Abstract
To investigate the relationship between macro-plastic behavior and meso-deformation mechanism of Mg alloy AZ31, the mathematical models for various deformation mechanisms of slip, twinning and detwinning are established, respectively. Furthermore, in order to capture the Bauschinger effect under cyclic loading, the back stress is introduced into the three independent deformation mechanisms, respectively. Finally, using the above-mentioned model, a new cyclic plastic constitutive model based on the constitutive theory of crystal deformation for magnesium alloy is established. On this basis, the numerical simulation for AZ31 under cyclic loading with the axial strain amplitude of 1.2% is carried out in accordance with the aforementioned crystal plasticity theory associated with the representative volume element model. The comparison between the stress–strain curves obtained from the simulation and the experiments shows that the macroscopic mechanical responses predicted using the proposed model are in good agreement with the experimental results. In particular, the unique characteristics of cyclic macro-plastic behavior observed in the experiments can be satisfactorily captured by the presented crystal plasticity model. At the mesoscale, these features are caused by the alternate occurrence of twinning and detwinning mechanisms. The further analysis of meso-plastic behavior shows that there are heterogeneous distributions of twinning, stress–strain and stress triaxiality in polycrystal under cyclic loading.
Similar content being viewed by others
Change history
22 November 2018
In all the articles in Acta Mechanica Solida Sinica, Volume 31, Issues 1–4, the copyright is incorrectly displayed as “The Chinese Society of Theoretical and Applied Mechanics and Technology ” where it should be “The Chinese Society of Theoretical and Applied Mechanics”.
References
Yin SM, Yang HJ, Li SX, Wu SD, Yang F. Cyclic deformation behavior of as-extruded Mg-3%Al-1%Zn. Scr Mater. 2008;58(9):751–4.
Lee CA, Lee MG, Seo OS, Nguyen NT, Kim JH, Kim HY. Cyclic behavior of AZ31B Mg: experiments and non-isothermal forming simulations. Int J Plast. 2015;75:39–62.
Lee SY, Gharghouri MA. Pseudoelastic behavior of magnesium alloy during twinning-dominated cyclic deformation. Mater Sci Eng A. 2013;572(10):98–102.
Morrow B, McCabe R, Cerreta E, Tomé C. In-situ TEM observation of twinning and detwinning during cyclic loading in Mg. Metall Mater Trans A. 2014;45:36–40.
Yu Q, Wang J, Jiang Y. Inverse slip accompanying twinning and detwinning during cyclic loading of magnesium single crystal. J Mater. 2013;2013:1–8.
Dong S, Yu Q, Jiang Y, Dong J, Wang F, Ding W. Electron backscatter diffraction observations of twinning–detwinning evolution in a magnesium alloy subjected to large strain amplitude cyclic loading. Mater Des. 2015;65:762–5.
Lou XY, Li M, Boger RK, Agnew SR, Wagoner RH. Hardening evolution of AZ31B Mg sheet. Int J Plast. 2007;23(1):44–86.
Caceres C, Sumitomo T, Veidt M. Pseudoelastic behaviour of cast magnesium AZ91 alloy under cyclic loading–unloading. Acta Mater. 2003;51(20,8):6211–8.
Keshavarz Z, Barnett MR. In-situ investigation of twinning behavior in Mg-3Al-1Zn. In: Neelameggham NR, Kaplan HI, Powell BR, editors. Magnesium Technology 2005. San Francisco, California, USA: TMS; 2005. p. 171–5.
Kleiner S, Uggowitzer P. Mechanical anisotropy of extruded Mg-6%Al-1% Zn alloy. Mater Sci Eng A. 2004;379(1–2):258–63.
Koike J, Fujiyama N, Ando D, Sutou Y. Roles of deformation twinning and dislocation slip in the fatigue failure mechanism of AZ31 Mg alloys. Scr Mater. 2010;63(7):747–50.
Ardeljan M, McCabe RJ, Beyerlein IJ, Knezevic M. Explicit incorporation of deformation twins into crystal plasticity finite element models. Comput Methods Appl Mech Eng. 2015;295(1):396–413.
Knezevic M, Daymond MR, Beyerlein IJ. Modeling discrete twin lamellae in a microstructural framework. Scr Mater. 2016;121:84–8.
Kumar AM, Kanjarla AK, Niezgoda SR, Lebensohn RA, Tomé CN. Numerical study of the stress state of a deformation twin in magnesium. Acta Mater. 2015;84(1):349–58.
Li M, Lou XY, Kim JH, Wagoner RH. An efficient constitutive model for room-temperature, low-rate plasticity of annealed Mg AZ31B sheet. Int J Plast. 2010;26(6):820–58.
Wang H, Wu PD, Tomé CN, Wang J. A constitutive model of twinning and detwinning for hexagonal close packed polycrystals. Mater Sci Eng A. 2012;555(15):93–8.
