Abstract
Conductive polymer three-dimensional microstructures were photofabricated utilizing the two-photon absorption of a sensitizer dye. The resulting three-dimensional structures were excised from the transparent polymer sheet using a micro-manipulator. The processing precisions for the vertical direction of the conductive polymer three-dimensional microstructure obtained in the transparent polymer sheet were evaluated in the present study. As a result, for the configurations of the obtained polypyrrole line deposition, the line height/line width ratios were around 5: 1; this ratio is higher than that of other UV resin works (h: w 2:4–3: 1) and the cross section distortion is not negligible for maintaining the higher reproducibility of the photofabrication.
Similar content being viewed by others
References
K. Teshima, K. Yamada, N. Kobayashi, and R. Hirohashi: J. Chem. Soc., Chem. Commun. (1996) 829.
K. Yamada, Y. Kimura, J. Sone, J. Chen, and S. Urabe: Chem. Lett. 35 (2006) 908.
K. Yamada, J. Sone, and J. Chen: Opt. Rev. 16 (2009) 208.
H.-B. Sun, T. Tanaka, and S. Kawata: App. Phys. Lett. 80 (2002) 3673.
S. Kanehira, J. Si, J. Qiu, K. Fujita, and K. Hirao: Nano Lett. 5 (2005) 1591.
R. Vestberg, R. Westlund, A. Eriksson, C. Lopes, M. Carsson, B. Eliasson, E. Glimsdal, M. Lindgren, and E. Malmstrm: Macromolecules 39 (2006) 2238.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Yamada, K., Kyoya, A., Sone, J. et al. Evaluations of vertical resolution of conductive polymer three-dimensional microstructures photofabricated in transparent polymer sheet. OPT REV 18, 162–165 (2011). https://doi.org/10.1007/s10043-011-0016-0
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10043-011-0016-0