Abstract
For an orthotropic material, the thermal conductivity in arbitrary directions follows from the conductivities in the principal material directions by rotation of the thermal conductivity tensor. Thus, in case of orthotropy, three analytical relations describe the thermal conductivity of wood between the principal anatomical directions depending on the rotation angle. Experiments were made to prove if these functions hold for wood. Thermal conductivity measurements were performed in the principal anatomical directions of European oak (Quercus sp.), European beech (Fagus sylvatica) and Norway spruce (Picea abies) and at angles to the grain in the longitudinal–radial plane. Test instrument was a single-specimen guarded hot plate apparatus. Experimental data for thermal conductivity at angles to the grain were compared with values predicted from the conductivities in the principal anatomical directions using the relations for rotation of the thermal conductivity tensor. Excellent agreement between the experimental data and the theoretical curve in the longitudinal–radial plane was obtained. It is concluded that thermal conductivity of wood at angles to the principal anatomical directions can be described by transformation equations derived by the respective rotation of the thermal conductivity tensor. This shows that wood exhibits orthotropic symmetry of the thermal conduction behaviour.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Bučar B, Straže A (2008) Determination of the thermal conductivity of wood by the hot plate method: the influence of morphological properties of fir wood (Abies alba Mill.) to the contact thermal resistance. Holzforschung 62:362–367
Donaldson L (2008) Microfibril angle: measurement, variation and relationships—a review. IAWA J 29(4):345–386
Eitelberger J, Hofstetter K (2011) Prediction of transport properties of wood below the fiber saturation point—a multiscale homogenization approach and its experimental validation part 1: thermal conductivity. Compos Sci Technol 71:134–144
Frandsen HL (2005) Modeling of moisture transport in wood: state of the art and analytic discussion. Wood science and timber engineering, paper no. 1, 2nd edn. Department of Building Technology and Structural Engineering, Aalborg University, Denmark
Griffiths E, Kaye G (1923) The measurement of thermal conductivity. Proc Roy Soc Lond Ser A 104(724):71–98
ISO 8302 (1991) Thermal insulation—determination of steady-state thermal resistance and related properties—guarded hot plate apparatus
Kollmann FFP, Côté WA (1968) Principles of wood science and technology. 1. Solid wood. Springer, Berlin
Kühlmann G (1962) Investigation of the thermal properties of wood and particleboards in dependency from moisture content and temperature in the hygroscopic range (In German). Holz Roh Werkst 20(7):259–270
Lichtenegger H, Reiterer A, Stanzl-Tschegg SE, Fratzl P (1999) Variation of cellulose microfibril angles in softwoods and hardwoods—a possible strategy of mechanical optimization. J Struct Biol 128:257–269
MacLean JD (1941) Thermal conductivity of wood. Heat Pip Air Cond 13:380–391
Maku T (1954) Studies on the heat conduction in wood. Bulletin of the wood research Institute, Kyoto University 13: 1–80
Narayanamurti D, Ranganathan V (1941) The thermal conductivity of Indian timbers. Proc Indian Acad Sci 13(4):300–315
Ratcliffe E (1964a) A review of thermal conductivity data—1. Wood 29(7):49–51
Ratcliffe E (1964b) A review of thermal conductivity data—2. Wood 29(8):46–49
Ratcliffe E (1964c) A review of thermal conductivity data—3. Wood 29(9):50–54
Rowley F (1933) The heat conductivity of wood at climatic temperature differences. Heat Pip Air Cond 5:313–323
Schneider A, Engelhardt F (1977) Vergleichende Untersuchungen über die Wärmeleitfähigkeit von Holzspan- und Rindenplatten (Comparative investigations on the thermal conductivity of wood particle boards and bark boards) (In German). Holz Roh- Werkst 35(7):273–278
Sonderegger W, Hering S, Niemz P (2011) Thermal behaviour of Norway spruce and European beech in and between the principal anatomical directions. Holzforschung 65:369–375
Torgovnikov G, Vinden P (2009) High-intensity microwave wood modification for increasing permeability. Forest Prod J 59(4):84–92
Vay O, Obersriebnig M, Müller U, Konnerth J, Gindl-Altmutter W (2013) Studying thermal conductivity of wood at cell wall level by scanning thermal microscopy (SThM). Holzforschung 67(2):155–159
Wagenführ R (1996) Holzatlas. 4. Auflage, Fachbuchverlag Leipzig
Wangaard F (1940) Transverse heat conductivity of wood. Heat Pip Air Cond 12:459–464
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Vay, O., De Borst, K., Hansmann, C. et al. Thermal conductivity of wood at angles to the principal anatomical directions. Wood Sci Technol 49, 577–589 (2015). https://doi.org/10.1007/s00226-015-0716-x
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00226-015-0716-x