Skip to main content
Log in

Effect of heat treatment on tensile behaviour of Ti-6Al-5Zr-0.5Mo-0.25Si alloy

  • Published:
Bulletin of Materials Science Aims and scope Submit manuscript

Abstract

Tensile behaviour of the near a titanium alloy, Ti-6Al-5Zr-0.5Mo-0.25Si (LT26A), was investigated in (α + β) as well as β treated condition, over a wide range of temperature from RT to 823 K. It was observed that there were distinct serrations on the load-elongation curves of the a + β treated material at intermediate temperatures from 623 to 723 K. Tensile tests at 673 K over a wide range of strain rate from 0052 to 5.60 (× 10-2) s-1 showed negative strain rate sensitivity. Thus, occurrence of DSA was confirmed. It was established from the measured activation energy for DSA that it was essentially controlled by diffusion of the solid solution strengthener silicon in the matrix.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

Download references

Author information

Authors and Affiliations

Authors

Corresponding author

Correspondence to Vakil Singh.

Rights and permissions

Reprints and permissions

About this article

Cite this article

Nag, A.K., Praveen, K.V.U. & Singh, V. Effect of heat treatment on tensile behaviour of Ti-6Al-5Zr-0.5Mo-0.25Si alloy. Bull Mater Sci 29, 147–154 (2006). https://doi.org/10.1007/BF02704607

Download citation

  • Received:

  • Revised:

  • Issue Date:

  • DOI: https://doi.org/10.1007/BF02704607

Keywords

Navigation