Abstract
Facets must be machined at the end of gear teeth. The shaping of facets by single-turn worm mills is considered in detail. Deficiencies are found in familiar design methods for such mills. Formulas are proposed for the calculation of single-turn worm mills used in machining conical round-tooth gears.
Similar content being viewed by others
References
Belugin, Yu.F. and Kondrashov, A.G., RF Patent 50140, Byull. Izobret., 2005, no. 36.
Belugin, Yu.F., Kondrashov, A.G., and Chemborisov, N.A. RF Patent 70474, Byull. Izobret., 2008, no. 3
Chemborisov, N.A. and Kondrashov, A.G., Tool for chamfering at the ends of the teeth of helical gears of cylindrical wheels, Materilay mezhvuzovskoi nauchnoprakticheskoi konferentsii “Vuzovskaya nauka-Rossii” (Proc. Interinstitutional Sci.-Pract. Conf. “The Place of High Institutional Science in Russia”), Naberezhnye Chelny: Kamsk. Politekh. Inst., 2005, part 1, pp. 183–187.
Chemborisov, N.A. and Kondrashov, A.G., Design of worm single-turn gearing mills, Spravochnik. Inzh. Zh., 2005, no. 8, pp. 22–27.
Chemborisov, N.A. and Kondrashov, A.G., Worm single-turn milling cutter for remove of the ends of cylindrical straight-toothed wheels, Metalloobrabotka, 2006, no. 1, pp. 12–15.
Chemborisov, N.A. and Kondrashov, A.G., End machining of teeth by a single-turn worm mill, Russ. Eng. Res., 2008, vol. 28, no. 8, pp. 809–811.
Golovko, A.N. and Golovko, I.V., Errors in the geartooth profile in shaving, Russ. Eng. Res., 2013, vol. 33, no. 5, pp. 309–311.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © A.G. Kondrashov, D.T. Safarov, A.I. Faskhutdinov, G.K. Davletshina, 2017, published in STIN, 2017, No. 4, pp. 12–13.
About this article
Cite this article
Kondrashov, A.G., Safarov, D.T., Faskhutdinov, A.I. et al. Single-turn worm mills for conical round-tooth gears. Russ. Engin. Res. 37, 812–813 (2017). https://doi.org/10.3103/S1068798X17090143
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X17090143