 47: 1539–1549
Hussein H M S. Theoretical and experimental investigation of wickless heat pipes flat solar collector with cross flow heat exchanger. Energ Convers Manage, 2007, 48: 1266–1272
Emmanouil M, Vassilis B. A new heat-pipe type solar domestic hot water system. Sol Energy, 2002, 47: 13–20
Samuel L A, Sergio C. An experimental study of two-phase closed thermosyphons for compact solar domestic hot-water systems. Sol Energy, 2004, 76: 141–145
Esen M, Esen H. Experimental investigation of a two-phase closed thermosyphon solar water heater. Sol Energy, 2005, 79(5): 459–468
Riffat S B, Zhao X, Doherty P S. Developing a theoretical model to investigate thermal performance of a thin membrane heat-pipe solar collector. Appl Therm Eng, 2005, 25: 899–915
Rittidech S, Wannapakne S. Experimental study of the performance of a solar collector by closed-end oscillating heat pipe (CEOHP). Appl Therm Eng, 2007, 27: 1978–1985
Azad E. Theoretical and experimental investigation of heat pipe solar collector. Exp Therm Fluid Sci, 2008, 32: 1666–1672
Azad E. Performance analysis of wick-assisted heat pipe solar collector and comparison with experimental results. Heat Mass Trans, 2009, 45: 645–649
Azad E. Assessment of three types of heat pipe solar collectors. Renew Sust Energ Rev, 2012, 16: 2833–2838
Xiao L, Wu S Y, Zhang Q L. Theoretical investigation on thermal performance of heat pipe flat plate solar collector with cross flow heat exchanger. Heat Mass Trans, 2012, 48: 1167–1176
Qu J, Wu H Y. Flow visualization of silicon-based micro pulsating heat pipes. Sci China Tech Sci, 2010, 53: 984–990
Wang N H, Burger J, Luo F. Operation characteristics of AMS-02 loop heat pipe with bypass valve. Sci China Tech Sci, 2011, 54: 1813–1819
Lefevre F, Conrardy J B, Raynaud M. Experimental investigations of flat plate heat pipes with screen meshes or grooves covered with screen meshes as capillary structure. Appl Therm Eng, 2012, 37: 95–102
Zhao Y H, Diao Y H, Zhang K R. China Patent (in Chinese), CN 200910078903A 20090227, 2009
Zhao Y H, Diao Y H, Zhang K R. China Patent (in Chinese), CN200810116295, 2008
Du S Y, Zhao Y H. New boundary conditions for the evaporating thin-film model in a rectangular micro channel. Int J Heat Mass Trans, 2011, 54: 3694–3701
Zhao Y H, Wang H Y, Diao Y H, et al. Heat transfer characteristics of flat micro-heat pipe array (in Chinese). CIESC J, 2011, 62: 336–343
Deng Y C, Quan Z H, Zhao Y H, et al. Performance experiments for flat plate solar water heater based on micro heat pipe array (in Chinese). Trans CSAE, 2013, 29: 222–228
GB/T 6424-2007, Flat Plate Solar Collectors (in Chinese)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Deng, Y., Quan, Z., Zhao, Y. et al. Experimental investigations on the heat transfer characteristics of micro heat pipe array applied to flat plate solar collector. Sci. China Technol. Sci. 56, 1177–1185 (2013). https://doi.org/10.1007/s11431-013-5204-7
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11431-013-5204-7