Abstract
In honing, burring is formed at the edges of radial holes in the wall of the hole being machined. Means of preventing such burring are considered.
Similar content being viewed by others
References
Chepovetskii, I.Kh., Mekhanika kontaktnogo vzaimo-deistviya pri almaznoi obrabotke (Contact Mechanics in Diamond Machining), Kiev: Naukova, Dumka, 1978.
Ogorodov, V.A., Simulation of honing, Russ. Eng. Res., 2011, vol. 31, no. 3, pp. 292–295.
Ogorodov, V.A., Control of diamond honing, Vestn. KhGATU, 2008, vol. 10, no. 1(26), pp. 122–126.
Ogorodov, V.A., Prevention of burring in honing, Uprav-lenie kachestvo finishnykh metodov obrabotki (Quality Control of Finishing Methods), Perm: Izd. PGTU, 1996, pp. 95–98.
Author information
Authors and Affiliations
Corresponding author
About this article
Cite this article
Ogorodov, V.A. Prevention of burring in diamond honing. Russ. Engin. Res. 35, 221–226 (2015). https://doi.org/10.3103/S1068798X15030132
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X15030132