Abstract
This paper presents a comparison of the performance of a non-isolated dual interleaved boost converter with coupled inductors and reset winding, while various practical realization of the coupled inductor with demagnetizing coil is being considered. The evaluation of the performance of individual alternatives is done for the steady-state operation. There are two alternatives that are being considered as perspective solutions (alternative 2, alternative 3), while their origin is represented by alternative 1. The main differences regarding magnetic circuit design are initially described. It was discovered that the solution with tight magnetic coupling (alternative 2) enables to reach twice the output power of solution with weak magnetic coupling (alternative 3), whereby the same volume of the magnetic core is used. Final experimental results have demonstrated that the investigated alternatives have different behavior when duty cycle operation range is considered. Both alternatives have been tested for their nominal power, whereby it was found that the designed prototypes achieved the peak efficiency above > 95% and alternative 2 showed much better output voltage stability. The operational range of the voltage gain was also investigated, and it was found that for the given turn’s ratio, the voltage gain is similar for both alternatives. The main difference was when duty cycle was considered, alternative 2 can reach required voltage gain at duty cycle which is half of the duty cycle of alternative 3. The presented modifications of original converter (alternative 1) might be a much proper solution for applications where tight constant DC bus voltage is required because of the improved operational characteristics.
Similar content being viewed by others
References
Shojaeian H, Heydari M, Hasanzadeh S (2017) Improved interleaved high step-up converter with high efficiency for renewable energy applications. In: 8th power electronics, drive systems and technologies conference (PEDSTC), Mashhad, Iran. https://doi.org/10.1109/pedstc.2017.7910339
Nouri T, Hosseini SH, Babaei E, Ebrahimi J (2016) A non-isolated three-phase high step-up DC/DC converter suitable for renewable energy systems. Electr Power Syst Res 140:209–224. https://doi.org/10.1016/j.epsr.2016.06.020
Lucena da Costa AE, Andersen RL (2015) High-gain boost–boost–flyback converter for renewable energy sources applications. In: IEEE 13th Brazilian power electronics conference and 1st southern power electronics conference (COBEP/SPEC), Fortaleza, Brazil. https://doi.org/10.1109/cobep.2015.7420088
Tseng K-Ch, Hang Ch-Ch, Cheng Ch-A (2016) Single-switch converter with high step-up gain and low diode voltage stress suitable for green power-source conversion. IEEE J Emerg Sel Top Power Electron 4(2):363–372. https://doi.org/10.1109/JESTPE.2015.2462735
Revathi BS, Mahalingam P (2017) Modular high-gain DC/DC converter for renewable energy microgrids. Electr Eng. https://doi.org/10.1007/s00202-017-0673-5
De Caro S, Testa A, Triolo D, Cacciato M, Consoli A (2005) Low input current ripple converters for fuel cell power units. In: IEEE European conference on power electronics and applications, Dresden, Germany. https://doi.org/10.1109/epe.2005.219647
Cacciato M, Consoli A, Attanasio R, Gennaro F (2006) Multi-stage converter for domestic generation systems based on fuel cells. In: Conference record of the 2006 IEEE industry applications conference forty-first IAS annual meeting, Tampa, FL, USA. https://doi.org/10.1109/ias.2006.256528
Martinez W, Cortes C, Munoz L, Yamamoto M (2016) Design of a 200 kW electric power train for a high performance electric vehicle. Ingenieria e Investigacion J 36(3):66–73. https://doi.org/10.15446/ing.investig.v36n3.53792
Pavlovsky M, Guidi G, Kawamura A (2014) Assessment of coupled and independent phase designs of interleaved multiphase buck/boost DC/DC converter for EV power train. IEEE Trans Power Electron 29(6):2693–2704. https://doi.org/10.1109/TPEL.2013.2273976
Azizi I, Radjeai H (2018) A new strategy for battery and supercapacitor energy management for an urban electric vehicle. Electr Eng 100(2):667–676. https://doi.org/10.1007/s00202-017-0535-1
Martinez W, Cortes C (2013) High power density interleaved DC/DC converter for a high performance electric vehicle. In: IEEE workshop on power electronics and power quality—PEPQA, Bogota, Colombia. https://doi.org/10.1109/pepqa.2013.6614971
Frivaldsky M, Hanko B, Prazenica M, Morgos J (2018) High gain boost interleaved converters with coupled inductors and with demagnetizing circuits. Energies 11(1):130. https://doi.org/10.3390/en11010130
