Abstract
n-CuInS2 photoanode has been prepared by spray pyrolysis onto SnO2 deposited glass substrate at 350°C. The conductivity type of the photoanode was tested by hot-probe method and was ofn type. The conductivity of the photoanode was of the order of 2–4Θ−1cm−1 and was measured by using four-probe method. The effect of etching (HCl:HNO3 = 5:1 by volume) on photoanode properties has been studied. The best cell had the following parameters:V oc = 0·29V,I sc = 5·33 mA/cm2,ff = 0·571 and η = 1·275%.
Similar content being viewed by others
References
Aruchamy A, Aravamudan G and Subba Rao G V 1982Bull. Mater. Sci. 4 483
Gerischer H 1977Special topics in electrochemistry (Amsterdam, The Netherlands: Elsevier)
Kazmerski L L and Shieh C C 1997Thin Solid Films (to be published)
Kazmerski L L, Ayyagari M S and Sanborn G A 1975J. Appl. Phys. 46 4865
Kazmerski L L, Ayyagari M S, Sanborn G A, White F R and Merrill A J 1976Thin Solid Films 37 323
Kung H K, Jerrett H S, Sleight A W and Ferreti A 1977J. Appl. Phys. (USA) 48 2463
Masse G, Manthuruthil J C and Locker D R 1975Bull. Am. Phys. Soc. 20 696
Oshcherin B N 1976Phys. Status Solidi (a) 35 K 35
Robbins Met al 1978J. Electrochem. Soc. 831
Shoonmann J 1982Ber. Bunsenges Phys. Chem. (Germany) 86 660
Tembhurkar Y D and Hirde J P 1992Bull. Mater. Sci. 15 143
Tembhurkar Y D and Hirde J P 1994Bull. Mater. Sci. 17 465
Veh L S R and Hackerman N 1977J. Electrochem. Soc. (USA) 124 833
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Tembhurkar, Y.D. n-CuInS2/polysulfide photoelectrochemical solar cells prepared by spray pyrolysis. Bull Mater Sci 20, 1011–1014 (1997). https://doi.org/10.1007/BF02744889
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02744889