Qiao H, Agnew SR, Wu PD. Modeling twinning and detwinning behavior of Mg alloy ZK60A during monotonic and cyclic loading. Int J Plast. 2015;65:61–84.
Wang H, Wu PD, Wang J. Modeling inelastic behavior of magnesium alloys during cyclic loading-unloading. Int J Plast. 2013;47:49–64.
Antolovich SD, Armstrong RW. Plastic strain localization in metals: origins and consequences. Prog Mater Sci. 2014;59:1–160.
Hazeli K, Cuadra J, Vanniamparambil PA, Kontsos A. In situ identification of twin-related bands near yielding in a magnesium alloy. Scr Mater. 2013;68(1):83–6.
Chen YP, Cai YY. Simulation of plastic deformation induced texture evolution using the crystallographic homogenization finite element method. Acta Mech Solida Sin. 2017;30(1):51–63.
Hazeli K, Askari H, Cuadra J, Streller F, Carpick RW, Zbib HM, Kontsos A. Microstructure-sensitive investigation of magnesium alloy fatigue. Int J Plast. 2015;68:55–76.
Proust G, Tomé CN, Jain A, Agnew SR. Modeling the effect of twinning and detwinning during strain-path changes of magnesium alloy AZ31. Int J Plast. 2009;25(5):861–80.
Jiang L, Jonas J, Mishra R, Luob AA, Sachdev AK, Godet S. Twinning and texture development in two Mg alloys subjected to loading along three different strain paths. Acta Mater. 2007;55(11):3899–910.
Hutchinson JW. Bounds and self-consistent estimates for creep of polycrystalline materials. Proc R Soc Lond A. 1976;348:101–27.
Pan J, Rice JR. Rate sensitively of plastic flow and implications for yield surface vertices. Int J Solids Struct. 1983;19:973–87.
Yu Q, Wang J, Jiang Y, McCabe RJ, Li N, Tomé CN. Twin–twin interactions in magnesium. Acta Mater. 2014;77(15):28–42.
Khan AS, Pandey A, Gnaupel-Herold T, Mishra RK. Mechanical response and texture evolution of AZ31 alloy at large strains for different strain rates and temperatures. Int J Plast. 2011;27(5):688–706.
Zhang KS, Shi YK, Xu LB, Yu DK. Anisotropy of yielding/hardening and micro-inhomogeneity of deforming/rotating for a polycrystalline metal under cyclic tension-compression. Acta Metall Sin. 2011;47(10):1292–300.
Knezevic M, Levinson A, Harris R, Mishra RK, Doherty RD, Kalidindi SR. Deformation twinning in AZ31: influence on strain hardening. Acta Mater. 2010;58(19):6230–42.
Simmons G, Wang H. Single crystal elastic constants and calculated aggregate properties. Cambridge: The M.I.T. Press; 1971.
Partridge PG. Irregular twin growth and contraction in hexagonal close packed metals. Acta Metall. 1965;13(12):1329–35.
Wu L, Agnew SR, Brown DW, Stoica GM, Clausen B, Jain A, Fielden DE, Liaw PK. Internal stress relaxation and load redistribution during the twinning–detwinning-dominated cyclic deformation of a wrought magnesium alloy ZK60A. Acta Mater. 2008;56(14):3699–707.
Partridge P. The crystallography and deformation modes of hexagonal closed-packed metals. Metall Rev. 1967;12:169–94.
Wu L, Jain A, Brown DW, Stoica GM, Agnew SR, Clausen B, Fielden DE, Liaw PK. Twinning–detwinning behavior during the straincontrolled low-cycle fatigue testing of a wrought magnesium alloy ZK60A. Acta Mater. 2008;56(4):688–95.
Choi SH, Shin EJ, Seong BS. Simulation of deformation twins and deformation texture in an AZ31 Mg alloy under uniaxial compression. Acta Mater. 2007;55(12):4181–92.
Author information
Authors and Affiliations
Corresponding author
Additional information
Project (11462002) supported by the National Natural Science Foundation of China; Project (2016GXNSFAA380218) supported by Guangxi Natural Science Foundation, China; Project (2014ZDK002) supported by the Open Project of Guangxi Key Laboratory of Disaster Prevention and Structural Safety at Guangxi University, China; and Project (Z01) supported by the Science Foundation for Doctorate Research of Guangxi University of Science and Technology, China.
Rights and permissions
About this article
Cite this article
Chen, Y., Hu, G., Lan, Y. et al. Constitutive Modeling of Slip, Twinning and Detwinning for Mg Alloy and Inhomogeneous Evolution of Microstructure. Acta Mech. Solida Sin. 31, 493–511 (2018). https://doi.org/10.1007/s10338-018-0028-4
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10338-018-0028-4