Erickson RW, Maksimovic D (2004) Fundamentals or power electronics, 2nd edn. Kluwer Academic Publishers, New York, pp 22–27. ISBN 0-7923-7270-0
Çelebi M (2018) Efficiency optimization of a conventional boost DC/DC converter. Electr Eng 100(2):803–809. https://doi.org/10.1007/s00202-017-0552-0
Henn GAL, Silva RNAL, Praca PP, Barreto LHSC, Oliveira DS Jr (2010) Interleaved-boost converter with high voltage gain. IEEE Trans Power Electron 25(11):2753–2761. https://doi.org/10.1109/TPEL.2010.2049379
Liu H, Hu H, Wu H, Xing Y, Batarseh I (2016) Overview of high-step-up coupled-inductor boost converters. IEEE J Emerg Sel Top Power Electron 4(2):689–704. https://doi.org/10.1109/JESTPE.2016.2532930
Lai Ch-M, Pan Ch-T, Cheng M-Ch (2012) High-efficiency modular high step-up interleaved boost converter for DC-microgrid applications. IEEE Trans Ind Appl 48(1):161–171. https://doi.org/10.1109/TIA.2011.2175473
Tseng K-C, Huang Ch-Ch (2014) High step-up high-efficiency interleaved converter with voltage multiplier module for renewable energy system. IEEE Trans Ind Electron 61(3):1–9. https://doi.org/10.1109/TIE.2013.2261036
Tseng K-C, Chen Ch-T, Cheng Ch-A (2016) A high-efficiency high step-up interleaved converter with a voltage multiplier for electric vehicle power management applications. J Power Electron 16(2):414–424. https://doi.org/10.6113/JPE.2016.16.2.414
Kascak S (2016) Analysis of bidirectional converter with coupled inductor for electric drive application. In: International conference on mechatronics, control and automation engineering (MCAE2016), Bangkok, Thailand
Lee J-P, Cha H, Shin D, Lee K-J, Yoo D-W, Yoo J-Y (2013) Analysis and design of coupled inductors for two-phase interleaved DC/DC converters. J Power Electron 13(3):339–348. https://doi.org/10.6113/JPE.2013.13.3.339
Tomaszuk A, Krupa A (2011) High efficiency high step-up DC/DC converters—a review. Bull Pol Acad Sci Tech Sci 59(4):475–483. https://doi.org/10.2478/v10175-011-0059-1
Erdogan AD, Aydemir MT (2009) Use of input power information for load sharing in parallel connected boost converters. Electr Eng 99:229–250. https://doi.org/10.1007/s00202-009-0138-6
Haghmaram R, Sedaghati F, Ghafarpour R (2017) Power exchange among microgrids using modular-isolated bidirectional DC/DC converter. Electr Eng 99(1):441–454. https://doi.org/10.1007/s00202-016-0437-7
Hirakawa M, Watanabe Y, Nagano M, Andoh K, Nakatomi S, Hashino S, Shimizu T (2010) High power DC/DC converter using extreme close-coupled inductors aimed for electric vehicles. In: 2010 international power electronics conference—ECCE ASIA, Sapporo, Japan. https://doi.org/10.1109/ipec.2010.5542015
Hirakawa M, Nagano M, Watanabe Y, Andoh K, Nakatomi S, Hashino S (2009) High power density DC/DC converter using the close coupled inductors. In: 1st IEEE energy conversion congress and exposition (ECCE), San Jose, CA, USA. https://doi.org/10.1109/ecce.2009.5316389
Shen C-L, Chiu P-C, Lee Y-C (2016) novel interleaved converter with extra-high voltage gain to process low-voltage renewable-energy generation. Energies 9(11):871. https://doi.org/10.3390/en9110871
Martinez W, Imaoka J, Itoh Y, Yamamoto M, Umetani K (2015) Analysis of coupled-inductor configuration for an interleaved high step-up converter. In: 9th international conference on power electronics and ECCE Asia (ICPE-ECCE Asia), Seoul, South Korea. https://doi.org/10.1109/icpe.2015.7168088
Martinez W, Imaoka J, Yamamoto M, Umetani K (2015) High step-up interleaved converter for renewable energy and automotive applications. In: 4th international conference on renewable energy research and applications (ICRERA), Palermo, Italy. https://doi.org/10.1109/icrera.2015.7418524
Acknowledgments
The authors would like to thank for the support to the Slovak National Grant Agency APVV for Project APVV-0571-15 and APVV-0396-15—New generation of power supplies utilized GaN Technology and Vega 1/0119/18. The special thank is also given to the BH Motorsport company for specific material support and supplementary equipment support.
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
The paper is extended version of paper for special issue ELEKTRO 2018.
Rights and permissions
About this article
Cite this article
Prazenica, M., Frivaldsky, M., Morgos, J. et al. Comparison of perspective dual interleaved boost converters with demagnetizing circuit. Electr Eng 102, 13–25 (2020). https://doi.org/10.1007/s00202-019-00844-3
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00202-019-00844-3