Abstract
Presented in this abstract are the considerations and results of an investigation of forced convective heat loss from the surface of flat-plate model collectors flush mounted on the roof of a model residential house. Forced convection with air as the external fluid was treated.
The study was motivated by the need to better understand heat transfer from the top surface of flat-plate solar energy collectors. The experimental work dealt with heat transfer from the top of rectangular parallelpipeds flush mounted on roof of a model residential house. The smallest collector was 7.62×10−2 m long by 7.62×10−2 m wide by 3.3×10−2 m deep, and the largest collector was 15.875×10−2 m long by 15.875×10−2 m wide by 3.3×10−2 m deep. These small scale units are expected to simulate heat loss pattern from a flat-plate solar collector placed over the roof of a residential dwelling. Experiments were performed to determine the average heat transfer coefficients for forced convective air flow over the surface of the model collector which was inclined and yawed relative to the incoming air flow. The wind speeds varied approximately from 2.5 m/sec to 15 m/sec, the flow was laminar for all wind speeds.
Zusammenfassung
Es werden Vorüberlegungen und Ergebnisse bezüglich einer Untersuchung mitgeteilt, deren Ziel es war, die Wärmeverluste infolge Zwangskonvektion von Flachplatten-Kollektoren auf den Dächern von Wohnhäusern im Kleinmodell zu bestimmen. Angeregt wurde die Studie durch den Bedarf an genaueren Berechnungsunterlagen für den Wärmeübergang an Flachplatten-Solarkollektoren. Die für das Experiment verwendeten zwei Kollektoren waren quadratisch, mit den Seitenlägen 7,62 bzw. 15,9 cm, bei jeweils 3,3 cm Tiefe. Die Versuche lieferten unter Zwangskonvektion mittlere Wärmeübergangskoeffizienten an den Oberflächen der Modellkollektoren, welche zur ankommenden Luftströmung sowohl geneigt als auch gedreht orientiert waren. Bei laminarer Strömung lagen die Anströmgeschwindigkeiten zwischen 2,5 and 15 m/s.
Similar content being viewed by others
References
Duffie, J. A.; Beckmann, W. A.: Solar energy thermal processes. New York: John Wiley and Sons, Inc. 1974
Saying, A. H.: Solar energy engineering. New York: Academic Press 1977
Kreith, F.; Kreider, J. E.: Principles of solar engineering. New York: McGraw Hill 1978
Results and analysis of a round robin test program for liquid heating flat plate solar collector, NBS, Washington D.C.; TN, 1975; August 1978
Meinel, A. B.; Meinel, M. P.: Applied solar energy. New York: Prentice Hall 1976
McAdams, W. H.: Heat transmission. New York: McGraw Hill 1954
Sparrow, E. M.; Tien, K. K.: Forced convection heat transfer at an inclined and yawed square plate-application to solar collectors. ASME J. of Heat Transfer 99 (1977) 507–512
Rowley, F. B.; Eckley, W. A.: Surface coefficients as affected by direction of wind. Heating, Piping and Air-conditioning Journal, October (1931) 870–874
Sogin, H. H.: A summary of experiments of local heat transfer from the rear of bluff obstacles to a low speed air-stream. ASME J. of Heat Transfer 86C (1964) 200–202
Parmelee, G. V.; Huebscher, R. G.: Forced convection heat transfer from flat surfaces. Transactions American Society of Heating and Ventilating Engineers 53 (1947) 245–284
Kind, R. J.; Gladstone, P. H.; Mozier, A. D.: Convective heat losses flat plate solar collectors in turbulent winds. ASME J. Solar Energy Engineering 105 (1983) 80–85
Kind, R. J.; Kitaljevich, D.: Wind induced heat losses from solar collector arrays on flat-roofed buildings. ASME J. of Solar Energy Engineering 107 (1985) 335–342
Characteristics of wind speed in the lower layers of the atmosphere near the ground: Strong Winds, Engineering Sciences Data Unit, ESDU Data Item No: 72026, London, 1972
Arpaci, V. S.; Larsen, P. S.: Convection heat transfer. Prentice Hall 1984
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Onur, N. Forced convection heat transfer from a flat-plate model collector on roof of a model house. Warme - und Stoffubertragung 28, 141–145 (1993). https://doi.org/10.1007/BF01541111
Received:
Issue Date:
DOI: https://doi.org/10.1007/BF01541111