Abstract
The effect of working fluid is investigated in the high-speed drawing of complex external surfaces. Criteria and recommendations are outlined for the selection of working fluids in the high-speed drawing of structural-steel workpieces.
Similar content being viewed by others
REFERENCES
Vinogradov, V.M. and Cherepachin, A.A., Hochleistungsstreckung von Formflächen, Saarbrücken: Lambert Academic, 2012.
Vinogradov, V.M. and Cherepakhin, A.A., Durability of circular broaches for cylindrical tooth gears machining, Izv. Mosk. Gos. Tekh. Univ. “MAMI”, 2010, no. 1 (9), pp. 106–106.
Rebinder, O.A., Poverkhnostnye yavleniya v dispersnykh sistemakh. Fiziko-khimicheskaya mekhanika. Izbrannye trudy (Surface Phenomena in Dispersed Systems. Physical-Chemical Mechanics. Selected Research Works), Moscow: Nauka, 1979.
Kragelskii, I.V., Friction and Wear, Elmsford: Pergamon, 1982.
Vinogradov, V.M. and Cherepakhin, A.A., Selection of GCL for high-speed broaching, Trenie Smazka Mash. Mekh., 2010, no. 8, pp. 39–43.
Author information
Authors and Affiliations
Corresponding authors
Ethics declarations
The authors declare that they has no conflict of interest.
Additional information
Translated by B. Gilbert
About this article
Cite this article
Cherepakhin, A.A., Kuznetsov, V.A. & Lyalyakin, V.P. Machining Fluids for High-Speed Drawing. Russ. Engin. Res. 42, 473–476 (2022). https://doi.org/10.3103/S1068798X22050094
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X22050094