Abstract
The abrasive finishing of flat parts is investigated, to establish the influence of the technological parameters on the machining forces. A mathematical model is proposed for use in the regulation of plane finishing so as to ensure high quality of the machined surface.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
Khanov, A.M., Ivanov, V.A., Muratov, K.R., and Gashev, E.A., Control of the working trajectory in plane finishing, Izv. Samarsk. Nauch. Tsentra RAN, 2013, vol. 13, no. 1(3), pp. 667–669.
Muratov, K.R., Pepelyshev, A.V., and Gashev, E.A., More efficient finishing by increasing the force on the lap, Izv. Samarsk. Nauch. Tsentra RAN, 2011, vol. 13, no. 4(4), pp. 980–983.
Abrazivnaya i almaznaya obrabotka materialov (Abrasive and Diamond Machining), Reznikov, A.N., Ed., Moscow: Mashinostroenie, 1977.
Reznikov, A.N., Teplofizika protsessov mekhanicheskoi obrabotki materialov (Thermal Physics of Machining), Moscow: Mashinostroenie, 1981.
Losev, V.A., Lur’e, A.I., Serebrennik, Yu.B., et al., Formation of surface roughness in plane finishing by free and bound abrasive, Sverkhtverdye materialy: Nauch.Tekhn. Proizv. Zh., 1983, no. 1, pp. 45–49.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © L.D. Sirotenko, A.M. Khanov, K.R. Muratov, 2015, published in STIN, 2015, No. 4, pp. 22–23.
About this article
Cite this article
Sirotenko, L.D., Khanov, A.M. & Muratov, K.R. Abrasive finishing of flat parts. Russ. Engin. Res. 35, 783–784 (2015). https://doi.org/10.3103/S1068798X15100196
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X15100196