Abstract
The structure of a helical drill with a coolant channel leading to the tool groove and the rear surface is considered. SolidWorks/FlowSimulation design software is used for finite-element analysis.
Similar content being viewed by others
REFERENCES
Mitin, E.V. and Sul’din, S.P., Hob strength in gear cutting, Stanki Instrum., 2018, no. 2, pp. 24–27.
Kuzin, E.K., Sul’din, S.P., Mitin, E.V., and Mitina, A.E., Calculation of the strength of a passenger trailer of general purpose loaded with a stack load during emergency braking, Avtom. Sovrem. Tekhnol., 2017, vol. 71, no. 12, pp. 537–539.
Mitin, E.V., Sul’din, S.P., and Martyshkin, A.V., The choice of the rational shape of replaceable polyhedral plates of face mills based on statistical analysis of the stress-strain state, SAPR Grafika, 2017, no. 1 (243), pp. 55–57.
Kuzin, E.K., Sul’din, S.P., Mitin, E.V., and Mitina, A.E., Use of the SOLIDWORKS/SIMULATION software for strength calculation of a passenger trailer for general use during loading a trailer with a loose cargo, SAPR Grafika, 2017, no. 3 (245), pp. 6769.
Kuzin, E.K., Sul’din, S.P., Mitin, E.V., and Mitina, A.E., Use of the SOLIDWORKS/SIMULATION software for strength calculation of a passenger trailer for general use during loading a trailer with a loose cargo, SAPR Grafika, 2017, no. 4 (246), p. 2527.
Mitin, E.V. and Sul’din, S.P., Hob strength in gear cutting, Russ. Eng. Res., 2018, vol. 38, no. 8, pp. 635–637.
Author information
Authors and Affiliations
Corresponding authors
Additional information
Translated by Bernard Gilbert
About this article
Cite this article
Mitin, E.V., Sul’din, S.P., Grigor’ev, A.V. et al. Design of Helical Drills with Channels for Coolant Supply. Russ. Engin. Res. 39, 520–522 (2019). https://doi.org/10.3103/S1068798X19060145
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X19060145