Abstract
Measurements of melt surface velocities on a twelve ton Ajax induction furnace were compared with the predictions of a mathematical model for melt flow in induction furnaces. Agreement was found to be fairly good. The results of calculations of the effect of changing power supply frequency, coil and melt geometry, current and phasing are presented.
Similar content being viewed by others
References
E. D. Tarapore and J. W. Evans:Met. Trans. B, 1976, vol. 7B, pp. 343–51.
A. D. Gosmanet at Heat and Mass Transfer in Recirculating Flows, Academic Press, London, 1969.
D. B. Spalding:VDIForschungsh., 1972, vol. 38, no. 549, pp. 5–16.
K. Schoenbacher:Elektrotechn. Zeit, 1952, vol. 73, no. 23, pp. 736–38.
E. D. Tarapore: Ph.D. Dissertation, University of California, Berkeley, 1976.
Author information
Authors and Affiliations
Additional information
Formerly with Airco Vacuum Metals
Rights and permissions
About this article
Cite this article
Tarapore, E.D., Evans, J.W. & Langfeldt, J. Fluid velocities in induction melting furnaces: Part II. large scale measurements and predictions. Metall Trans B 8, 179–184 (1977). https://doi.org/10.1007/BF02656368
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF02656368