Abstract—The plastic deformation of large disks and hard-to-deform disks on low-power equipment is considered. In comparison with upsetting and flattening by forging, sectional bulk stamping is promising. It permits successive plastic deformation of individual sections of the blank.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
REFERENCES
Semenov, E.I., Kovka i ob”emnaya shtampovka (Forging and Bulk Stamping), Moscow: Vysshaya Shkola, 1972.
Storozhev, M.V. and Popov, E.A., Teoriya obrabotki metallov davleniem (Theory of Metal Processing by Pressure), Moscow: Mashinostroenie, 1977.
Dmitriev, A.M. and Vorontsov, A.L., Physical patterns and determination of the power parameters of extrusion of hollow cylindrical products, Kuznechno-Shtampovochnoe Proizvod.–Obrab. Mater. Davleniem, 2004, no. 6, pp. 3–8.
Vorontsov, A.L., New solution of complex variational problems by the description of the shape change of the blank during firmware, Kuznechno-Shtampovochnoe Proizvod.–Obrab. Mater. Davleniem, 2009, no. 10, pp. 3–8.
Vorontsov, A.L., Analysis of kinematic, stressed, and deformed states of the bilet during punching of the cylindrical punching into half space, Vestn. Mashinostr., 1998, no. 7, pp. 44–47.
Vorontsov, A.L., Teoriya i raschety protsessov obrabotki metallov davleniem: Uchebnoe posobie dlya vuzov (Theory and Calculations of Processing of Metals by Pressure), Moscow: Mosk. Gos. Tekh. Univ. im. N.E. Baumana, 2014, vol. 2.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Vorontsov, A.L. Production of Large Disks from Cylindrical Blanks by Plastic Deformation. 1. Formulation of the Problem. Russ. Engin. Res. 39, 477–479 (2019). https://doi.org/10.3103/S1068798X19060200
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X19060200