Abstract
Four methods of determining shear moduli on flat specimens are discussed. For each method the effect of the geometric parameters and the load range on the values of the shear moduli determined is estimated. Experimental values of the shear moduli obtained by each of these methods for the same materials are compared with the calculated values.
Similar content being viewed by others
Literature cited
Static Testing Methods for Reinforced Plastics. A Handbook [in Russian], Riga (1972).
A. M. Skudra, F. Ya. Bulavs, and K. A. Rotsens, Creep and Static Fatigue of Reinforced Plastics [in Russian], Riga (1971).
S. G. Lekhnitskii, Anisotropic Plates [in Russian], Moscow-Leningrad (1957).
V. P. Nikolaev and Yu. N. Novichkov, "Experimental determination of the shear moduli of glass-reinforced plastics," in: Strength Calculations [in Russian], No. 13, Moscow (1968), pp. 355–368.
Yu. M. Tarnopol'skii, A. V. Roze, I. G. Zhigun, and G. M. Gunyaev, "Structural characteristics of materials reinforced with high-modulus fibers," Mekh. Polim., No. 4, 676–685 (1971).
Additional information
Institute of Polymer Mechanics, Academy of Sciences of the Latvian SSR, Riga. Translated from Mekhanika Polimerov, No. 1, pp. 133–140, January–February, 1976.
Rights and permissions
About this article
Cite this article
Zhigun, I.G., Yakushin, V.A., Tanevskii, V.V. et al. Analysis of certain methods of determining shear moduli 1. Testing composites uniform over the thickness. Polymer Mechanics 12, 112–119 (1976). https://doi.org/10.1007/BF00857210
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF00857210