Skip to main content
SpringerLink
Log in

Enabling landings on irregular surfaces for unmanned aerial vehicles via a novel robotic landing gear

  • Original Research Paper
  • Published:
Intelligent Service Robotics Aims and scope Submit manuscript

Abstract

Unmanned aerial vehicles (UAVs) have been attracting much attention and changing our daily lives. Recent technological advances in the development of UAVs have drastically increased both their general capabilities and areas of application. Among many others, one of the areas that benefits immediately from using UAVs could be remote inspection, since they can provide an alternative means of access to structures and collect data from locations difficult to reach for human inspectors. Lately, wall-climbing UAVs outfitted with contact-type sensors have been proposed to collect data for the periodic inspection and maintenance of buildings. However, the major drawback is that they can be used only for flat surfaces. In this paper, we present a lightweight robotic landing gear for enabling UAVs to land on irregular surfaces, without affecting the on-board flight control system that keeps the UAV in level flight during the entire mission. Our novel design uses a vacuum system for robotic landing gear to attach to the surface, and the movable counterweight composed of a vacuum motor and other control components to balance the flight. To lighten the total weight of UAV, the proposed robotic landing gear system has only one servo motor for gear operation and a passive mechanical structure that guides the vacuum suction cup at the frontal robotic legs to adapt to different shapes of surfaces. We present details of a prototype mechanism and landing experimental results under different scenarios generated within our laboratory environment.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12

Similar content being viewed by others

References

  1. Albers A, Trautmann S, Howard T, Nguyen TA, Frietsch M, Sauter C (2010) Semi-autonomous flying robot for physical interaction with environment. In: 2010 IEEE conference on robotics, automation and mechatronics, pp 441–446. IEEE

  2. Bass J, Desbiens AL (2020) Improving multirotor landing performance on inclined surfaces using reverse thrust. IEEE Robot Autom Lett 5(4):5850–5857. https://doi.org/10.1109/LRA.2020.3010208

    Article  Google Scholar 

  3. Bisht R.S, Alexander S.J (2013) Mobile robots for periodic maintenance and inspection of civil infrastructure: a review. In: International conference on machines and mechanisms, pp 1050–1057

  4. Dethe RD, Jaju S (2014) Developments in wall climbing robots: a review. Int J Eng Res Gen Sci 2(3):p33-42

    Google Scholar 

  5. Gago J, Douthe C, Coopman R, Gallego P, Ribas-Carbo M, Flexas J, Escalona J, Medrano H (2015) Uavs challenge to assess water stress for sustainable agriculture. Agricult Water Manag 153:9–19

    Article  Google Scholar 

  6. Gómez-Candón D, De Castro A, López-Granados F (2014) Assessing the accuracy of mosaics from unmanned aerial vehicle (uav) imagery for precision agriculture purposes in wheat. Precis Agricult 15(1):44–56

    Article  Google Scholar 

  7. González-deSantos LM, Martínez-Sánchez J, González-Jorge H, Arias P (2020) Active uav payload based on horizontal propellers for contact inspections tasks. Measurement 165:108106

    Article  Google Scholar 

  8. Hallermann N, Morgenthal G (2014) Visual inspection strategies for large bridges using unmanned aerial vehicles (uav). In: Proceedings of 7th IABMAS, international conference on bridge maintenance, safety and management, pp 661–667

  9. Ichikawa A, Abe Y, Ikeda T, Ohara K, Kishikawa J, Ashizawa S, Oomichi T, Okino A, Fukuda T (2017) Uav with manipulator for bridge inspection-hammering system for mounting to uav. In: 2017 IEEE/SICE international symposium on system integration (SII), pp 775–780. IEEE

  10. Ikeda T, Yasui S, Fujihara M, Ohara K, Ashizawa S, Ichikawa A, Okino A, Oomichi T, Fukuda T (2017) Wall contact by octo-rotor uav with one dof manipulator for bridge inspection. In: 2017 IEEE/RSJ international conference on intelligent robots and systems (IROS), pp 5122–5127. IEEE

  11. Iwamoto T, Enaka T, Tada K (2017) Development of testing machine for tunnel inspection using multi-rotor uav. J Phys Conf Ser 842:012068

    Article  Google Scholar 

  12. Jarman M, Vesey J, Febvre P (2016) Unmanned aerial vehicles (uavs) for uk agriculture: creating an invisible precision farming technology. White Paper, July

  13. Jimenez-Cano A, Heredia G, Ollero A (2017) Aerial manipulator with a compliant arm for bridge inspection. In: 2017 international conference on unmanned aircraft systems (ICUAS), pp 1217–1222. IEEE

