Abstract—The final stage of central-punch introduction during the plastic deformation of large disks or hard-to-deform disks is mathematically described. The maximum force of punch introduction at the end of deformation is determined
Similar content being viewed by others
REFERENCES
Vorontsov, A.L., Production of large disks from cylindrical blanks by plastic deformation. 1. Formulation of the problem, Russ. Eng. Res., 2019, vol. 39, no. 6, pp. 477–479.
Vorontsov, A.L., Production of large disks from cylindrical blanks by plastic deformation. 2. Introduction of the central punch at the stage of concavity formation, Vestn. Mashinostr., 2018, no. 4, pp. 54–57.
Vorontsov, A.L., Analysis of the kinematic, stress, and strain state of a blank when a cylindrical punch is inserted into a halfspace, Vestn. Mashinostr., 1998, no. 7, pp. 44–47.
Vorontsov, A.L., New solution of complex variational problems by the description of the shape change of the blank during firmware, Kuznechno-Shtampovochnoe Proizvod.–Obrab. Mater. Davleniem, 2009, no. 10, pp. 3–8.
Vorontsov, A.L., Teoriya i raschety protsessov obrabotki metallov davleniem. Uchebnoe posobie dlya vuzov (Theory and Calculations of Metal Forming by Pressure: Manual for Higher Education Institutions), Moscow: Mosk. Gos. Tekh. Univ. im. N.E. Baumana, 2014, vol. 1.
Vorontsov, A.L., Teoriya i raschety protsessov obrabotki metallov davleniem. Uchebnoe posobie dlya vuzov (Theory and Calculations of Metal Forming by Pressure: Manual for Higher Education Institutions), Moscow: Mosk. Gos. Tekh. Univ. im. N.E. Baumana, 2014, vol. 2.
Vorontsov, A.L., The mechanics of a deformable solid and its technological applications. 7. Axisymmetric problem of the theory of plasticity. Stress and kinematic states during the upsetting of a cylindrical billet with friction on the ends. Work balance method, Part 1, Proizvod. Prokata, 2010, no. 9, pp. 2–13.
Vorontsov, A.L., The mechanics of a deformable solid and its technological applications. 7. Axisymmetric problem of the theory of plasticity. Stress and kinematic states during the upsetting of a cylindrical billet with friction on the ends. Work balance method, Part 2, Proizvod. Prokata, 2010, no. 10, pp. 2–14.
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Vorontsov, A.L. Production of Large Disks from Cylindrical Blanks by Plastic Deformation. 3. Final Stage of Central-Punch Introduction. Russ. Engin. Res. 39, 656–658 (2019). https://doi.org/10.3103/S1068798X19080215
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X19080215