Abstract
Some important characteristics of gas turbine engines (in the first place the thrust and the efficiency) depend on the gas temperature and hence are determined by the service life of the blades. Heat-resistant nickel alloys are used for casting blades that can work at maximum temperatures of 1050–1100°C. However, more efficient engines need materials with a higher operating temperature and high-temperature strength. The work concerns the principles of alloying and structure formation of eutectic heat-resistant alloys on a nickel base with carbide and intermetallic strengthening. Their main mechanical properties at high temperatures are analyzed in comparison with the characteristics of high-temperature single-crystal nickel alloys, and the possibility of using them for casting turbine blades of high-temperature gas-turbine engines is considered.
Similar content being viewed by others
References
D. J. Frasier, J. R. Whetstone, K. Harris, et al., “Process and alloy optimization for SMSX-4 superalloy single crystal airfoils,” in:High Temperature Materials far Power Engineering 1990, Proc. of a Conf. Held in Liege, Belgium, 24–27 September (1990), Part II, Kluwer Academic Publishers, Dordrecht - Boston - London (1990).
T. Khan, “Further assessment and improvement of high strength γ/γ′ — NbC composites for advanced turbine blades,” in:Proc. of Conf on In-Situ Composites 111, Ginn Custom Publ., Lexington (1978).
C. Damerval, “Contributions a l'etude du comportement mecanique des composites COTAS γ/γ′ — NbC a moyenne et naute temperature,”Note technique ONERA, March (1986).
D. A. Woodford, “Creep and rupture of an advanced fiber strengthened eutectic composite superalloy,”Metallurgical Transactions,8a(4), 639–650 (1977).
G. W. Meetham, “Superalloys in gas turbine blades,”Metallurgist Materials Technologist,14(9), 387–392 (1982).
S. W. Yang, “Ni-base MC-carbide reinforced eutectic alloys for jet engine application,” in:Proc. NCKU/AAS Int. Symp. Engineering Sciences and Mechanics, 1525–1537 (1981).
B. E. Paton, G. B. Stroganov, S. T. Kishkin, et al.,High-Temperature Strength of Castable Nickel Alloys and Their Protection from Oxidation [in Russian], Naukova Dumka, Kiev (1987).
Superalloys II. High-Temperature Materials for Aerospace and Industrial Power, Wiley - Interscience Publication, New York -Chichester - Brisbane - Toronto - Singapore (1986).
Author information
Authors and Affiliations
Additional information
Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 4, pp. 24–29, April, 1995.
Rights and permissions
About this article
Cite this article
Kachanov, E.B., Petrushin, N.V. & Svetlov, I.L. Heat-resistant eutectic alloys with carbide-intermetallic strengthening. Met Sci Heat Treat 37, 154–159 (1995). https://doi.org/10.1007/BF01189472
Issue Date:
DOI: https://doi.org/10.1007/BF01189472