Abstract
The adoption of a concept similar to the prestressing technique used in laminated wood decks of bridge structures might increase the initial stiffness or ultimate resistance of dowel-type timber joints by applying pretension to their bolts. This study investigated the effect of pretension in bolts on hysteretic responses and ultimate properties of moment-carrying timber joints with steel side plates. A pretension of 20 kN that yielded a prestress level of 1600 kPa or about 90% of the allowable long-term end-bearing strength of spruce species was applied to the bolts of prestressed joints. The superiority of the prestressed joint over the non-pre-stressed joint was proved by very high hysteretic damping, equivalent viscous damping ratio, and cyclic stiffness. At any given rotation level, hysteretic damping reduction and moment resistance decrement due to continuously reversed loads were found to be small because bolt pretensioning minimized the pinching effect. This study showed that the hysteresis loop of the prestressed joint can be obtained by adding the frictional hysteresis loop due to pretension force into the hysteresis loop of the non-pre-stressed joint. Despite a great increase of initial stiffness, only slight increments in ductility coefficient and ultimate moment resistance were found in the prestressed joint.
Article PDF
Similar content being viewed by others
References
Ritter MA, Wacker JP (1995) Field performance of stress-laminated timber bridge on low-volume roads. In: Proceedings of the 6th International Conference on Low-Volume Roads, Minneapolis, pp 347–356
Wipf TJ, Ritter MA, Wood DL (1999) Dynamic evaluation and testing of timber highway bridges. In: Proceedings of Pacific Timber Engineering Conference, Rotorua, pp 333–340
Quenneville JHP, Dalen KV (1991) The enhanced performance of split-ring connections through prestressing. Can J Civil Eng 18:830–838
Kainz JA, Ritter MA (1998) Effect of cold temperature on stress-laminated timber bridge-decks. In: Proceedings of the 5th WCTE, Montreaux, pp 42–49
Sarisley EF, Accorsi ML (1990) Prestress level in stress-laminated timber bridge. J Struct Eng 116:3003–3019
American Association of State Highway and Transportation Officials (1991) Guide specifications for the design of stress-laminated wood decks. American Association of State Highway and Transportation Officials, Washington DC
Prion H, Foschi R (1994) Cyclic behaviour of dowel type connection. In: Proceedings of the Pacific Timber Engineering Conference, Gold Coast, pp 21–27
Mesic E (2003) Analysis of timber frames with localized nonlinearities. Facta Univ Architect Civil Eng 2:307–320
Japanese Industrial Standards Association (1987) Japanese Industrial Standard JIS G 3101. Rolled steel for general structure (in Japanese). Japanese Industrial Standards Association, Tokyo
National Instruments (1996) LabVIEW 4. National Instruments, Austin, TX, USA
Architecture Institute of Japan (2006) Standard for structural design of timber structures. Architecture Institute of Japan, Tokyo, pp 13–14, 400
Karacabeyli E, Yasumura M, Foliente GC, Ceccotti A (2005) Back-ground information on ISO standard 16670 for cyclic testing of connections. In: Proceedings of the 38th CIB-W18, Karlshure, paper no. 38-15-1
Wakashima Y, Hirai T (1993) Hysteretic properties of nailed timber-plywood joints under cyclic loading I: static cyclic loading test (in Japanese). Mokuzai Gakkaishi 39:1259–1266
Hirai T (1991) Analysis of the lateral resistance of bolt joints and drift-pin joints in timber II: numerical analysis applying the theory of a beam on an elastic foundation (in Japanese). Mokuzai Gakkaishi 37:1017–1025
Chang WS, Komatsu K, Hsu MF, Chen WJ (2007) On mechanical behavior of timber shear wall in Taiwan. J Wood Sci 53:17–23
Dolan JD, Toothman A (2002) Monotonic and cyclic tests of shear wall with gypsum wallboard, fiberboard, and hardboard sheathing. Report No. WMEL-2002-03. Wood Materials and Engineering Laboratory, Washington State University, Pullman
Chopra AK (2001) Dynamics of structures: theory and applications to earthquake engineering. Prentice Hall, Upper Saddle River, pp 99–104
SPSS (1999) SigmaScan Pro 5.0.0: Image Analysis. SPSS, Chicago, IL, USA
Hirai T (1991) Effect of frictional resistance on lateral resistance of bolted timber-joints with steel side-webs (in Japanese). Mokuzai Gakkaishi 37:517–522
Author information
Authors and Affiliations
Corresponding author
About this article
Cite this article
Awaludin, A., Hirai, T., Hayashikawa, T. et al. Effects of pretension in bolts on hysteretic responses of moment-carrying timber joints. J Wood Sci 54, 114–120 (2008). https://doi.org/10.1007/s10086-007-0914-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10086-007-0914-8