Abstract
This paper extends traditional wheel–soil modeling for lightweight mobile robots operating with smooth wheels on dry sandy soil to capture the transient oscillations that have been observed in drawbar pull measurements. To model these drawbar pull fluctuations, a new dynamic pressure–sinkage relationship was extrapolated from the literature and experimental observations of smooth rigid wheels operating in sandy soil. The resulting two-dimensional high-fidelity analytical model was validated with a unique single-wheel testbed designed from a Blohm Planomat 408 computer-numerically-controlled creep-feed grinding machine. For the experimental conditions used in this research, the resulting model is able to predict the fluctuating values of the drawbar pull for a variety of slip ratios and normal loads tested with a smooth rigid wheel in sandy soil. The new model was tuned at a single normal load over a variety of slip ratios and was then able to predict the amplitude and frequency of the oscillations about the mean drawbar pull at different normal loads and slip ratios.
Similar content being viewed by others
References
Apostolopoulos, D., Wagner, M., Heys, S., Teza, J.: Results of the inflatable robotic rover testbed. Tech. Rep. CMU-RI-TR-03-18, Carnegie Mellon University (2003)
Arvidson, R., Bell III, J., Bellutta, P., Cabrol, N., Catalano, J., Cohen, J., Crumpler, L., Des Marais, D., Estlin, T., Farrand, W., et al.: Spirit Mars Rover Mission: overview and selected results from the northern Home Plate Winter Haven to the side of Scamander crater. J. Geophys. Res 115, 1–19 (2010)
Bauer, R., Leung, W., Barfoot, T.: Experimental and simulation results of wheel–soil interaction for planetary rovers. In: 2005 IEEE/RSJ International Conference on Intelligent Robots and Systems (IROS 2005), pp. 586–591. IEEE (2005)
Bekker, M.: Introduction to Terrain-Vehicle Systems. University of Michigan Press, Ann Arbor (1969)
Fervers, C.: Improved fem simulation model for tire-soil interaction. J. Terramechs. 41(2–3), 87–100 (2004)
Hambleton, J., Drescher, A.: Development of improved test rolling methods for roadway embankment construction. Final Report MN/RC 2008-08, University of Minnesota. Dept. of Civil Engineering (2008)
Hegedus, E.: A simplified method for the determination of bulldozing resistance. Land Locomotion Research Laboratory, Army TankAutomotive Command Report, 61 (1960)
Holtz, R., Kovacs, W.: An Introduction to Geotechnical Engineering, vol. 733. Prentice-Hall (1981)
Iagnemma, K., Kang, S., Shibly, H., Dubowsky, S.: Online terrain parameter estimation for wheeled mobile robots with application to planetary rovers. IEEE Trans. Robot. 20(5), 921–927 (2004)
Iagnemma, K., Shibly, H., Dubowsky, S.: On-line terrain parameter estimation for planetary rovers. In: IEEE International Conference on Robotics and Automation (ICRA’02), vol. 3, pp. 3142–3147. IEEE (2002)
Irani, R., Bauer, R., Warkentin, A.: A dynamic terramechanic model for small lightweight vehicles with rigid wheels and grousers operating in sandy soil. J. Terramechs. 48(4), 307–318 (2011)
Ishigami, G.: Terramechanics-based analysis and control for lunar/planetary exploration robots. Phd, Tohoku University, Department of Aerospace Engineering (2008)
Ishigami, G., Miwa, A., Nagatani, K., Yoshida, K.: Terramechanics-based model for steering maneuver of planetary exploration rovers on loose soil. J. Field Robot. 24(3), 233–250 (2007)
Janosi, Z., Hanamoto, B.: The analytical determination of drawbar pull as a function of slip for tracked vehicle in deformable soils. In: 1st Int. Conf. on Terrain-Vehicle Systems. Torino, Italy (1961)
Khot, L., Salokhe, V., Jayasuriya, H., Nakashima, H.: Experimental validation of distinct element simulation for dynamic wheel–soil interaction. J. Terramechs. 44(6), 429–437 (2007)
Lyasko, M.: LSA model for sinkage predictions. J. Terramechs. 47(1), 1–19 (2010)
Maciejewski, J., Jarzbowski, A.: Experimental analysis of soil deformation below a rolling rigid cylinder. J. Terramechs. 41(4), 223–241 (2004)
Meirion-Griffith, G., Spenko, M.: A modified pressure–sinkage model for small, rigid wheels on deformable terrains. J. Terramechs. 48(2), 149–155 (2011)
Nakashima, H., Fujii, H., Oida, A., Momozu, M., Kawase, Y., Kanamori, H., Aoki, S., Yokoyama, T.: Parametric analysis of lugged wheel performance for a lunar microrover by means of DEM. J. Terramechs. 44(2), 153–162 (2007)
Reece, A.: Principles of soil–vehicle mechanics. Proc. Inst. Mech. Eng. 180(1965), 45–66 (1965)
Shibly, H., Iagnemma, K., Dubowsky, S.: An equivalent soil mechanics formulation for rigid wheels in deformable terrain, with application to planetary exploration rovers. J. Terramechs. 42(1), 1–13 (2005)
Wong, J.: Terramechanics and Off-road Vehicles. Elsevier (1989)
Wong, J.: Theory of Ground Vehicles. Wiley, New York (2001)
Wong, J., Reece, A.: Prediction of rigid wheel performance based on the analysis of soil–wheel stresses part I. Performance of driven rigid wheels. J. Terramechs. 4(1), 81–98 (1967)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Irani, R.A., Bauer, R.J. & Warkentin, A. Dynamic Wheel-Soil Model for Lightweight Mobile Robots with Smooth Wheels. J Intell Robot Syst 71, 179–193 (2013). https://doi.org/10.1007/s10846-012-9777-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10846-012-9777-3