  14. Jung S, Shin J.U, Myeong W, Myung H (2015) Mechanism and system design of mav (micro aerial vehicle)-type wall-climbing robot for inspection of wind blades and non-flat surfaces. In: 2015 15th international conference on control, automation and systems (ICCAS), pp 1757–1761. IEEE

  15. Kamel M, Verling S, Elkhatib O, Sprecher C, Wulkop P, Taylor Z, Siegwart R, Gilitschenski I (2018) Voliro: an omnidirectional hexacopter with tiltable rotors. arXiv:1801.04581

  16. Mahmood S, Bakhy S, Tawfik M (2021) Propeller-type wall-climbing robots: a review. IOP Conf Ser Mater Sci Eng 1094:012106

    Article  Google Scholar 

  17. Myeong W, Jung S, Yu B, Chris T, Song S, Myung H (2019) Development of wall-climbing unmanned aerial vehicle system for micro-inspection of bridges. In: 2019 international conference on robotics and automation (ICRA). IEEE

  18. Myeong W, Myung H (2018) Development of a wall-climbing drone capable of vertical soft landing using a tilt-rotor mechanism. IEEE Access 7:4868–4879

    Article  Google Scholar 

  19. Myeong WC, Jung KY, Jung SW, Jung Y, Myung H (2015) Development of a drone-type wall-sticking and climbing robot. In: 2015 12th international conference on ubiquitous robots and ambient intelligence (URAI), pp 386–389. IEEE

  20. Paul H, Miyazaki R, Ladig R, Shimonomura K (2019) Landing of a multirotor aerial vehicle on an uneven surface using multiple on-board manipulators. In: 2019 IEEE/RSJ international conference on intelligent robots and systems (IROS), pp 1926–1933. IEEE

  21. Pope MT, Kimes CW, Jiang H, Hawkes EW, Estrada MA, Kerst CF, Roderick WR, Han AK, Christensen DL, Cutkosky MR (2016) A multimodal robot for perching and climbing on vertical outdoor surfaces. IEEE Trans Robot 33(1):38–48

    Article  Google Scholar 

  22. Ratsamee P, Kriengkomol P, Arai T, Kamiyama K, Mae Y, Kiyokawa K, Mashita T, Uranishi Y, Takemura H (2016) A hybrid flying and walking robot for steel bridge inspection. In: 2016 IEEE international symposium on safety, security, and rescue robotics (SSRR), pp 62–67. IEEE

  23. Ridao P, Carreras M, Ribas D, Garcia R (2010) Visual inspection of hydroelectric dams using an autonomous underwater vehicle. J Field Robot 27(6):759–778

    Article  Google Scholar 

  24. Sanchez-Cuevas PJ, Ramon-Soria P, Arrue B, Ollero A, Heredia G (2019) Robotic system for inspection by contact of bridge beams using uavs. Sensors 19(2):305

    Article  Google Scholar 

  25. Song YK, Lee CM, Koo IM, Tran DT, Moon H, Choi HR (2008) Development of wall climbing robotic system for inspection purpose. In: 2008 IEEE/RSJ international conference on intelligent robots and systems, pp 1990–1995. IEEE

  26. Tsukagoshi H, Watanabe M, Hamada T, Ashlih D, Iizuka R (2015) Aerial manipulator with perching and door-opening capability. In: 2015 IEEE international conference on robotics and automation (ICRA), pp 4663–4668. IEEE

  27. Watanabe K, Nakatsuka T, Nagai I (2018) Production of a wall-climbing-type quadrotor and its experiment for verifying basic operations. In: 2018 IEEE international conference on mechatronics and automation (ICMA), pp 1850–1855. IEEE

Download references

Acknowledgements

This material is based upon work supported by the U.S. Air Force Office of Scientific Research under AFOSR/AOARD FA2386-20-1-4019 Grant.

Author information

Authors and Affiliations

  1. School of Information Science, Japan Advanced Institute of Science and Technology, Nomi, Ishikawa, 923-1292, Japan

    TsungHsuan Huang, Armagan Elibol & Nak Young Chong

Authors
  1. TsungHsuan Huang
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Armagan Elibol
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Nak Young Chong
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to TsungHsuan Huang.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

In the original publication, the first author’s name was incorrect and this has been corrected.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Huang, T., Elibol, A. & Chong, N.Y. Enabling landings on irregular surfaces for unmanned aerial vehicles via a novel robotic landing gear. Intel Serv Robotics 15, 231–243 (2022). https://doi.org/10.1007/s11370-022-00420-y

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11370-022-00420-y

Keywords

Mathematics Subject Classification

Search

Navigation